- 您現在的位置：買賣IC網 > PDF目錄10790 > LTC1591-1IG#TRPBF (Linear Technology)IC D/A CONV 14BIT PAR 28-SSOP PDF資料下載
參數資料
| 型號： | LTC1591-1IG#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 2/20頁 |
| 文件大小： | 0K |
| 描述： | IC D/A CONV 14BIT PAR 28-SSOP |
| 標準包裝： | 2,000 |
| 設置時間： | 2µs |
| 位數： | 14 |
| 數據接口： | 并聯 |
| 轉換器數目： | 1 |
| 電壓電源： | 單電源 |
| 功率耗散（最大）： | 55µW |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-SSOP（0.209"，5.30mm 寬） |
| 供應商設備封裝： | 28-SSOP |
| 包裝： | 帶卷 (TR) |
| 輸出數目和類型： | 1 電流，單極；1 電流，雙極 |
| 采樣率（每秒）： | * |
10
LTC1591/LTC1597
15917fa
PIN FUNCTIONS
UU
U
LTC1591
REF (Pin 1): Reference Input and 4-Quadrant Resistor R2.
Typically
±10V, accepts up to ±25V. In 2-Quadrant mode
this is the reference input. In 4-quadrant mode, this pin is
driven by external inverting reference amplifier.
RCOM (Pin 2): Center Tap Point of the Two 4-Quadrant
Resistors R1 and R2. Normally tied to the inverting input
of an external amplifier in 4-quadrant operation, otherwise
shorted to the REF pin. See Figures 1a and 2a.
R1 (Pin 3): 4-Quadrant Resistor R1. In 2-quadrant opera-
tion short to the REF pin. In 4-quadrant mode tie to ROFS
(Pin 4).
ROFS (Pin 4): Bipolar Offset Resistor. Typically swings
±10V, accepts up to ±25V. In 2-quadrant operation tie to
RFB. In 4-quadrant operation tie to R1.
RFB (Pin 5): Feedback Resistor. Normally tied to the output
of the current to voltage converter op amp. Swings to
±VREF. VREF is typically ±10V.
IOUT1 (Pin 6): DAC Current Output. Tie to the inverting
input of the current to voltage converter op amp.
AGND (Pin 7): Analog Ground. Tie to ground.
LD (Pin 8): DAC Digital Input Load Control Input. When LD
is taken to a logic high, data is loaded from the input
register into the DAC register, updating the DAC output.
WR (Pin 9):DAC Digital Write Control Input. When WR is
taken to a logic low, data is loaded from the digital input
pins into the 14-bit wide input register.
DB13 to D2 (Pins 10 to 21): Digital Input Data Bits.
DGND (Pin 22): Digital Ground. Tie to ground.
VCC (Pin 23): The Positive Supply Input. 4.5V ≤ VCC ≥ 5.5V.
Requires a bypass capacitor to ground.
DB1, DB0 (Pins 24, 25): Digital Input Data Bits.
NC (Pins 26, 27): No Connect.
CLR (Pin 28):Digital Clear Control Function for the DAC.
When CLR is taken to a logic low, it sets the DAC output
and all internal registers to zero code for the LTC1591 and
midscale code for the LTC1591-1.
LTC1597
REF (Pin 1): Reference Input and 4-Quadrant Resistor R2.
Typically
±10V, accepts up to ±25V. In 2-Quadrant mode
this is the reference input. In 4-quadrant mode, this pin is
driven by external inverting reference amplifier.
RCOM (Pin 2): Center Tap Point of the Two 4-Quadrant
Resistors R1 and R2. Normally tied to the inverting input
of an external amplifier in 4-quadrant operation, otherwise
shorted to the REF pin. See Figures 1b and 2b.
R1 (Pin 3): 4-Quadrant Resistor R1. In 2-quadrant opera-
tion short to the REF pin. In 4-quadrant mode tie to ROFS
(Pin 4).
