- 您現在的位置：買賣IC網 > PDF目錄377746 > LTC1418 (Linear Technology Corporation) Low Power, 14-Bit, 200ksps ADC with Serial and Parallel I/O(低功耗,14位, 200ksps,采樣模數轉換器(帶并行和串行I/O口)) PDF資料下載
參數資料
| 型號： | LTC1418 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | Low Power, 14-Bit, 200ksps ADC with Serial and Parallel I/O(低功耗,14位, 200ksps,采樣模數轉換器(帶并行和串行I/O口)) |
| 中文描述： | 低功耗，14位，高達200ksps的串行和并行I / O（低功耗，14位，處理速度高達200ksps，采樣模數轉換器（帶并行和串行的I / O口ADC）的） |
| 文件頁數： | 9/28頁 |
| 文件大?。?/td> | 510K |
| 代理商： | LTC1418 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
9
LTC1418
APPLICATIO
S I
N
FOR
ATIO
U
Referring to Figure 1, the A
IN+
and A
IN–
inputs are con-
nected to the sample-and-hold capacitors (C
SAMPLE
) dur-
ing the acquire phase and the comparator offset is nulled by
the zeroing switches. In this acquire phase, a minimum
delay of 1
μ
s will provide enough time for the sample-and-
hold capacitors to acquire the analog signal. During the
convert phase the comparator zeroing switches open,
putting the comparator into compare mode. The input
switches the C
SAMPLE
capacitors to ground, transferring
the differential analog input charge onto the summing
junction. This input charge is successively compared with
the binary weighted charges supplied by the differential
capacitive DAC. Bit decisions are made by the high speed
comparator. At the end of a conversion, the differential
DAC output balances the A
IN+
and A
IN–
input charges. The
SAR contents (a 14-bit data word) which represent the
difference of A
IN+
and A
IN–
are loaded into the 14-bit
output latches.
W
U
DYNAMIC PERFORMANCE
The LTC1418 has excellent high speed sampling capabil-
ity. FFT (Fast Fourier Transform) test techniques are used
to test the ADC’s frequency response, distortion and noise
at the rated throughput. By applying a low distortion sine
wave and analyzing the digital output using an FFT algo-
rithm, the ADC’s spectral content can be examined for
frequencies outside the fundamental. Figure 2 shows a
typical LTC1418 FFT plot.
Signal-to-Noise Ratio
The signal-to-noise plus distortion ratio [S/(N + D)] is the
ratio between the RMS amplitude of the fundamental input
frequency to the RMS amplitude of all other frequency
components at the A/D output. The output is band limited
to frequencies from above DC and below half the sampling
frequency. Figure 2a shows a typical spectral content with
a 200kHz sampling rate and a 10kHz input. The dynamic
performance is excellent for input frequencies up to and
beyond the Nyquist limit of 100kHz.
FREQUENCY (kHz)
0
10
30
50
70
90
A
0
–20
–40
–60
–80
–100
–120
20
40
60
80
1418 F02a
100
f
SAMPLE
= 200kHz
f
= 9.9609375kHz
SFDR = 99.32
SINAD = 82.4
Figure 2a. LTC1418 Nonaveraged, 4096 Point FFT,
Input Frequency = 10kHz
FREQUENCY (kHz)
0
10
30
50
70
90
A
0
–20
–40
–60
–80
–100
–120
20
40
60
80
1418 F02b
100
f
SAMPLE
= 200kHz
f
= 97.509765kHz
SFDR = 94.29
SINAD = 81.4
Figure 2b. LTC1418 Nonaveraged, 4096 Point FFT,
Input Frequency = 97.5kHz
Effective Number of Bits
The effective number of bits (ENOBs) is a measurement of
the resolution of an ADC and is directly related to the
S/(N + D) by the equation:
N = [S/(N + D) – 1.76]/6.02
where N is the effective number of bits of resolution and
S/(N + D) is expressed in dB. At the maximum sampling
rate of 200kHz the LTC1418 maintains near ideal ENOBs
up to the Nyquist input frequency of 100kHz (refer to
Figure 3).
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1419ACG | Quad, Low Voltage, LinCMOS(TM) Differential Comparator 14-SOIC |
| LTC1419IG | 14-Bit, 800ksps Sampling A/D Converter with Shutdown |
| LTC1419AIG | 14-Bit, 800ksps Sampling A/D Converter with Shutdown |
| LTC1419ACSW | 14-Bit, 800ksps Sampling A/D Converter with Shutdown |
| LTC1419AISW | 14-Bit, 800ksps Sampling A/D Converter with Shutdown |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1418ACG | 功能描述:IC A/D CONV 14BIT SRL&PAR 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
| LTC1418ACG#PBF | 功能描述:IC A/D CONV 14BIT SRL&PAR 28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC1418ACG#TR | 功能描述:IC A/D CONV 14BIT SRL&PAR 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
| LTC1418ACG#TRPBF | 功能描述:IC A/D CONV 14BIT SRL&PAR 28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
| LTC1418ACN | 功能描述:IC A/D CONV 14BIT SRL&PAR 28-DIP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
發布緊急采購，3分鐘左右您將得到回復。