- 您現在的位置：買賣IC網 > PDF目錄383290 > LTC1261LCMS8 (LINEAR TECHNOLOGY CORP) Switched Capacitor Regulated Voltage Inverter PDF資料下載
參數資料
| 型號： | LTC1261LCMS8 |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Switched Capacitor Regulated Voltage Inverter |
| 中文描述： | 0.02 A SWITCHED CAPACITOR REGULATOR, 650 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封裝： | PLASTIC, MSOP-8 |
| 文件頁數： | 7/12頁 |
| 文件大小： | 182K |
| 代理商： | LTC1261LCMS8 |
7
LTC1261L
APPLICATIO
S I
N
FOR
ATIO
U
COMP2 also monitors the divided signal at ADJ but it is
connected to a 1.17V reference, 5% below the main
reference voltage. When the divided output exceeds this
lower reference voltage indicating that the output is within
5% of the set value, COMP2 goes high turning on the REG
output transistor. This is an open drain N-channel device
capable of sinking 4mA with a 3.3V V
CC
and 5mA with a 5V
V
CC
. When in the “off” state (divided output is more than
5% below V
REF
) the drain can be pulled above V
CC
without
damage up to a maximum of 6V above ground. Note that
the REG output only indicates if the magnitude of the
output is belowthe magnitude of the set point by 5% (i.e.,
V
OUT
> –4.75V for a –5V set point). If the magnitude of the
output is forced higherthan the magnitude of the set point
( i.e., to –5.25V when the output is set for –5V) the REG
output will stay low.
W
U
OUTPUT RIPPLE
Output ripple in the LTC1261L is present from two sources;
voltage droop at the output capacitor between clocks and
frequency response of the regulation loop. Voltage droop
is easy to calculate. With a typical clock frequency of
650kHz, the charge on the output capacitor is refreshed
once every 1.54
μ
s. With a 15mA load and a 3.3
μ
F output
capacitor, the output will droop by:
C
OUT
)
I
LOAD
= 15mA
t
)
= 7mV
1.54
μ
s
)
3.3
μ
F
)
This can be a significant ripple component when the
output is heavily loaded, especially if the output capacitor
is small. If absolute minimum output ripple is required, a
10
μ
F or greater output capacitor should be used.
Regulation loop frequency response is the other major
contributor to output ripple. The LTC1261L regulates the
output voltage by limiting the amount of charge trans-
ferred to the output capacitor on a cycle-by-cycle basis.
The output voltage is sensed at the ADJ pin (COMP for
fixed output voltage versions) through an internal or
external resistor divider from the OUT pin to ground. As
the flying capacitor is first connected to the output, the
output voltage begins to change quite rapidly. As soon as
it exceeds the set point COMP1 trips, switching the state
of the charge pump and stopping the charge transfer.
Because the RC time constant of the capacitors and the
switches is quite short, the ADJ pin must have a wide AC
bandwidth to be able to respond to the output in time.
External parasitic capacitance at the ADJ pin can reduce
the bandwidth to the point where the comparator cannot
respond by the time the clock pulse finishes. When this
happens the comparator will allow a few complete pulses
through, then overcorrect and disable the charge pump
until the output drops below the set point. Under these
conditions the output will remain in regulation but the
output ripple will increase as the comparator “hunts” for
the correct value.
To prevent this from happening, an external capacitor can
be connected from ADJ (or COMP for fixed output voltage
parts) to ground to compensate for external parasitics and
increase the regulation loop bandwidth (Figure 2). This
sounds counterintuitive until we remember that the inter-
nal reference is generated with respect to OUT, not ground.
The feedback loop actually sees ground as its “output,”
thus the compensation capacitor should be connected
across the “top” of the resistor divider, from ADJ (or
COMP) to ground. By the same token, avoid adding
capacitance between ADJ (or COMP) and V
OUT
. This will
slow down the feedback loop and increase output ripple.
A 100pF capacitor from ADJ or COMP to ground will
compensate the loop properly under most conditions for
fixed voltage versions of the LTC1261L. For the adjustable
LTC1261L, the capacitor value will be dependent upon the
values of the external resistors in the divider network.
Figure 2. Regulator Loop Compensation
COMP1
1.23V
R2
V
OUT
ADJ/COMP
RESISTORS ARE
INTERNAL FOR FIXED
OUTPUT VOLTAGE PARTS
1261L F02
R1
C
C
100pF
TO CHARGE
PUMP
REF
+
–
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1261LCMS8-4 | Switched Capacitor Regulated Voltage Inverter |
| LTC1261LCMS8-4.5 | Switched Capacitor Regulated Voltage Inverter |
| LTC1261LCS8 | Switched Capacitor Regulated Voltage Inverter |
| LTC1261LCS8-4 | Switched Capacitor Regulated Voltage Inverter |
| LTC1261LCS8-4.5 | Switched Capacitor Regulated Voltage Inverter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1261LCMS8#PBF | 功能描述:IC REG SWITCHD CAP INV ADJ 8MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LTC1261LCMS8#TR | 功能描述:IC REG SWITCHD CAP INV ADJ 8MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LTC1261LCMS8#TRPBF | 功能描述:IC REG SWITCHD CAP INV ADJ 8MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LTC1261LCMS8-4 | 功能描述:IC REG SWITCHD CAP INV -4V 8MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LTC1261LCMS8-4#PBF | 功能描述:IC REG SWITCHD CAP INV -4V 8MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
發布緊急采購，3分鐘左右您將得到回復。