- 您現在的位置：買賣IC網 > PDF目錄67758 > LTC1735IS-1#TR (LINEAR TECHNOLOGY CORP) 3 A SWITCHING CONTROLLER, 550 kHz SWITCHING FREQ-MAX, PDSO16 PDF資料下載
參數資料
| 型號： | LTC1735IS-1#TR |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 3 A SWITCHING CONTROLLER, 550 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | 0.150 INCH, PLASTIC, SO-16 |
| 文件頁數： | 28/28頁 |
| 文件大?。?/td> | 343K |
| 代理商： | LTC1735IS-1#TR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁當前第28頁
9
LTC1735-1
OPERATIO
U
(Refer to Functional Diagram)
The main control loop is shut down by pulling Pin 2 (RUN/
SS) low. Releasing RUN/SS allows an internal 1.2
A
current source to charge soft-start capacitor CSS. When
CSS reaches 1.5V, the main control loop is enabled with the
ITH voltage clamped at approximately 30% of its maximum
value. As CSS continues to charge, ITH is gradually re-
leased allowing normal operation to resume. If VOUT has
not reached 70% of its final value when CSS has charged
to 4.1V, latchoff can be invoked as described in the
Applications Information section.
The internal oscillator can be synchronized to an external
clock applied though a series resistor to the PGOOD pin
and can lock to a frequency between 90% and 130% of its
nominal rate set by capacitor COSC.
An overvoltage comparator OV guards against transient
overshoots (> 7.5%) as well as other more serious
conditions that may overvoltage the output. In this case,
the top MOSFET is turned off and the bottom MOSFET is
turned on until the overvoltage condition is cleared.
Foldback current limiting for an output shorted to ground
is provided by amplifier A. As VOSENSE drops below 0.6V,
the buffered ITHinputtothecurrentcomparatorisgradually
pulled down to a 0.86V clamp. This reduces peak inductor
current to about 1/4 of its maximum value.
Low Current Operation
The LTC1735-1 has three low current modes controlled
by the PGOOD pin. Burst Mode operation is selected when
the PGOOD pin is above 0.8V (typically tied through a
resistor to INTVCC). During Burst Mode operation, if the
error amplifier drives the ITH voltage below 0.86V, the
buffered ITH input to the current comparator will be
clamped at 0.86V. The inductor current peak is then held
at approximately 20mV/RSENSE (about 1/4 of maximum
output current). If ITH then drops below 0.5V, the Burst
Mode comparator B will turn off both MOSFETs to maxi-
mize efficiency. The load current will be supplied solely by
the output capacitor until ITH rises above the 60mV
hysteresis of the comparator and switching is resumed.
Burst Mode operation is disabled by comparator F when
the PGOOD pin is brought below 0.8V. This forces
continuous operation and assists in controlling voltage
regulation. If the output voltage is not within 7.5% of its
nominal value the PGOOD open-drain output will be
pulled low and Burst Mode operation will be disabled.
Foldback Current, Short-Circuit Detection
and Short-Circuit Latchoff
The RUN/SS capacitor, CSS, is used initially to limit the
inrush current of the switching regulator. After the con-
troller has been started and been given adequate time to
charge up the output capacitors and provide full load
current, CSS is used as a short-circuit time-out circuit. If
the output voltage falls to less than 70% of its nominal
output voltage, CSS begins discharging on the assumption
that the output is in an overcurrent and/or short-circuit
condition. If the condition lasts for a long enough period
as determined by the size of the CSS, the controller will be
shut down until the RUN/SS pin voltage is recycled. This
built-in latchoff can be overridden by providing a current
>5
A at a compliance of 5V to the RUN/SS pin. This
current shortens the soft-start period but also prevents net
discharge of CSS during an overcurrent and/or short-
circuit condition. Foldback current limiting is activated
when the output voltage falls below 70% of its nominal
level whether or not the short-circuit latchoff circuit is
enabled.
INTVCC/EXTVCC Power
Power for the top and bottom MOSFET drivers and most
of the internal circuitry of the LTC1735-1 is derived from
the INTVCC pin. When the EXTVCC pin is left open, an
internal 5.2V low dropout regulator supplies the INTVCC
power from VIN. If EXTVCC is raised above 4.7V, the
internal regulator is turned off and an internal switch
connects EXTVCC to INTVCC. This allows a high efficiency
source, such as the primary or a secondary output of the
converter itself, to provide the INTVCC power. Voltages up
to 7V can be applied to EXTVCC for additional gate drive
capability.
To provide clean start-up and to protect the MOSFETs,
undervoltage lockout is used to keep both MOSFETs off
until the input voltage is above 3.5V.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1735IS-1#TRPBF | 3 A SWITCHING CONTROLLER, 550 kHz SWITCHING FREQ-MAX, PDSO16 |
| LTC2951IDDB-1#TRMPBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| LTC3105EDD#PBF | SWITCHING REGULATOR, PDSO10 |
| LTC3105EMS#PBF | SWITCHING REGULATOR, PDSO12 |
| LTC3105EMS#TRPBF | SWITCHING REGULATOR, PDSO12 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1736CG | 功能描述:IC SW REG STEP-DOWN SYNC 24-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
| LTC1736CG#PBF | 功能描述:IC SW REG STEP-DONW SYNC 24-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
| LTC1736CG#TR | 功能描述:IC REG SW SYNC STEPDWN HE 24SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
| LTC1736CG#TRPBF | 功能描述:IC SW REG STEP-DONW SYNC 24-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
| LTC1736IG | 功能描述:IC REG SW SYNC STEPDWN HE 24SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。