參數資料
型號： LT3837IFE#PBF
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： SWITCHING CONTROLLER, 110 kHz SWITCHING FREQ-MAX, PDSO16
封裝： 4.40 MM, LEAD FREE, PLASTIC, TSSOP-16
文件頁數： 10/28頁
文件大小： 247K
代理商： LT3837IFE#PBF
LT3837
18
3837fc
APPLICATIONS INFORMATION
Enable Delay Time (ENDLY)
Enable delay time provides a programmable delay between
turn-off of the primary gate drive node and the subsequent
enabling of the feedback amplier. As discussed earlier, this
delay allows the feedback amplier to ignore the leakage
inductance voltage spike on the primary side.
The worst-case leakage spike pulse width is at maximum
load conditions. So set the enable delay time at these
conditions.
While the typical applications for this part use forced
continuous operation, it is conceivable that a secondary-
side controller might cause discontinuous operation at
light loads. Under such conditions the amount of energy
stored in the transformer is small. The yback waveform
becomes “l(fā)azy” and some time elapses before it indicates
the actual secondary output voltage. The enable delay time
should be made long enough to ignore the “irrelevant”
portion of the yback waveform at light load.
Even though the LT3837 has a robust gate drive, the gate
transition-time slows with very large MOSFETs. Increase
delay time is as required when using such MOSFETs.
The enable delay resistor is set with the following equa-
tion:
Rk
tns
ENDLY
()
() –
.
Ω=
30
2 616
Keep RENDLY greater than 40k. A good starting point
is 56k.
Primary Gate Delay Time (PGDLY)
Primary gate delay is the programmable time from the
turn-off of the synchronous MOSFET to the turn-on of
the primary side MOSFET. Correct setting eliminates
overlap between the primary side switch and secondary
side synchronous switch(es) and the subsequent current
spike in the transformer. This spike will cause additional
component stress and a loss in regulator efciency.
The primary gate delay resistor is set with the following
equation:
Rk
tns
PGDLY
()
.
Ω=
+ 47
901
A good starting point is 27k.
Soft-Start Functions
The LT3837 contains an optional soft-start function that is
enabled by connecting an external capacitor between the
SFST pin and ground. Internal circuitry prevents the control
voltage at the VC pin from exceeding that on the SFST pin.
There is an initial pull-up circuit to quickly bring the SFST
voltage to approximately 0.8V. From there it charges to
approximately 2.8V with a 20μA current source.
The SFST node is then discharged to 0.8V when a fault
occurs. A fault is VCC too low (undervoltage lockout),
current sense voltage greater than 200mV or the IC’s
thermal (overtemperature) shutdown is tripped. When
SFST discharges, the VC node voltage is also pulled low
to below the minimum current voltage. Once discharged,
the SFST recharges up again.
In this manner, switch currents are reduced and the stresses
in the converter are reduced during fault conditions.
The time it takes to fully charge soft-start is:
t
CV
μA
ms C
μF
SS
SFST
==
.
(
)
14
20
70
UVLO Pin Function
The UVLO pin provides a user programming undervoltage
lockout. This is usually used to provide undervoltage
lockout based on VIN. The gate drivers are disabled when
UVLO is below the 1.24V UVLO threshold. An external
resistive divider between the input supply and ground is
used to set the turn-on voltage.
The bias current on this pin depends on the pin volt-
age and UVLO state. The change provides the user with
adjustable UVLO hysteresis. When the pin rises above
the UVLO threshold a small current is sourced out of the
pin, increasing the voltage on the pin. As the pin voltage
drops below this threshold, the current is stopped, further
相關PDF資料
PDF描述
LT3837IFE#TRPBF SWITCHING CONTROLLER, 110 kHz SWITCHING FREQ-MAX, PDSO16
LT3845AMPFE#TRPBF SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO16
LT3845AIFE#TRPBF SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO16
LT3845AMPFE#PBF SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO16
LT3845EFE#TR SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO16
相關代理商/技術參數
參數描述
LT383L313 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Optoelectronic
LT3844 制造商:LINER 制造商全稱:Linear Technology 功能描述:High Voltage, Current Mode Switching Regulator Controller with Programmable Operating Frequency
LT3844EFE 制造商:LINER 制造商全稱:Linear Technology 功能描述:High Voltage, Current Mode Switching Regulator Controller with Programmable Operating Frequency
LT3844EFE#PBF 功能描述:IC REG CTRLR BST INV PWM 16TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR
LT3844EFE#TRPBF 功能描述:IC REG CTRLR BST INV PWM 16TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*