- 您現在的位置：買賣IC網 > PDF目錄377724 > LT3781IG (LINEAR TECHNOLOGY CORP) Bootstrap Start Dual Transistor Synchronous Forward Controller PDF資料下載
參數資料
| 型號： | LT3781IG |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Bootstrap Start Dual Transistor Synchronous Forward Controller |
| 中文描述： | SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO20 |
| 封裝： | 5.30 MM, PLASTIC, SSOP-20 |
| 文件頁數： | 12/20頁 |
| 文件大?。?/td> | 267K |
| 代理商： | LT3781IG |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁
12
LT3781
3781i
internally as the system clock for the IC. Free-run
frequency for the internal oscillator is programmed via an
RC timing network connected to the FSET pin. A pull-up
resistor R
FSET
, connected from the 5V
REF
pin to FSET,
provides current to charge a timing capacitor C
FSET
con-
nected from the FSETpin to ground. The oscillator oper-
ates by allowing R
FSET
to charge C
FSET
up to 2.5V at which
point R
FSET
is pulled back toward ground by a 2.5K resistor
internal to the LT3781. When the voltage across C
FSET
is
pulled down to 1.5V, the FSET pin becomes high imped-
ance, once again allowing R
FSET
to charge C
FSET
.
Figure 3 is a plot of oscillator frequency vs C
FSET
and R
FSET
is shown below. Typical values for 300kHz operation
(150kHz system frequency) are C
FSET
= 150pF and
R
FSET
= 51k
.
600
Figure 3. Oscillator Frequency vs. Timing Components
Due the relatively fast fall time of the oscillator waveform,
the FSET pin is held at its 1.5V threshold by an internal low
impedance clamp to reduce undershoot error. As a result,
if this pin is externally forced low for any reason, external
current limiting is required to prevent damage to the
LT3781. Continuous source current from the FSET pin
should not exceed 1mA. Putting a 2k resistor in series with
any low impedance pull-down device will assure proper
function and protect the IC from damage.
Another common error amplifier configuration is for
optocoupler use in fully isolated converters with second-
ary side control (Figure 2). In such a system, the dominant
pole for the feedback loop is created at the secondary side
controller, so the error amplifier needs only to translate the
optocoupler information. The bandwidths of the
optocoupler and amplifier should be as high as possible to
simplify system compensation. This high bandwidth
operation is accomplished by using the error amplifier as
a transimpedance amplifier, with the optocoupler transis-
tor emitter providing feedback information directly into
the V
FB
pin. A resistor from V
FB
to ground provides the DC
bias condition for the optocoupler. Connecting the
optocoupler transistor collector to the local 5V
REF
supply
reduces Miller capacitance effects and maximizes the
bandwidth of the optocoupler. Also, higher optocoupler
current means higher bandwidth, and the 5V
REF
supply
can provide collector currents up to 10mA.
Figure 2. Optocoupler High-BW Configuration
Oscillator Frequency Programming and
Synchronization
The LT3781 internal oscillator runs at twice the system
switching frequency. The oscillator output toggles a T
flip-flop, generating a 50% duty cycle pulse that is used
APPLICATIOU
W
U
U
V
FB
5V
REF
V
SENSE
V
C
1.25V
3781 F01
LT3781
9
5
10
–
+
5V
TIMING RESISTOR (k
)
20
100
O
150
250
300
350
450
40
60
70
3781 F03
200
500
550
400
30
50
80
90
100
330pF
150pF
100pF
200pF
相關PDF資料 |
PDF描述 |
|---|---|
| LT4256-3 | Positive High Voltage Hot Swap Controller with Open-Circuit Detect |
| LT4256-3CGN | Positive High Voltage Hot Swap Controller with Open-Circuit Detect |
| LT4256-3IGN | Positive High Voltage Hot Swap Controller with Open-Circuit Detect |
| LT4351 | MOSFET Diode-OR Controller |
| LT4351CMS | JACK RJ45 8POS/2PORT RTANG PCB |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT3781IG#PBF | 功能描述:IC REG CTRLR ISO PWM CM 20-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,000 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:1MHz 占空比:50% 電源電壓:9 V ~ 10 V 降壓:無 升壓:是 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 包裝:帶卷 (TR) |
| LT3781IG#TR | 功能描述:IC REG CTRLR ISO PWM CM 20-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LT3781IG#TRPBF | 功能描述:IC REG CTRLR ISO PWM CM 20-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LT3782 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:2-Phase Step-Up DC/DC Controller |
| LT3782A | 制造商:LINER 制造商全稱:Linear Technology 功能描述:2-Phase Step-Up DC/DC Controller |
發布緊急采購，3分鐘左右您將得到回復。