- 您現在的位置：買賣IC網 > PDF目錄377730 > LTC1090C (Linear Technology Corporation) Single Chip 10-Bit Data Acquisition System PDF資料下載
參數資料
| 型號： | LTC1090C |
| 廠商： | Linear Technology Corporation |
| 英文描述： | Single Chip 10-Bit Data Acquisition System |
| 中文描述： | 單芯片10位數據采集系統 |
| 文件頁數： | 20/28頁 |
| 文件大小： | 344K |
| 代理商： | LTC1090C |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
20
LTC1090
1090fc
Input Op Amps
When driving the analog inputs with an op amp it is
important that the op amp settle within the allowed time
(see Figure 10). Again, the “+” and “–” input sampling
times can be extended as described above to accommo-
date slower op amps. Most op amps including the LT1006
and LT1013 single supply op amps can be made to settle
well even with the minimum settling windows of 4
μ
s (“+”
input) and 2
μ
s (“–” input) which occur at the maximum
clock rates (ACLK = 2MHz and SCLK = 1MHz). Figures 11
and 12 show examples of adequate and poor op amp
settling.
RC Input Filtering
It is possible to filter the inputs with an RC network as
shown in Figure 13. For large values of C
F
(e.g., 1
μ
F), the
capacitive input switching currents are averaged into a net
DC current. Therefore, a filter should be chosen with a
small resistor and large capacitor to prevent DC drops
across the resistor. The magnitude of the DC current is
approximately l
DC
= 60pF x V
IN
/t
CYC
and is roughly propor-
tional to V
IN
. When running at the minimum cycle time of
33
μ
s, the input current equals 9
μ
A at V
IN
= 5V. In this case,
a filter resistor of 50
will cause 0.1LSB of full-scale error.
If a larger filter resistor must be used, errors can be
eliminated by increasing the cycle time as shown in the
typical curve of Maximum Filter Resistor vs Cycle Time.
Figure 11. Adequate Settling of Op Amp Driving Analog Input
Figure 12. Poor Op Amp Settling can Cause A/D Errors
Figure 13. RC Input Filtering
APPLICATIOU
W
U
U
HORIZONTAL: 1
μ
s/DIV
V
HORIZONTAL: 20
μ
s/DIV
V
LTC1090 AI18
V
IN
R
FILTER
I
DC
C
FILTER
LTC1090
“ + ”
“ – ”
Input Leakage Current
Input leakage currents can also create errors if the source
resistance gets too large. For instance, the maximum input
leakage specification of 1
μ
A (at 125
°
C) flowing through a
source resistance of 1k
will cause a voltage drop of 1mV
or 0.2LSB. This error will be much reduced at lower
temperatures because leakage drops rapidly (see typical
curve of Input Channel Leakage Current vs Temperature).
Noise Coupling into Inputs
High source resistance input signals (>500
) are more
sensitive to coupling from external sources. It is preferable
to use channels near the center of the package (i.e., CH2 to
CH7) for signals which have the highest output resistance
because they are essentially shielded by the pins on the
package ends (DGND and CH0). Grounding any unused
inputs (especially the end pin, CH0) will also reduce
outside coupling into high source resistances.
4. Sample-and-Hold
Single Ended Inputs
The LTC1090 provides a built-in sample and hold (S&H)
function for all signals acquired in the single ended mode
(COM pin grounded). This sample and hold allows the
LTC1090 to convert rapidly varying signals (see typical
curve of S&H Acquisition Time vs Source Resistance). The
input voltage is sampled during the t
SMPL
time as shown
in Figure 10. The sampling interval begins after the fourth
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1090CJ | Quad Precision Single Supply Low-Power Operational Amplifier 14-PDIP -40 to 85 |
| LTC1090CN | Single Chip 10-Bit Data Acquisition System |
| LTC1090CS | Single Chip 10-Bit Data Acquisition System |
| LTC1090CSW | Single Chip 10-Bit Data Acquisition System |
| LTC1090M | Single Chip 10-Bit Data Acquisition System |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1090CJ | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Single Chip 10-Bit Data Acquisition System |
| LTC1090CN | 功能描述:IC DATA ACQUIS SYS 10BIT 20-DIP RoHS:否 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統（DAS） 分辨率（位）:16 b 采樣率（每秒）:21.94k 數據接口:MICROWIRE?，QSPI?，串行，SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤 |
| LTC1090CN#PBF | 功能描述:IC DATA ACQUIS SYS 10BIT 20-DIP RoHS:是 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Data Converter Basics 標準包裝:1 系列:- 類型:電機控制 分辨率（位）:12 b 采樣率（每秒）:1M 數據接口:串行，并聯 電壓電源:單電源 電源電壓:2.7 V ~ 3.6 V，4.5 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:100-TQFP 供應商設備封裝:100-TQFP（14x14） 包裝:剪切帶 (CT) 其它名稱:296-18373-1 |
| LTC1090CS | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Single Chip 10-Bit Data Acquisition System |
| LTC1090CSW | 功能描述:IC DATA ACQUIS SYS 10BIT 20-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統（DAS） 分辨率（位）:16 b 采樣率（每秒）:21.94k 數據接口:MICROWIRE?，QSPI?，串行，SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤 |
發布緊急采購，3分鐘左右您將得到回復。