參數資料
型號: LTC1566-1CS8
廠商: Linear Technology
文件頁數: 6/8頁
文件大?。?/td> 0K
描述: IC FILTER LP 7ORDER 2.3MHZ 8SOIC
標準包裝: 100
濾波器類型: 低通
頻率 - 截止或中心: 150kHz
濾波器數: 1
濾波器階數: 7th
電源電壓: ±5V,5V
安裝類型: 表面貼裝
封裝/外殼: 8-SOIC(0.154",3.90mm 寬)
供應商設備封裝: 8-SOIC
包裝: 管件
LTC1566-1
6
15661fa
a common mode voltage that is equal to one-half of the total
supply voltage. Figure 5 illustrates the THD versus output
common mode voltage for a 0.5VP-P/2.0VP-P differential
input/output voltage and a common mode input voltage
that is equal to one-half the total supply voltage.
Output DC Offset Control
A unique feature of the LTC1566-1 is the ability to introduce
a differential offset voltage at the output of the filter. As
seen in the “Block Diagram”, if a DC voltage is applied to Pin
5 with respect to Pin 3, the same voltage will be added to
the differential voltage seen between Pins 8 and 7.
The output DC offset control pin can be used for sideband
suppression in differential modulators, calibration of A/D
converters, or simple signal summation. Since the voltage
summing occurs at the output of the filter, Pin 5 acts as a
unfiltered input. The response from Pin 5 to Pin 8 – Pin 7
with Pins 1,2 and 3 grounded is shown in Figure 7. The
range of voltages that can be applied to Pin 5 is shown in
Figure 6 where THD is plotted versus output offset. Pin 3 is
biased to mid supply.
Output Drive
Pins 7 and 8 can drive a 1k or 300pF load connected to
AC ground with a ±0.5V signal (corresponding to a 2VP-P
differential signal). For differential loads (loads connected
across Pins 7 and 8) the outputs can produce a 2VP-P
differential signal across 2k or 150pF. For smaller signal
amplitudes the outputs can drive correspondingly larger
loads.
–5 –4
–2
0
2
4
–30
–40
–50
–60
–70
–80
–90
–3
–1
1
3
1566-1 F03
5
INPUT COMMON MODE VOLTAGE (V)
THD
(dB)
VS = 5V
VS = ±5V
DIFFERENTIAL OUTPUT (VP-P)
0.5
THD,
SNR
(dB)
–30
–40
–50
–60
–70
–80
–90
2.0
3.0
1566-1 F04
1.0
1.5
2.5
3.5
4.0
VS = 5V
VS = ±5V
S/N
OUTPUT COMMON MODE VOLTAGE (V)
–4
THD
(dB)
–30
–40
–50
–60
–70
–80
–90
–1
2
1566-1 F05
–3
–2
1
03
4
VS = 5V
VS = ±5V
Figure 3
Figure 4
Figure 5
APPLICATIO S I FOR ATIO
WU
U
Input Common Mode and Differential Voltage Range
The range of voltage each input can support while operat-
ing in its linear region is typically 0.8V to 3.7V for a single
5V supply and – 4.2V to 3.2V for a ±5V supply. Therefore,
the filter can accept a variety of common mode input
voltages. Figure 3 shows the total harmonic distortion of
the filter versus input common mode voltage with a
2VP-P differential output signal.
Figure 4 shows the total harmonic distortion and signal to
noise ratio versus differential output voltage level for both
a single 5V and a ±5V supply. The common mode voltage
of the input signal is one-half the total power supply voltage
of the filter. The spurious free dynamic range (SFDR), the
level where the THD and S/N ratio are equal, is 72dB.
For best performance, the inputs should be driven differen-
tially. For single-ended signals, connect the unused input
to Pin 3 or a common mode reference.
The filter DC differential swings listed in the “Electrical
Characteristics” are measured with input differential volt-
ages of 0.9VP-P and 1.5VP-P for 5V and ±5V supplies
respectively. Ideally the corresponding output levels would
be 3.6VP-P and 6VP-P. As seen in Figure 4, these levels are
above the range of linear operation. Input signals larger
than 0.9VP-P/1.5VP-P will result in phase inversion and
should be avoided.
Output Common Mode and Differential Voltage Range
The output is a fully differential signal with a common
mode level equal to the voltage at Pin 3 when Pin 5 is
shorted to Pin 3. The best performance is achieved using
相關PDF資料
PDF描述
LTC1569CS8-7 IC FILTER 10TH ORDR LOWPASS8SOIC
VE-B02-IY-F4 CONVERTER MOD DC/DC 15V 50W
LTC1065IN8 IC FILTR 5TH ORDR LOWPASS 8-DIP
LTC1065CSW#TRPBF IC FILTR 5TH ORDR LOWPASS 16SOIC
LTC1065CSW#TR IC FILTER LP 5TH ORD LIN 16SOIC
相關代理商/技術參數
參數描述
LTC1566-1CS8#PBF 功能描述:IC FILTER LP 7ORDER 2.3MHZ 8SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間,帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V,±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR)
LTC1566-1CS8#TR 功能描述:IC FILTER LP 7ORDER 2.3MHZ 8SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間,帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V,±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR)
LTC1566-1CS8#TRPBF 功能描述:IC FILTER LP 7ORDER 2.3MHZ 8SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間,帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V,±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR)
LTC1566-1IS8 功能描述:IC FILTER LP 7ORDER 2.3MHZ 8SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間,帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V,±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR)
LTC1566-1IS8#PBF 功能描述:IC FILTER LP 7ORDER 2.3MHZ 8SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間,帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V,±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR)