- 您現在的位置：買賣IC網 > PDF目錄30768 > LT3695EMSE-3.3#PBF (LINEAR TECHNOLOGY CORP) 2 A SWITCHING REGULATOR, 2420 kHz SWITCHING FREQ-MAX, PDSO16 PDF資料下載
參數資料
| 型號： | LT3695EMSE-3.3#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 2 A SWITCHING REGULATOR, 2420 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | LEAD FREE, PLASTIC, MSOP-16 |
| 文件頁數： | 5/30頁 |
| 文件大?。?/td> | 491K |
| 代理商： | LT3695EMSE-3.3#PBF |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
LT3695 Series
13
3695fa
APPLICATIONS INFORMATION
A good choice of switching frequency should allow an
adequate input voltage range (see Input Voltage Range sec-
tion) and keep the inductor and capacitor values small.
Input Voltage Range
The minimum input voltage is determined by either the
LT3695 regulators’ minimum operating voltage of ~3.6V
(VBD > 3V) or by their maximum duty cycle (see equation
in Operating Frequency Trade-Offs section). The minimum
input voltage due to duty cycle is:
V
VV
ft
VV
IN MIN
OUT
D
SW OFF MIN
DSW
()
=
+
+
1
where VIN(MIN) is the minimum input voltage, and tOFF(MIN)
is the minimum switch off time. Note that a higher switch-
ing frequency will increase the minimum input voltage.
If a lower dropout voltage is desired, a lower switching
frequency should be used.
The maximum input voltage for LT3695 regulator applica-
tions depends on switching frequency, the absolute maxi-
mum ratings of the VIN and BOOST pins and the operating
mode. The LT3695 regulators can operate from continuous
input voltages up to 36V. Input voltage transients of up to
60V are also safely withstood. However, note that while
VIN > VOVLO (overvoltage lockout, 38V typical), the LT3695
regulators will stop switching, allowing the output to fall
out of regulation.
For a given application where the switching frequency
and the output voltage are already xed, the maximum
input voltage that guarantees optimum output voltage
ripple for that application can be found by applying the
following expression:
V
VV
ft
VV
IN MAX
OUT
D
SW ON MIN
DSW
()
=
+
+
where VIN(MAX) is the maximum operating input voltage,
VOUT is the output voltage, VD is the catch diode drop
(~0.5V), VSWistheinternalswitchdrop(~0.5Vatmaxload),
fSW is the switching frequency (set by RT) and tON(MIN) is
the minimum switch on time (~150ns). Note that a higher
switching frequency will reduce the maximum operating
input voltage. Conversely, a lower switching frequency
will be necessary to achieve optimum operation at high
input voltages.
Special attention must be paid when the output is in
start-up, short-circuit or other overload conditions. Dur-
ing these events, the inductor peak current might easily
reach and even exceed the maximum current limit of
the LT3695 regulators, especially in those cases where
the switch already operates at minimum on-time. The
circuitry monitoring the current through the catch diode
via the DA pin prevents the switch from turning on again
if the inductor valley current is above 1.6A nominal. In
these cases, the inductor peak current is therefore the
maximum current limit of the LT3695 regulators plus the
additional current overshoot during the turn off delay due
to minimum on time:
IA
VV
L
t
LPEAK
IN MAX
OUT OL
ON MIN
()
(
)
()
=+
2
where IL(PEAK) is the peak inductor current, VIN(MAX) is
the maximum expected input voltage, L is the inductor
value, tON(MIN) is the minimum on time and VOUT(OL) is the
output voltage under the overload condition. The parts are
robust enough to survive prolonged operation under these
conditions as long as the peak inductor current does not
exceed 3.5A. Inductor current saturation and excessive
junction temperature may further limit performance.
Input voltage transients of up to VOVLO are acceptable
regardless of the switching frequency. In this case, the
LT3695 regulators may enter pulse-skipping operation
where some switching pulses are skipped to maintain
output regulation. In this mode the output voltage ripple
and inductor current ripple will be higher than in normal
operation.
Input voltage transients above VOVLO and up to 60V can
be tolerated. However, since the parts will stop switching
during these transients, the output will fall out of regulation
and the output capacitor may eventually be completely
discharged. This case must be treated then as a start-up
condition as soon as VIN returns to values below VOVLO
and the part starts switching again.
相關PDF資料 |
PDF描述 |
|---|---|
| LT3695EMSE-3.3#TRPBF | 2 A SWITCHING REGULATOR, 2420 kHz SWITCHING FREQ-MAX, PDSO16 |
| LT3751IUFD#TR | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC20 |
| LT3751IUFD#TRPBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC20 |
| LT3751EFE | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO20 |
| LT3751EUFD#TRPBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT3695EMSE-5#PBF | 功能描述:IC REG BUCK 5V 1A 16MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LT3695EMSE-5#PBF | 制造商:Linear Technology 功能描述:IC STEP-DOWN REGULATOR MSOP-16 |
| LT3695EMSE-5#TRPBF | 功能描述:IC REG BUCK 5V 1A 16MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LT3695EMSEPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:1A Fault Tolerant Micropower Step-Down Regulator |
| LT3695EMSETRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:1A Fault Tolerant Micropower Step-Down Regulator |
發布緊急采購，3分鐘左右您將得到回復。