參數資料
型號： LT3781EG
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： Bootstrap Start Dual Transistor Synchronous Forward Controller
中文描述： SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO20
封裝： 5.30 MM, PLASTIC, SSOP-20
文件頁數： 14/20頁
文件大?。?/td> 267K
代理商： LT3781EG
14
LT3781
3781i
Shutdown
The LT3781 SHDN pin will support TTL and CMOS logic
signals and also analog inputs. The SHDN pin turn-on
(rising) threshold is 1.25V with 150mV of hysteresis. A
common use of the SHDN pin is for under voltage detec-
tion on the input supply. Driving the SHDN pin with a
resistor-divider connected from the input supply to ground
will prevent switching until the desired input supply volt-
age is achieved.
An 18V clamp on the V
CC
pin is enabled during shutdown
mode, preventing a trickle start circuit from pulling that pin
above maximum operational levels.
The LT3781 enters an ultralow current shutdown mode
when the SHDN pin is below 350mV. During this mode,
total supply current drops to a typical value of 16
μ
A. When
SHDN rises above 350mV, the IC will draw increasing
amounts of supply current until just before the 1.25V
turn-on threshold is achieved, when the supply current
reaches 75
μ
A.
The shutdown function can be disabled by connecting the
SHDN pin to V
CC
. This pin is internally clamped to 2.5V
through a 20k series input resistance and can therefore
draw almost 1mA when tied directly to the V
CC
supply. This
additional current can be minimized by making the con-
nection through an external series resistor (100k is typi-
cally used).
Soft-Start
The LT3781 current control pin (V
C
) limits sensed current
to zero at voltage less than 1.4V through full current limit
at V
C
= 3.2V, yielding 1.8V over the full regulation range.
The voltage on the V
C
pin is internally forced to be less than
or equal to SS + 0.7V. As such, the SS pin has a “dead
zone” between 0V and 0.7V, where a zero sensed current
condition is maintained. At SS voltages above 0.7V, the
sensed current limit threshold on the V
C
pin may rise as
needed up to the SS maintained current limit value. Once
the SS pin rises to the V
C
pin maximum value less 0.7V, or
2.5V, the SS circuit has no effect.
The SS pin sources a typical current of 10
μ
A. Placing a
capacitor (C
SS
) from the SS pin to ground will cause the
voltage on the SS pin to ramp up at a controlled rate,
allowing a graceful increase of maximum converter output
current during a start-up condition. The start-up delay
time to full available current limit is:
t
SS
= 2.5 10
5
C
SS
(sec)
The LT3781 internally pulls the SS pin below the zero
current threshold during any fault condition to assure
graceful recovery. The SS circuit also acts as a fault control
latch to assure a full-range recovery from a short duration
fault. Once a fault condition is detected, the LT3781 will
suspend switching until the SS pin has discharged to
approximately 225mV.
Layout Considerations-Grounding
The LT3781 is typically used in high current converter
designs that involve substantial switching transients. The
switch drivers on the IC are designed to drive large
capacitances and, as such, generate significant transient
currents. Careful consideration must be made regarding
input and local power supply bypassing to avoid corrupt-
ing the ground references used by the error amplifier and
current sense circuitry.
Effective grounding of the two-transistor synchronous
forward topology where the LT3781 is used is inherently
difficult. The situation is complicated further by the num-
ber of bypass elements that must be considered.
Typically, high current paths and transients from the input
supply and any local drive supplies must be kept isolated
from SGND, to which sensitive circuits such as the error
amp reference and the current sense circuits, as well as the
local 5V
REF
supply, are referred. By virtue of the topologies
used in LT3781 applications, the large currents from the
primary switches, as well as the switch drive transients,
pass through the sense resistor to ground. This defines
the ground connection of the sense resistor as the refer-
ence point for both SGND and PGND. In nonisolated
applications where SGND is the output reference, we now
have a condition where every bypass capacitor in the
converter is referenced to the same point.
APPLICATIOU
W
U
U
相關PDF資料
PDF描述
LT3781IG Bootstrap Start Dual Transistor Synchronous Forward Controller
LT4256-3 Positive High Voltage Hot Swap Controller with Open-Circuit Detect
LT4256-3CGN Positive High Voltage Hot Swap Controller with Open-Circuit Detect
LT4256-3IGN Positive High Voltage Hot Swap Controller with Open-Circuit Detect
LT4351 MOSFET Diode-OR Controller
相關代理商/技術參數
參數描述
LT3781EG#PBF 功能描述:IC REG CTRLR ISO PWM CM 20-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,000 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:1MHz 占空比:50% 電源電壓:9 V ~ 10 V 降壓:無 升壓:是 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 包裝:帶卷 (TR)
LT3781EG#TR 功能描述:IC REG CTRLR ISO PWM CM 20-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LT3781EG#TRPBF 功能描述:IC REG CTRLR ISO PWM CM 20-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LT3781IG 功能描述:IC REG CTRLR ISO PWM CM 20-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,000 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:1MHz 占空比:50% 電源電壓:9 V ~ 10 V 降壓:無 升壓:是 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 包裝:帶卷 (TR)
LT3781IG#PBF 功能描述:IC REG CTRLR ISO PWM CM 20-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,000 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:1MHz 占空比:50% 電源電壓:9 V ~ 10 V 降壓:無 升壓:是 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 包裝:帶卷 (TR)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*