- 您現在的位置：買賣IC網 > PDF目錄5752 > LT6204IS#PBF (Linear Technology)IC OPAMP R-R INOUT QUAD LP14SOIC PDF資料下載
參數資料
| 型號： | LT6204IS#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 11/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP R-R INOUT QUAD LP14SOIC |
| 標準包裝： | 55 |
| 放大器類型： | 通用 |
| 電路數： | 4 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 25 V/µs |
| 增益帶寬積： | 100MHz |
| 電流 - 輸入偏壓： | 3.8µA |
| 電壓 - 輸入偏移： | 2600µV |
| 電流 - 電源： | 2.8mA |
| 電流 - 輸出 / 通道： | 40mA |
| 電壓 - 電源，單路/雙路(±)： | 2.5 V ~ 12.6 V，±1.25 V ~ 6.3 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 14-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 14-SO |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LT6202/LT6203/LT6204
19
620234fd
APPLICATIONS INFORMATION
Input Protection
There are back-to-back diodes, D1 and D2, across the
+ and – inputs of these amplifiers to limit the differential
input voltage to ±0.7V. The inputs of the LT6202/LT6203/
LT6304 do not have internal resistors in series with the
input transistors. This technique is often used to protect
the input devices from over voltage that causes excessive
currents to flow. The addition of these resistors would
significantly degrade the low noise voltage of these ampli-
fiers.Forinstance,a100Ωresistorinserieswitheachinput
would generate 1.8nV/√Hz of noise, and the total amplifier
noise voltage would rise from 1.9nV/√Hz to 2.6nV/√Hz.
Once the input differential voltage exceeds ±0.7V, steady
state current conducted though the protection diodes
should be limited to ±40mA. This implies 25Ω of protec-
tion resistance per volt of continuous overdrive beyond
±0.7V. The input diodes are rugged enough to handle
transient currents due to amplifier slew rate overdrive or
momentary clipping without these resistors.
Figure 2 shows the input and output waveforms of the
amplifier driven into clipping while connected in a gain
of AV = 1. When the input signal goes sufficiently beyond
the power supply rails, the input transistors will saturate.
When saturation occurs, the amplifier loses a stage of
phase inversion and the output tries to change states.
Diodes D1 and D2 forward bias and hold the output within
OV
Figure 2. VS = ±2.5V, AV = 1 with Large Overdrive
a diode drop of the input signal. In this photo, the input
signal generator is clipping at ±35mA, and the output
transistors supply this generator current through the
protection diodes.
With the amplifier connected in a gain of AV ≥ 2, the output
can invert with very heavy input overdrive. To avoid this
inversion, limit the input overdrive to 0.5V beyond the
power supply rails.
ESD
The LT6202/LT6203/LT6204 have reverse-biased ESD
protection diodes on all inputs and outputs as shown in
Figure 1. If these pins are forced beyond either supply,
unlimited current will flow through these diodes. If the
current is transient and limited to one hundred milliamps
or less, no damage to the device will occur.
Noise
The noise voltage of the LT6202/LT6203/LT6204 is equiva-
lent to that of a 225Ω resistor, and for the lowest possible
noise it is desirable to keep the source and feedback re-
sistance at or below this value, i.e. RS + RG||RFB ≤ 225Ω.
With RS + RG||RFB = 225Ω the total noise of the amplifier
is: en = √(1.9nV)2+(1.9nV)2 = 2.7nV. Below this resis-
tance value, the amplifier dominates the noise, but in the
resistanceregionbetween225Ωandapproximately10kΩ,
the noise is dominated by the resistor thermal noise. As
the total resistance is further increased, beyond 10k, the
noise current multiplied by the total resistance eventually
dominates the noise.
The product of en √ISUPPLY is an interesting way to gauge
lownoiseamplifiers.Manylownoiseamplifierswithlowen
have high ISUPPLY current. In applications that require low
noise with the lowest possible supply current, this product
can prove to be enlightening. The LT6202/LT6203/LT6204
have an en, √ISUPPLY product of 3.2 per amplifier, yet it is
commontoseeamplifierswithsimilarnoisespecifications
have an en √ISUPPLY product of 4.7 to 13.5.
For a complete discussion of amplifier noise, see the
LT1028 data sheet.
相關PDF資料 |
PDF描述 |
|---|---|
| 1-826375-6 | CONN MTIS SGL VERT BLACK 16POS |
| RMCF1206FT20K0 | RES 20K OHM 1/4W 1% 1206 SMD |
| 60598-7 | CONN UNINSUL RECEPT 20-24AWG |
| AD8426BCPZ-WP | IC AMP INSTR RR 1.5MHZ 16LFCSP |
| 61782-2 | CONN EDGE DISCONNECT 16-22AWG |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT6205 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Single/Dual/Quad Single Supply 3V, 100MHz Video Op Amps |
| LT6205_1 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Single/Dual/Quad Single Supply 3V, 100MHz Video Op Amps |
| LT6205CS5 | 制造商:Linear Technology 功能描述:OP Amp Single Volt Fdbk R-R O/P ±6.3V/12.6V 5-Pin TSOT-23 |
| LT6205CS5#PBF | 制造商:Linear Technology 功能描述:SC-Amps/High Speed, Cut Tape 3V 100MHz, Video Op Amp |
| LT6205CS5#TR | 功能描述:IC OPAMP VID SGL 100MHZ TSOT23-5 RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 標準包裝:1,000 系列:- 應用:驅動器 輸出類型:差分 電路數:3 -3db帶寬:350MHz 轉換速率:1000 V/µs 電流 - 電源:14.5mA 電流 - 輸出 / 通道:60mA 電壓 - 電源，單路/雙路(±):5 V ~ 12 V，±2.5 V ~ 6 V 安裝類型:表面貼裝 封裝/外殼:20-VFQFN 裸露焊盤 供應商設備封裝:20-QFN 裸露焊盤（4x4） 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。