參數資料
型號: LTC1261LCMS8-4
廠商: LINEAR TECHNOLOGY CORP
元件分類: 穩壓器
英文描述: Switched Capacitor Regulated Voltage Inverter
中文描述: 0.02 A SWITCHED CAPACITOR REGULATOR, 650 kHz SWITCHING FREQ-MAX, PDSO8
封裝: PLASTIC, MSOP-8
文件頁數: 8/12頁
文件大小: 182K
代理商: LTC1261LCMS8-4
8
LTC1261L
APPLICATIO
S I
FOR
ATIO
U
OUTPUT FILTERING
If extremely low output ripple (<5mV) is required, addi-
tional output filtering is required. Because the LTC1261L
uses a high 650kHz switching frequency, fairly low value
RC or LC networks can be used at the output to effectively
filter the output ripple. A 10
series output resistor and a
3.3
μ
F capacitor will cut output ripple to below 3mV (Figure
3). Further reductions can be obtained with larger filter
capacitors or by using an LC output filter.
W
U
U
capacitor type for both the input bypass capacitor and the
flying capacitor.
In applications where the maximum load current is well-
defined and output ripple is critical or input peak currents
need to be minimized, the flying capacitor value can be
tailored to the application. Reducing the value of the
flying capacitor reduces the amount of charge trans-
ferred with each clock cycle. This limits maximum output
current, but also cuts the size of the voltage step at the
output with each clock cycle. The smaller capacitor
draws smaller pulses of current out of V
CC
as well,
limiting peak currents and reducing the demands on the
input supply. Table 1 shows recommended values of
flying capacitor vs maximum load capacity.
Table 1. Typical Max Load (mA) vs Flying Capacitor Value at
T
A
= 25
°
C, V
OUT
= –4V
FLYING
CAPACITOR
VALUE (
μ
F)
MAX LOAD (mA)
V
CC
= 5V
20
15
10
5
1
0.1
0.047
0.033
0.022
0.01
The output capacitor performs two functions: it provides
output current to the load during half of the charge pump
cycle and its value helps to set the output ripple voltage.
For applications that are insensitive to output ripple, the
output bypass capacitor can be as small as 1
μ
F. Larger
output capacitors will reduce output ripple further at the
expense of turn-on time.
Capacitor ESR
Output capacitor Equivalent Series Resistance (ESR) is
another factor to consider. Excessive ESR in the output
capacitor can fool the regulation loop into keeping the
output artificially low by prematurely terminating the charg-
ing cycle. As the charge pump switches to recharge the
output a brief surge of current flows from the flying
capacitors to the output capacitor. This current surge can
be as high as 100mA under full load conditions. A typical
LTC1261L-4
V
CC
5V
C1
+
C1
4
6
5
2
3
OUT
0.1
μ
F
100pF
3.3
μ
F
10
COMP
1261L F03
GND
V
OUT
= –4V
1
μ
F
+
3.3
μ
F
+
Figure 3. Output Filter Cuts Ripple Below 3mV
CAPACITOR SELECTION
Capacitor Sizing
The performance of the LTC1261L is affected by the
capacitors to which it connects. The LTC1261L requires
bypass capacitors to ground for both the V
CC
and OUT
pins. The input capacitor provides most of LTC1261L’s
supply current while it is charging the flying capacitors.
This capacitor should be mounted as close to the package
as possible and its value should be at least ten times larger
than the flying capacitor. Ceramic capacitors generally
provide adequate performance. Avoid using a tantalum
capacitor as the input bypass unless there is at
least a
0.1
μ
F ceramic capacitor in parallel with it. The charge
pump capacitor is somewhat less critical since its peak
current is limited by the switches inside the LTC1261L.
Most applications should use a 0.1
μ
F as the flying
capacitor value. Conveniently, ceramic capacitors are the
most common type of 0.1
μ
F capacitor and they work well
here. Usually the easiest solution is to use the same
相關PDF資料
PDF描述
LTC1261LCMS8-4.5 Switched Capacitor Regulated Voltage Inverter
LTC1261LCS8 Switched Capacitor Regulated Voltage Inverter
LTC1261LCS8-4 Switched Capacitor Regulated Voltage Inverter
LTC1261LCS8-4.5 Switched Capacitor Regulated Voltage Inverter
LTC1262C 12V, 30mA Flash Memory Programming Supply
相關代理商/技術參數
參數描述
LTC1261LCMS8-4#PBF 功能描述:IC REG SWITCHD CAP INV -4V 8MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓(升壓) 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式,混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC
LTC1261LCMS8-4#TR 功能描述:IC REG SWITCHD CAP INV -4V 8MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓(升壓) 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式,混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC
LTC1261LCMS8-4#TRPBF 功能描述:IC REG SWITCHD CAP INV -4V 8MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓(升壓) 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式,混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC
LTC1261LCMS8-4.5 功能描述:IC REG SWITCHED CAP INV 8MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓(升壓) 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式,混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC
LTC1261LCMS8-4.5#PBF 功能描述:IC REG SWITCHED CAP INV 8MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓(升壓) 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式,混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC