參數資料
型號: LTC1514IS8-5
廠商: LINEAR TECHNOLOGY CORP
元件分類: 穩壓器
英文描述: Step-Up/Step-Down Switched Capacitor DC/DC Converters with Low-Battery Comparator
中文描述: 0.05 A SWITCHED CAPACITOR REGULATOR, 800 kHz SWITCHING FREQ-MAX, PDSO8
封裝: 0.150 INCH, PLASTIC, SOP-8
文件頁數: 6/8頁
文件大?。?/td> 235K
代理商: LTC1514IS8-5
6
LTC1514-3.3/LTC1514-5
APPLICATIO
S I
FOR
ATIO
U
output pin cause high frequency voltage spikes on V
OUT
with every clock cycle.
There are several ways to reduce the output voltage
ripple. A larger C
OUT
capacitor (22
μ
F or greater) will
reduce both the low and high frequency ripple due to the
lower C
OUT
charging and discharging dV/dt and the lower
ESR typically found with higher value (larger case size)
capacitors. A low ESR ceramic output capacitor will
minimize the high frequency ripple, but will not reduce
the low frequency ripple unless a high capacitance value
is chosen. A reasonable compromise is to use a 10
μ
F to
22
μ
F tantalum capacitor in parallel with a 1
μ
F to 3.3
μ
F
ceramic capacitor on V
OUT
to reduce both the low and
high frequency ripple. An RC or LC filter may also be used
to reduce high frequency voltage spikes (see Figure 1).
W
U
U
Internal soft start circuitry controls the rate at which V
OUT
may be charged from 0V to its final regulated value. The
typical start-up time from V
OUT
= 0V to 5V is 4ms. This
corresponds to an effective V
OUT
charging current of only
12.5mA for a 10
μ
F output capacitor (27.5mA for 22
μ
F,
etc). Note that any output current load present during
start-up will add directly to the charging currents men-
tioned above. The soft start circuitry limits start-up
current both at initial power-up and when coming out of
shutdown.
As the V
IN
(or boosted V
IN
) to V
OUT
voltage differential
grows, the effective output impedance of the charge
pump is automatically increased by internal voltage
sensing circuitry. This feature minimizes the current
spikes pulled from V
IN
whenever the charge pump is
enabled and helps to reduce both input and output ripple.
Protection Features
The LTC1514-X contain thermal shutdown and short-
circuit protection features. The parts will shut down when
the junction temperature reaches approximately 150
°
C
and will resume operation once the junction temperature
has dropped back to approximately 140
°
C. The parts will
limit output current to 12mA (typ) when a short-circuit
condition (V
OUT
< 100mV) exists. The parts can survive
an indefinite short to GND. The LTC1514-X devices use
a low thermal resistance SO-8 package (110
°
C/W vs
150
°
C/W for standard SO-8). This permits full output
current, even at high input supply voltages.
Low-Battery Comparator
The internal low-battery comparator trips at 1.145
±
3%
(LBI ramping negative). Programming the comparator to
trip at a higher voltage can easily be done with an external
LTC1514-X
V
OUT
V
OUT
8
15
μ
F
TANTALUM
2
1
μ
F
CERAMIC
LTC1514-X
V
OUT
1514 F01
V
OUT
8
10
μ
F
TANTALUM
+
+
10
μ
F
TANTALUM
+
Figure 1. Output Ripple Reduction Techniques
Inrush Currents
A common problem with switched capacitor regulators
is inrush current—particularly during power-up and
coming out of shutdown mode. Whenever large V
IN
(or
boosted V
IN
) to V
OUT
voltage differentials are present,
most charge pumps will pull large current spikes from
the input supply. Only the effective charge pump output
impedance limits the current while the charge pump is
enabled. This may disrupt input supply regulation, espe-
cially if the input supply is a low power DC/DC converter
or linear regulator. The LTC1514-3.3/LTC1514-5 mini-
mize inrush currents both at start-up and under normal
high V
IN
to V
OUT
operation.
Figure 2. Programming the Low-Battery Comparator Trip Voltage
1
2
3
4
8
7
6
5
SHDN
LBO
LBI
GND
V
OUT
V
IN
C1
+
C1
LTC1514-X
R2
R1
V
= 1.145V(1 + R1/R2)
(LBI RAMPING NEGATIVE)
1514 F02
V
BAT
相關PDF資料
PDF描述
LTC1515CS8 Step-Up/Step-Down Switched Capacitor DC/DC Converters with Reset
LTC1515IS8 Step-Up/Step-Down Switched Capacitor DC/DC Converters with Reset
LTC1515 Quadruple 2-Input Exclusive-OR Gates 14-SOIC 0 to 70
LTC1516CS8 Micropower, Regulated 5V Charge Pump DC/DC Converter
LTC1516 Micropower, Regulated 5V Charge Pump DC/DC Converter
相關代理商/技術參數
參數描述
LTC1514IS8-5#PBF 功能描述:IC REG MULTI CONFIG 5V 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 產品培訓模塊:MIC23xxx HyperLight Load™ Regulators 標準包裝:5,000 系列:HyperLight Load® 類型:降壓(降壓) 輸出類型:固定 輸出數:1 輸出電壓:1.8V 輸入電壓:2.7 V ~ 5.5 V PWM 型:混合物 頻率 - 開關:4MHz 電流 - 輸出:2A 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-VFDFN 裸露焊盤,8-MLF? 包裝:帶卷 (TR) 供應商設備封裝:8-MLF?(2x2) 產品目錄頁面:1094 (CN2011-ZH PDF) 其它名稱:576-3303-2
LTC1514IS8-5#TR 功能描述:IC REG MULTI CONFIG 5V 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓(升壓) 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型,TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT
LTC1514IS8-5#TRPBF 功能描述:IC REG MULTI CONFIG 5V 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓(升壓) 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型,TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT
LTC1515CS8 功能描述:IC REG MULTI CONFIG ADJ 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓(升壓) 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型,TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT
LTC1515CS8#PBF 功能描述:IC REG MULTI CONFIG ADJ 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓(降壓) 輸出類型:固定 輸出數:1 輸出電壓:1.2V,1.5V,1.8V,2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP,10-MSOP(0.118",3.00mm 寬)裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