參數資料
型號： LTC1197IMS8#TRPBF
廠商： Linear Technology
文件頁數： 4/28頁
文件大?。?/td> 0K
描述： IC ADC 10BIT 500KHZ SHTDWN 8MSOP
標準包裝： 2,500
位數： 10
采樣率（每秒）： 500k
數據接口： MICROWIRE?，串行，SPI?
轉換器數目： 1
功率耗散（最大）： 25mW
電壓電源： 單電源
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 8-TSSOP，8-MSOP（0.118"，3.00mm 寬）
供應商設備封裝： 8-MSOP
包裝： 帶卷 (TR)
輸入數目和類型： 1 個差分，單極
12
LTC1197/LTC1197L
LTC1199/LTC1199L
OVERVIEW
The LTC1197/LTC1197L/LTC1199/LTC1199L are 10-bit
switched-capacitor A/D converters. These sampling ADCs
typically draw 5mA of supply current when sampling up to
500kHz (800
A at 2.7V sampling up to 250kHz). Supply
current drops linearly as the sample rate is reduced (see
Supply Current vs Sample Rate in the Typical Perfor-
mance Characteristics). The ADCs automatically power
down when not performing a conversion, drawing only
leakage current. They are packaged in 8-pin MSOP and SO
packages. The LTC1197L/LTC1199L operate on a single
supply ranging from 2.7V to 4V. The LTC1197 operates on
a single supply ranging from 4V to 9V while the LTC1199
operates from 4V to 6V.
These ADCs contain a 10-bit, switched-capacitor ADC, a
sample-and-hold and a serial port (see Block Diagram).
Although they share the same basic design, the LTC1197/
LTC1197L and LTC1199/LTC1199L differ in some re-
spects. The LTC1197/LTC1197L have a differential input
and have an external reference input pin. They can mea-
sure signals floating on a DC common mode voltage and
can operate with reduced spans down to 200mV. Reduc-
ing the span allows it to achieve 200
V resolution. The
LTC1199/LTC1199L have a 2-channel input multiplexer
with the reference connected to the supply (VCC) pin. They
can convert the input voltage of either channel with re-
spect to ground or the difference between the voltages of
the two channels.
SERIAL INTERFACE
The LTC1199/LTC1199L communicate with microproces-
sors and other external circuitry via a synchronous, half
duplex, 4-wire serial interface while the LTC1197/
LTC1197L use a 3-wire interface (see Operating Sequence
in Figures 1 and 2). These interfaces are compatible with
both SPI and MICROWIRE protocols without requiring any
additional glue logic (see MICROPROCESSOR INTER-
FACES: Motorola SPI).
DATA TRANSFER
The CLK synchronizes the data transfer with each bit being
transmitted and captured on the rising CLK edge in both
transmitting and receiving systems. The LTC1199/
LTC1199L first receives input data and then transmits
back the A/D conversion result (half duplex). Because of
the half-duplex operation, DIN and DOUT may be tied
together allowing transmission over just three wires: CS,
CLK and DATA (DIN/DOUT).
Data transfer is initiated by a falling chip select (CS) signal.
After CS falls the LTC1199/LTC1199L look for a start bit on
the DIN input. After the start bit is received, the 3-bit input
word is shifted into the DIN input which configures the
LTC1199/LTC1199L and starts the conversion. After two
null bits, the result of the conversion is output on the DOUT
line in MSB-first format. At the end of the data exchange
CS should be brought high. This resets the LTC1199/
LTC1199L in preparation for the next data exchange.
Bringing CS high after the conversion also minimizes
supply current if CLK is left running.
Figure 1. LTC1197/LTC1197L Operating Sequence
1197/99 F01
CLK
CS
tdDO
tsuCS
B0*
B1
B2
B3
B4
B5
B6
B7
B8
B9
NULL
BITS
Hi-Z
14
13
12
11
10
9
8
7
6
5
4
3
2
1
DOUT
HI-Z
*AFTER COMPLETING THE DATA TRANSFER, IF FURTHER CLOCKS ARE APPLIED WITH CS LOW,
THE ADC WILL OUTPUT ZEROS INDEFINITELY
tCYC (14 CLKs )*
tSMPL
(1.5 CLKs)
POWER
DOWN
tCONV
(10.5 CLKs)
APPLICATIO S I FOR ATIO
WU
UU
相關PDF資料
PDF描述
VI-2N2-IU-F1 CONVERTER MOD DC/DC 15V 200W
VI-BTK-MW-F4 CONVERTER MOD DC/DC 40V 100W
MS27656E25F35SD CONN RCPT 128POS WALL MNT W/SCKT
V300B3V3M100BL3 CONVERTER MOD DC/DC 3.3V 100W
MAX3098EBCSE+T IC RS485/422 RX 32MBPS 16-SOIC
相關代理商/技術參數
參數描述
LTC1197IS8 功能描述:IC A/DCONV 10BIT W/SHTDWN 8-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
LTC1197IS8#PBF 功能描述:IC A/DCONV 10BIT W/SHTDWN 8-SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
LTC1197IS8#TR 功能描述:IC ADC 10BIT 500KHZ SHTDWN 8SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
LTC1197IS8#TRPBF 功能描述:IC A/DCONV 10BIT W/SHTDWN 8-SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
LTC1197L 制造商:LINER 制造商全稱:Linear Technology 功能描述:10-Bit, 500ksps ADCs in MSOP with Auto Shutdown
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*