- 您現在的位置：買賣IC網 > PDF目錄30768 > LTC1174IN8#TRPBF (LINEAR TECHNOLOGY CORP) 1 A SWITCHING REGULATOR, 200 kHz SWITCHING FREQ-MAX, PDIP8 PDF資料下載
參數資料
| 型號： | LTC1174IN8#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 1 A SWITCHING REGULATOR, 200 kHz SWITCHING FREQ-MAX, PDIP8 |
| 封裝： | 0.300 INCH, LEAD FREE, PLASTIC, DIP-8 |
| 文件頁數： | 2/20頁 |
| 文件大小： | 251K |
| 代理商： | LTC1174IN8#TRPBF |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁
10
LTC1174
LTC1174-3.3/LTC1174-5
1174fe
APPLICATIO S I FOR ATIO
WU
UU
output voltage is now taken off the GND pin. Therefore,
the maximum input voltage is now determined by the
difference between the absolute maximum voltage rating
and the output voltage. A maximum of 12V is specified in
Figure 5, giving the circuit a 1.5V of headroom for VIN. Note
that the circuit can operate from a minimum of 4V, making
it ideal for a 4 NiCad cell application. For a higher output
current circuit, please refer to the Typical Applications
section.
Absolute Maximum Ratings and Latchup Prevention
The absolute maximum ratings specify that SW (Pin 5) can
never exceed VIN (Pin 6) by more than 0.3V. Normally this
situation should never occur. It could, however, if the
output is held up while the supply is pulled down. A con-
dition where this could potentially occur is when a battery
is supplying power to an LTC1174/LTC1174-3.3/
LTC1174-5 regulator and also to one or more loads in
parallel with the the regulator’s VIN. If the battery is dis-
connected while the LTC1174/LTC1174-3.3/LTC1174-5
regulator is supplying a light load and one of the parallel
circuits is a heavy load, the input capacitor of the LTC1174/
LTC1174-3.3/LTC1174-5 regulator could be pulled down
faster than the output capacitor, causing the absolute
maximum ratings to be exceeded. The result is often a
latchup which can be destructive if VIN is reapplied. Bat-
tery disconnect is possible as a result of mechanical stress,
bad battery contacts or use of a lithium-ion battery with
a built-in internal disconnect. The user needs to assess
his/her application to determine whether this situation
could occur. If so, additional protection is necessary.
Prevention against latchup can be accomplished by sim-
ply connecting a Schottky diode across the SW and VIN
pins as shown in Figure 6. The diode will normally be
reverse biased unless VIN is pulled below VOUT at which
time the diode will clamp the (VOUT – VIN) potential to less
than the 0.6V required for latchup. Note that a low leakage
Schottky should be used to minimize the effect on no-load
supply current. Schottky diodes such as MBR0530, BAS85
and BAT84 work well. Another more serious effect of the
protection diode leakage is that at no load with nothing to
provide a sink for this leakage current, the output voltage
can potentially float above the maximum allowable toler-
ance. To prevent this from occuring, a resistor must be
connected between VOUT and ground with a value low
enough to sink the maximum possible leakage current.
Figure 4. LTC1174 Adjustable Configuration
R2
R1
1
VOUT
1174 F04
100pF*
6.8nF**
*
**
ADJUSTABLE APPLICATIONS
LOW NOISE APPLICATIONS
LTC1174
VFB
Figure 5. Positive-to-Negative 5V Converter
3
SHUTDOWN
2
7
6
8
1
5
4
50
H**
VOUT
–5V
45mA
MBRS140T3
1174 F05
*
**
AVX TPSD476K016
COILTRONICS CTX50-4
INPUT VOLTAGE
4V TO 12V
0.1
F
47
F*
16V
×2
47
F*
16V
×2
LTC1174HV-5
LBIN
LBOUT
IPGM
GND
VIN
VOUT
SW
+
Figure 6. Preventing Absolute Maximum
Ratings from Being Exceeded
1174 F06
VIN
VOUT
LATCHUP
PROTECTION
SCHOTTKY
SW
LTC1174
LTC1174-3.3
LTC1174-5
+
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1174CN8#TRPBF | 1 A SWITCHING REGULATOR, 200 kHz SWITCHING FREQ-MAX, PDIP8 |
| LTC1174CN8-5#TRPBF | 1 A SWITCHING REGULATOR, 200 kHz SWITCHING FREQ-MAX, PDIP8 |
| LTC1174CN8-5#TR | 1 A SWITCHING REGULATOR, 200 kHz SWITCHING FREQ-MAX, PDIP8 |
| LTC1174HVCS8#TR-5 | SWITCHING REGULATOR, 200 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC1174CS8#TR-5 | SWITCHING REGULATOR, 200 kHz SWITCHING FREQ-MAX, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1174IS8 | 功能描述:IC REG BUCK INV ADJ 1A 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC1174IS8#PBF | 功能描述:IC REG BUCK INV ADJ 1A 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC1174IS8#TR | 功能描述:IC REG BUCK INV ADJ 1A 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC1174IS8#TRPBF | 功能描述:IC REG BUCK INV ADJ 1A 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC1177-12 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Isolated MOSFET Drivers |
發布緊急采購，3分鐘左右您將得到回復。