- 您現在的位置：買賣IC網 > PDF目錄44987 > LT6604CUFF-5#TRPBF (LINEAR TECHNOLOGY CORP) SPECIALTY ANALOG CIRCUIT, PQCC34 PDF資料下載
參數資料
| 型號： | LT6604CUFF-5#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 模擬信號調理 |
| 英文描述： | SPECIALTY ANALOG CIRCUIT, PQCC34 |
| 封裝： | 4 X 7 MM, 0.75 MM HEIGHT, LEAD FREE, PLASTIC, QFN-34 |
| 文件頁數： | 2/16頁 |
| 文件大?。?/td> | 182K |
| 代理商： | LT6604CUFF-5#TRPBF |
LT6604-5
10
66045fa
APPLICATIONS INFORMATION
Use Figure 4 to determine the interface between the
LT6604-5 and a current output DAC. The gain, or “tran-
simpedance,” is dened as A = VOUT/IIN. To compute the
transimpedance, use the following equation:
A
=
806 R1
R1
+R2
Ω
By setting R1 + R2 = 806Ω, the gain equation reduces to A
= R1(Ω). The voltage at the pins of the DAC is determined
by R1, R2, the voltage on VMID and the DAC output current.
Consider Figure 4 with R1 = 49.9Ω and R2 = 750Ω. The
voltage at VMID, for VS = 3.3V, is 1.65V. The voltage at the
DAC pins is given by:
VDAC = VMID
R1
+R2+806
+IIN
R1R2
R1
+R2
= 51mV +IIN46.8Ω
Evaluating the LT6604-5
The low impedance levels and high frequency operation
of the LT6604-5 require some attention to the matching
networks between the LT6604-5 and other devices. The
previous examples assume an ideal (0Ω) source impedance
and a large (1k) load resistance. Among practical examples
where impedance must be considered is the evaluation of
the LT6604-5 with a network analyzer.
Figure 5 is a laboratory setup that can be used to character-
ize the LT6604-5 using single-ended instruments with 50Ω
source impedance and 50Ω input impedance. For a unity
gain conguration the LT6604-5 requires an 806Ω source
resistance yet the network analyzer output is calibrated
for a 50Ω load resistance. The 1:1 transformer, 51.1Ω
and 787Ω resistors satisfy the two constraints above.
The transformer converts the single-ended source into a
differential stimulus. Similarly, the output of the LT6604-5
will have lower distortion with larger load resistance yet
the analyzer input is typically 50Ω. The 4:1 turns (16:1
impedance) transformer and the two 402Ω resistors of
Figure 5, present the output of the LT6604-5 with a 1600Ω
differential load, or the equivalent of 800Ω to ground at
each output. The impedance seen by the network analyzer
input is still 50Ω, reducing reections in the cabling be-
tween the transformer and analyzer input.
Differential and Common Mode Voltage Ranges
The differential ampliers inside the LT6604-5 contain
circuitry to limit the maximum peak-to-peak differential
voltage through the lter. This limiting function prevents
excessive power dissipation in the internal circuitry and
provides output short-circuit protection. The limiting
function begins to take effect at output signal levels
above 2VP-P and it becomes noticeable above 3.5VP-P.
This is illustrated in Figure 6; the LT6604-5 channel was
congured with unity passband gain and the input of the
lter was driven with a 1MHz signal. Because this voltage
limiting takes place well before the output stage of the
lter reaches the supply rails, the input/output behavior
of the IC shown in Figure 6 is relatively independent of
the power supply voltage.
–
+
0.1μF
3.3V
–
+
0.01μF
CURRENT
OUTPUT
DAC
VOUT
+
VOUT
–
66045 F04
R2
R1
IIN
–
IIN
+
R2
R1
=
VOUT
+ – VOUT–
IIN
+ – IIN–
806 R1
R1 + R2
25
27
4
34
6
2
29
7
1/2
LT6604-5
Figure 4
–
+
0.1μF
2.5V
–2.5V
–
+
66045 F05
402Ω
NETWORK
ANALYZER
INPUT
50Ω
COILCRAFT
TTWB-16A
4:1
NETWORK
ANALYZER
SOURCE
COILCRAFT
TTWB-1010
1:1
50Ω
51.1Ω
787Ω
25
27
4
34
6
2
29
7
1/2
LT6604-5
Figure 5
相關PDF資料 |
PDF描述 |
|---|---|
| LT6604IUFF-5#PBF | SPECIALTY ANALOG CIRCUIT, PQCC34 |
| LT6604IUFF-5#TRPBF | SPECIALTY ANALOG CIRCUIT, PQCC34 |
| LT6654AHS6-5#TRPBF | 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 5 V, PDSO6 |
| LT6660HCDC-10#PBF | 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 10 V, PSSO3 |
| LT6660JCDC-10#TRPBF | 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 10 V, PSSO3 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT6604IUFF-10#PBF | 功能描述:IC AMP DIFF LN DUAL 34-QFN RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:4 輸出類型:- 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:45nA 電壓 - 輸入偏移:2000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:40mA 電壓 - 電源，單路/雙路(±):3 V ~ 32 V，±1.5 V ~ 16 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:帶卷 (TR) 其它名稱:LM324ADTBR2G-NDLM324ADTBR2GOSTR |
| LT6604IUFF-10#TRPBF | 功能描述:IC AMP DIFF LN DUAL 34-QFN RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:Excalibur™ 放大器類型:J-FET 電路數:1 輸出類型:- 轉換速率:45 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:20pA 電壓 - 輸入偏移:490µV 電流 - 電源:1.7mA 電流 - 輸出 / 通道:48mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 38 V，±2.25 V ~ 19 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:帶卷 (TR) |
| LT6604IUFF-10-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Very Low Noise, Differential Amplifi er and 10MHz Lowpass Filter |
| LT6604IUFF-15#PBF | 功能描述:IC AMP DIFF LN DUAL 34-QFN RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:4 輸出類型:- 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:45nA 電壓 - 輸入偏移:2000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:40mA 電壓 - 電源，單路/雙路(±):3 V ~ 32 V，±1.5 V ~ 16 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:帶卷 (TR) 其它名稱:LM324ADTBR2G-NDLM324ADTBR2GOSTR |
| LT6604IUFF-15#TRPBF | 功能描述:IC AMP DIFF LN DUAL 34-QFN RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:Excalibur™ 放大器類型:J-FET 電路數:1 輸出類型:- 轉換速率:45 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:20pA 電壓 - 輸入偏移:490µV 電流 - 電源:1.7mA 電流 - 輸出 / 通道:48mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 38 V，±2.25 V ~ 19 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。