- 您現在的位置：買賣IC網 > PDF目錄3319 > LT6233CS6-10#TRM (Linear Technology)IC OP AMP SGL 1.2MA R-R SOT23-6 PDF資料下載
參數資料
| 型號： | LT6233CS6-10#TRM |
| 廠商： | Linear Technology |
| 文件頁數： | 9/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OP AMP SGL 1.2MA R-R SOT23-6 |
| 標準包裝： | 1 |
| 放大器類型： | 通用 |
| 電路數： | 1 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 115 V/µs |
| 增益帶寬積： | 375MHz |
| 電流 - 輸入偏壓： | 1.5µA |
| 電壓 - 輸入偏移： | 100µV |
| 電流 - 電源： | 1.15mA |
| 電流 - 輸出 / 通道： | 55mA |
| 電壓 - 電源，單路/雙路(±)： | 3 V ~ 12.6 V，±1.5 V ~ 6.3 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SOT-23-6 |
| 供應商設備封裝： | TSOT-23-6 |
| 包裝： | 剪切帶 (CT) |
| 產品目錄頁面： | 1321 (CN2011-ZH PDF) |
| 其它名稱： | LT6233CS6-10 LT6233CS6-10#TRMCT LT6233CS6-10-ND |
17
623345fc
LT6233/LT6233-10
LT6234/LT6235
applicaTions inForMaTion
Figure 1. Simplified Schematic
Figure 2. VS = ±2.5V, AV = 1 with Large Overdrive
ENABLE
DESD6
DESD5
–V
+V
+VIN
–VIN
+V
623345 F01
BIAS
DIFFERENTIAL
DRIVE GENERATOR
VOUT
+V
CM
I1
–V
DESD3
–V
DESD4
+V
DESD1
–V
DESD2
+V
D1
C1
D2
Q5
Q6
Q4
Q2
Q3
Q1
2.5V
–2.5V
0V
500s/DIV
623345 F02
1V
/DIV
Amplifier Characteristics
Figure 1 is a simplified schematic of the LT6233/LT6234/
LT6235, which has a pair of low noise input transistors
Q1 and Q2. A simple current mirror Q3/Q4 converts the
differential signal to a single-ended output, and these
transistors are degenerated to reduce their contribution
to the overall noise.
Capacitor C1 reduces the unity-cross frequency and im-
proves the frequency stability without degrading the gain
bandwidth of the amplifier. Capacitor CM sets the overall
amplifier gain bandwidth. The differential drive generator
supplies current to transistors Q5 and Q6 that swing the
output from rail-to-rail.
Input Protection
Thereareback-to-backdiodes,D1andD2acrossthe+and
– inputs of these amplifiers to limit the differential input
voltage to ±0.7V. The inputs of the LT6233/LT6234/LT6235
do not have internal resistors in series with the input tran-
sistors. This technique is often used to protect the input
devices from overvoltage that causes excessive current
to flow. The addition of these resistors would significantly
degrade the low noise voltage of these amplifiers. For
instance, a 100Ω resistor in series with each input would
generate 1.8nV/√Hz of noise, and the total amplifier noise
voltage would rise from 1.9nV/√Hz to 2.6nV/√Hz. Once
the input differential voltage exceeds ±0.7V, steady-state
current conducted through the protection diodes should
be limited to ±40mA. This implies 25Ω of protection re-
sistance is necessary per volt of overdrive beyond ±0.7V.
These input diodes are rugged enough to handle transient
currents due to amplifier slew rate overdrive and clipping
without protection resistors.
The photo of Figure 2 shows the output response to an
input overdrive with the amplifier connected as a voltage
follower. With the input signal low, current source I1 satu-
rates and the differential drive generator drives Q6 into
saturation so the output voltage swings all the way to V–.
The input can swing positive until transistor Q2 saturates
into current mirror Q3/Q4. When saturation occurs, the
output tries to phase invert, but diode D2 conducts current
from the signal source to the output through the feedback
connection. The output is clamped a diode drop below the
input. In this photo, the input signal generator is limiting
at about 20mA.
相關PDF資料 |
PDF描述 |
|---|---|
| MAX412CSA+T | IC OPAMP LN LV PREC 28MHZ 8-SOIC |
| 532446-9 | HDI PIN ASSY 2 ROW 100 POS |
| P6KE20C-E3/54 | TVS 600W 20V 10% BIDIR AXIAL |
| P6KE13-E3/54 | TVS 600W 13V 10% UNIDIR AXIAL |
| MAX9626ATC+ | IC DIFF AMP/DRIVER LN 12TQFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT6233CS6TRMPBF | 制造商:Linear Technology 功能描述:LT6233 60MHz LP SOT23 op amp |
| LT6233IS6 | 制造商:Linear Technology 功能描述:OP Amp Single GP R-R O/P ±6.3V/12.6V 6-Pin TSOT-23 |
| LT6233IS6#PBF | 制造商:Linear Technology 功能描述:OP Amp Single GP R-R O/P 6.3V/12.6V 6-Pin TSOT-23 制造商:Linear Technology 功能描述:OPAMP, UNITY GAIN STABLE, 60MHZ, 17V/us, TSOT-23-6, Op Amp Type:Unity Gain Stable, No. of Amplifiers:1, Slew Rate:17V/s, Supply Voltage Range:3V to 12.6V, Amplifier Case Style:TSOT-23, No. of Pins:6, Bandwidth:60MHz , RoHS Compliant: Yes 制造商:Linear Technology 功能描述:SC-Amps/High Speed, Cut Tape 60 MHz Ultra Low Noise Low power Op Amp |
| LT6233IS6#TR | 功能描述:IC OP AMP SGL 60MHZ R-R SOT23-6 RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:1.8 V/µs 增益帶寬積:6.5MHz -3db帶寬:4.5MHz 電流 - 輸入偏壓:5nA 電壓 - 輸入偏移:100µV 電流 - 電源:65µA 電流 - 輸出 / 通道:35mA 電壓 - 電源，單路/雙路(±):1.8 V ~ 5.25 V，±0.9 V ~ 2.625 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
| LT6233IS6#TRM | 功能描述:IC OP AMP SGL 60MHZ R-R SOT23-6 RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:1.8 V/µs 增益帶寬積:6.5MHz -3db帶寬:4.5MHz 電流 - 輸入偏壓:5nA 電壓 - 輸入偏移:100µV 電流 - 電源:65µA 電流 - 輸出 / 通道:35mA 電壓 - 電源，單路/雙路(±):1.8 V ~ 5.25 V，±0.9 V ~ 2.625 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。