- 您現在的位置：買賣IC網 > PDF目錄11226 > LT6556CGN#TRPBF (Linear Technology)IC VIDEO MULTIPLEXER 2X1 24SSOP PDF資料下載
參數資料
| 型號： | LT6556CGN#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 2/16頁 |
| 文件大小： | 0K |
| 描述： | IC VIDEO MULTIPLEXER 2X1 24SSOP |
| 標準包裝： | 2,500 |
| 功能： | 視頻多路復用器 |
| 電路： | 3 x 2:1 |
| 電壓電源： | 雙電源 |
| 電壓 - 電源，單路/雙路(±)： | ±2.25 V ~ 6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-SSOP（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 24-SSOP |
| 包裝： | 帶卷 (TR) |
LT6556
10
6556f
APPLICATIO S I FOR ATIO
WU
U
In order to counteract any peaking in the frequency re-
sponse from driving a capacitive load, a series resistance
can be inserted in the line at the output of the part to at-
ten the response. Figure 4 shows the frequency response
with the same 4cm trace from Figure 3, now with a 10Ω
series resistor inserted near the output pin of the ampli-
er. Note that using a 10Ω series resistor with a 1k load
only decreases the output amplitude by 0.1dB or 1% and
has a minimal effect on the bandwidth of the system. See
the graph labeled “Maximum Capacitive Load vs Output
Series Resistor” in the Typical Performance Characteristics
section for more information.
FREQUENCY (MHz)
0.1
AMPLITUDE
(dB)
6
4
2
0
–2
–4
–6
1
10
100
1000
6556 F04
4cm TRACE
RS, OUT = 10Ω
VS = ±5V
VOUT = 200mVP-P
RL = 1k
TA = 25°C
Figure 4. Response vs Series Output Resistance
While the AGND pins on the LT6556 are not connected to
the amplier circuitry, tying them to ground or another
“quiet” node signicantly increases channel isolation
and is always recommended. The AGND pins do have
ESD protection and therefore should not be connected to
potentials outside the power supply range.
Low ESL/ESR bypass capacitors should be placed as close
to the positive and negative supply pins as possible. One
4700pF ceramic capacitor is recommended for both V+
and V–supply busses. Additional 470pF ceramic capacitors
with minimal trace length on each supply pin will further
improve AC and transient response as well as channel
isolation. For high current drive and large-signal transient
applications, additional 1F to 10F tantalums should
be added on each supply. The smallest value capacitors
should be placed closest to the package.
To maintain the LT6556’s channel isolation, it is benecial
to shield parallel input and parallel output traces using a
ground plane or power supply traces. Vias between top-
side and backside metal may be required to maintain a
low inductance ground near the part where numerous
traces converge. See Figures 7 and 8 for photos of an
optimized layout.
Single Supply Operation
Figure 5 illustrates how to use the LT6556 with a single
supply ranging from 4.5V to 12V. Since the output range is
comparable to the input range, the DC bias point at the input
can be set anywhere between the supplies that will prevent
the AC-coupled signal from running into the output range
limits. As shown, the DC input level is mid-supply.
The only additional power dissipation in the single supply
conguration is through the resistor bias string at the input
and through any load resistance at the output. In many
cases, the output can be used to directly drive other single
supply devices without additional coupling and without
any resistive load.
1/3
LT6556
5k
AGND
IN
VIN
22μF
OUT
V+
V–
4.5V TO 12V
6556 F05
Figure 5. Single Supply Conguration, One Channel Shown
Input Expansion
In applications with more than two inputs per channel,
multiple LT6556s can be connected directly together at the
outputs. Logic circuitry can be used to drive the
EN pins
of each LT6556 to ensure that only one set of channels is
buffered at a time. See Figure 9 for a schematic.
Since the output impedance of a disabled LT6556 is high,
adding additional channels will not resistively load an
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1391IGN | IC MULTIPLEXER 8X1 16SSOP |
| LTC1391IGN#PBF | IC MULTIPLEXER 8X1 16SSOP |
| ADG1433YRUZ-REEL7 | IC SWITCH TRIPLE SPDT 16TSSOP |
| ADG706BRUZ-REEL | IC MULTIPLEXER 16X1 28TSSOP |
| TMS320F28069UPZT | IC MCU 32BIT 256KB FLASH 100LQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT6556CUF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:750MHz Gain of 1 Triple 2:1Video Multiplexer |
| LT6556CUF#PBF | 功能描述:IC VIDEO MULTIPLEXER 2X1 24QFN RoHS:是 類別:集成電路 (IC) >> 接口 - 模擬開關，多路復用器，多路分解器 系列:- 標準包裝:1,000 系列:- 功能:多路復用器 電路:1 x 4:1 導通狀態電阻:- 電壓電源:雙電源 電壓 - 電源，單路/雙路(±):±5V 電流 - 電源:7mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| LT6556CUF#TRPBF | 功能描述:IC VIDEO MULTIPLEXER 2X1 24QFN RoHS:是 類別:集成電路 (IC) >> 接口 - 模擬開關，多路復用器，多路分解器 系列:- 標準包裝:48 系列:- 功能:開關 電路:4 x SPST - NO 導通狀態電阻:100 歐姆 電壓電源:單/雙電源 電壓 - 電源，單路/雙路(±):2 V ~ 12 V，±2 V ~ 6 V 電流 - 電源:50nA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:管件 |
| LT6556IGN | 制造商:Linear Technology 功能描述:Video Multiplexer 24-Pin SSOP N |
| LT6556IGN#PBF | 功能描述:IC VIDEO MULTIPLEXER 2X1 24SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 模擬開關，多路復用器，多路分解器 系列:- 其它有關文件:STG4159 View All Specifications 標準包裝:5,000 系列:- 功能:開關 電路:1 x SPDT 導通狀態電阻:300 毫歐 電壓電源:雙電源 電壓 - 電源，單路/雙路(±):±1.65 V ~ 4.8 V 電流 - 電源:50nA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:7-WFBGA，F(xiàn)CBGA 供應商設備封裝:7-覆晶 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。