參數資料
型號: LTC1408CUH-12#TRPBF
廠商: Linear Technology
文件頁數: 6/20頁
文件大?。?/td> 0K
描述: IC ADC 12BIT 600KSPS 32-QFN
標準包裝: 2,500
位數: 12
采樣率(每秒): 600k
數據接口: 串行
轉換器數目: 1
功率耗散(最大): 15mW
電壓電源: 模擬和數字
工作溫度: 0°C ~ 70°C
安裝類型: 表面貼裝
封裝/外殼: 32-WFQFN 裸露焊盤
供應商設備封裝: 32-QFN 裸露焊盤(5x5)
包裝: 帶卷 (TR)
輸入數目和類型: 12 個單端,單極;12 個單端,雙極;6 個差分,單極;6 個差分,雙極
配用: DC887A-ND - BOARD SAR ADC LTC1408
14
LTC1408-12
140812f
APPLICATIO S I FOR ATIO
WU
UU
INPUT FILTERING AND SOURCE IMPEDANCE
The noise and the distortion of the input amplifier and
other circuitry must be considered since they will add to
the LTC1408-12 noise and distortion. The small-signal
bandwidth of the sample-and-hold circuit is 50MHz. Any
noise or distortion products that are present at the analog
inputs will be summed over this entire bandwidth. Noisy
input circuitry should be filtered prior to the analog inputs
to minimize noise. A simple 1-pole RC filter is sufficient for
many applications. For example, Figure 1 shows a 47pF
capacitor from CHO+ to ground and a 51
source resistor
to limit the net input bandwidth to 30MHz. The 47pF ca-
pacitor also acts as a charge reservoir for the input sample-
and-hold and isolates the ADC input from sampling-glitch
sensitive circuitry. High quality capacitors and resistors
should be used since these components can add distor-
tion. NPO and silvermica type dielectric capacitors have
excellent linearity. Carbon surface mount resistors can
generate distortion from self heating and from damage
that may occur during soldering. Metal film surface mount
resistors are much less susceptible to both problems.
When high amplitude unwanted signals are close in
frequency to the desired signal frequency a multiple pole
filter is required.
High external source resistance, combined with 13pF of
input capacitance, will reduce the rated 50MHz input band-
width and increase acquisition time beyond 39ns.
INPUT RANGE
The analog inputs of the LTC1408-12 may be driven fully
differentially with a single supply. Either input may swing
up to VCC, provided the differential swing is no greater than
2.5V with BIP (Pin 29) Low, or
±1.25V with (BIP Pin 29)
High. The 0V to 2.5V range is also ideally suited for single-
ended input use with single supply applications. The
common mode range of the inputs extend from ground to
the supply voltage VCC. If the difference between the CH+
and CHat any input pair exceeds 2.5V (unipolar) or 1.25V
(bipolar), the output code will stay fixed at positive full-
scale, and if this difference goes below 0V (unipolar) or –
1.25V (bipolar), the output code will stay fixed at negative
full-scale.
INTERNAL REFERENCE
The LTC1408-12 has an on-chip, temperature compen-
sated, bandgap reference that is factory trimmed to 2.5V
to obtain a precise 2.5V input span. The reference ampli-
fier output VREF, (Pin 23) must be bypassed with a capaci-
tor to ground. The reference amplifier is stable with capaci-
tors of 1
F or greater. For the best noise performance, a
10
F ceramic or a 10F tantalum in parallel with a 0.1F
ceramic is recommended. The VREF pin can be overdriven
with an external reference as shown in Figure 2. The volt-
age of the external reference must be higher than the 2.5V
of the open-drain P-channel output of the internal refer-
ence. The recommended range for an external reference
is 2.55V to VDD. An external reference at 2.55V will see a
DC quiescent load of 0.75mA and as much as 3mA
during conversion.
Figure 1. RC Input Filter
LTC1408-12
CH0+
CH0
VREF
GND
1408 F01
1
2
11
3
10
F
47pF*
51
*
CH1+
CH1
4
5
47pF*
*TIGHT TOLERANCE REQUIRED TO AVOID
APERTURE SKEW DEGRADATION
51
*
ANALOG
INPUT
ANALOG
INPUT
Figure 2. Overdriving VREF Pin with an External Reference
LTC2351-12
VREF
GND
1408 F02
23
22
10
F
LT1790-3
3.5V to 18V
3V
相關PDF資料
PDF描述
D38999/26FG11BN CONN HSG PLUG 11POS STRGHT SCKT
VE-26D-CU-S CONVERTER MOD DC/DC 85V 200W
LTC2444CUHF IC ADC 24BIT HI SPEED 38QFN
VE-264-CU-S CONVERTER MOD DC/DC 48V 200W
D38999/26WG11BN CONN HSG PLUG 11POS STRGHT SCKT
相關代理商/技術參數
參數描述
LTC1408IUH#PBF 功能描述:IC ADC 14BIT 600KSPS 32-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率(每秒):1M 數據接口:串行,SPI? 轉換器數目:1 功率耗散(最大):- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤(4x4) 包裝:Digi-Reel® 輸入數目和類型:8 個單端,單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
LTC1408IUH#TRPBF 功能描述:IC ADC 14BIT 600KSPS 32-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率(每秒):300k 數據接口:并聯 轉換器數目:1 功率耗散(最大):75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC(0.295",7.50mm 寬) 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端,單極;1 個單端,雙極
LTC1408IUH-12#PBF 功能描述:IC ADC 12BIT 600KSPS 32-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率(每秒):20M 數據接口:并聯 轉換器數目:2 功率耗散(最大):155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP(7x7) 包裝:Digi-Reel® 輸入數目和類型:4 個單端,單極;2 個差分,單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6
LTC1408IUH-12#TRPBF 功能描述:IC ADC 12BIT 600KSPS 32-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極
LTC1409CG 功能描述:IC A/D CONV 12BIT SAMPLNG 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率(每秒):300k 數據接口:并聯 轉換器數目:1 功率耗散(最大):75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC(0.295",7.50mm 寬) 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端,單極;1 個單端,雙極