ROFS (Pin 4): Bipolar Offset Resistor. Typically swings
±10V, accepts up to ±25V. In 2-quadrant operation tie to
RFB. In 4-quadrant operation tie to R1.
RFB (Pin 5): Feedback Resistor. Normally tied to the output
of the current to voltage converter op amp. Swings to
±VREF. VREF is typically ±10V.
IOUT1 (Pin 6): DAC Current Output. Tie to the inverting
input of the current to voltage converter op amp.
AGND (Pin 7): Analog Ground. Tie to ground.
LD (Pin 8): DAC Digital Input Load Control Input. When LD
is taken to a logic high, data is loaded from the input
register into the DAC register, updating the DAC output.
WR (Pin 9):DAC Digital Write Control Input. When WR is
taken to a logic low, data is loaded from the digital input
pins into the 16-bit wide input register.
DB15 to D4 (Pins 10 to 21): Digital Input Data Bits.
DGND (Pin 22): Digital Ground. Tie to ground.
VCC (Pin 23): The Positive Supply Input. 4.5V ≤ VCC ≥ 5.5V.
Requires a bypass capacitor to ground.
DB3 to DB0 (Pins 24 to 27): Digital Input Data Bits.
CLR (Pin 28):Digital Clear Control Function for the DAC.
When CLR is taken to a logic low, it sets the DAC output
and all internal registers to zero code for the LTC1597 and
midscale code for the LTC1597-1.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2611CDD#TRPBF | IC DAC 14BIT SGL R-R VOUT 10DFN |
| B37987F5104K054 | CAP CER 0.1UF 50V 10% RADIAL |
| B37987F5683K054 | CAP CER 0.068UF 50V 10% RADIAL |
| VE-J0W-MY-S | CONVERTER MOD DC/DC 5.5V 50W |
| VE-J0T-MY-S | CONVERTER MOD DC/DC 6.5V 50W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1591-1IN | 功能描述:IC D/A CONV 14BIT PAR 28-DIP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:47 系列:- 設置時間:2µs 位數:14 數據接口:并聯 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:55µW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:28-SSOP 包裝:管件 輸出數目和類型:1 電流，單極；1 電流，雙極 采樣率（每秒）:* |
| LTC1591-1IN#PBF | 功能描述:IC D/A CONV 14BIT PAR 28-DIP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:2,400 系列:- 設置時間:- 位數:18 數據接口:串行 轉換器數目:3 電壓電源:模擬和數字 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:36-TFBGA 供應商設備封裝:36-TFBGA 包裝:帶卷 (TR) 輸出數目和類型:* 采樣率（每秒）:* |
| LTC1591CG | 功能描述:IC D/A CONV 14BIT PAR 28-SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:47 系列:- 設置時間:2µs 位數:14 數據接口:并聯 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:55µW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:28-SSOP 包裝:管件 輸出數目和類型:1 電流，單極；1 電流，雙極 采樣率（每秒）:* |
| LTC1591CG#PBF | 功能描述:IC D/A CONV 14BIT PAR 28-SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Data Converter Fundamentals DAC Architectures 標準包裝:750 系列:- 設置時間:7µs 位數:16 數據接口:并聯 轉換器數目:1 電壓電源:雙 ± 功率耗散（最大）:100mW 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-LCC（J 形引線） 供應商設備封裝:28-PLCC（11.51x11.51） 包裝:帶卷 (TR) 輸出數目和類型:1 電壓，單極；1 電壓，雙極 采樣率（每秒）:143k |
| LTC1591CG#TR | 功能描述:IC DAC 14BIT PARALLEL IN 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:47 系列:- 設置時間:2µs 位數:14 數據接口:并聯 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:55µW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:28-SSOP 包裝:管件 輸出數目和類型:1 電流，單極；1 電流，雙極 采樣率（每秒）:* |
發布緊急采購，3分鐘左右您將得到回復。