- 您現在的位置：買賣IC網 > PDF目錄30767 > LT3585EDDB-2#PBF (LINEAR TECHNOLOGY CORP) 0.95 A BATTERY CHARGE CONTROLLER, PDSO10 PDF資料下載
參數資料
| 型號： | LT3585EDDB-2#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.95 A BATTERY CHARGE CONTROLLER, PDSO10 |
| 封裝： | 3 X 2 MM, LEAD FREE, PLASTIC, MO-229WECD-1, DFN-10 |
| 文件頁數： | 7/20頁 |
| 文件大?。?/td> | 423K |
| 代理商： | LT3585EDDB-2#PBF |
LT3585-0/LT3585-1
LT3585-2/LT3585-3
15
3585f
APPLICATIO S I FOR ATIO
WU
UU
Board Layout
The high voltage operation of these parts demand care-
ful attention to board layout. You will not get advertised
performance with careless layout. Figure 10 shows the
recommended component placement. Keep the area for the
high voltage end of the secondary as small as possible. Also
note the larger than minimum spacing for all high voltage
nodes in order to meet breakdown voltage requirements for
the circuit board. It is imperative to keep the electrical path
formed by C1, the primary of T1, and the LT3585 series IC
as short as possible. If this path is haphazardly made long,
Figure 10. LT3585 Suggested Layout
it will effectively increase the leakage inductance of T1,
which may result in an overvoltage condition on the SW
pin. The CHRG/IADJ pin trace should be kept as short as
possible while minimizing the adjacent edge with the SW
pin trace. This will eliminate false toggling of the CHRG/IADJ
pin during sharp transitions on the SW pin. Thermal vias
should be added underneath the Exposed Pad, Pin 11, to
enhance the LT3585’s thermal performance. These vias
should go directly to a large area of ground plane. Acting
as a heat sink, the thermal vias/ground plane will lower
the device’s operating temperature.
1
2
3
4
5
10
9
8
7
6
11
THERMAL
VIAS
IGBTIN
VOUT
D1 (DUAL DIODE)
PHOTOFLASH
CAPACITOR
IGBTPWR
GND
VIN
VBAT
C2
C1
3585 F10
T1
R2
R1
GND
DONE CHRG
TO GATE OF IGBT
相關PDF資料 |
PDF描述 |
|---|---|
| LT3641EUFD#PBF | 3.4 A DUAL SWITCHING CONTROLLER, 2350 kHz SWITCHING FREQ-MAX, PQCC28 |
| LT3641IUFD#TRPBF | 3.4 A DUAL SWITCHING CONTROLLER, 2350 kHz SWITCHING FREQ-MAX, PQCC28 |
| LT3641EFE#TRPBF | 3.4 A DUAL SWITCHING CONTROLLER, 2350 kHz SWITCHING FREQ-MAX, PDSO28 |
| LT3641EUFD#TRPBF | 3.4 A DUAL SWITCHING CONTROLLER, 2350 kHz SWITCHING FREQ-MAX, PQCC28 |
| LT3641IUFD#PBF | 3.4 A DUAL SWITCHING CONTROLLER, 2350 kHz SWITCHING FREQ-MAX, PQCC28 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT3585EDDB-3 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Photofl ash Chargers with Adjustable Input Current and IGBT Drivers |
| LT3585EDDB-3#TRPBF | 功能描述:IC CHARGER PHOTOFLASH 10-DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:- 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
| LT3587 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:High Voltage Monolithic Inverter and Dual Boost |
| LT3587EUD#PBF | 功能描述:IC REG BOOST INV ADJ DL 20QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 產品培訓模塊:MIC23xxx HyperLight Load™ Regulators 標準包裝:5,000 系列:HyperLight Load® 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.8V 輸入電壓:2.7 V ~ 5.5 V PWM 型:混合物 頻率 - 開關:4MHz 電流 - 輸出:2A 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-VFDFN 裸露焊盤，8-MLF? 包裝:帶卷 (TR) 供應商設備封裝:8-MLF?（2x2） 產品目錄頁面:1094 (CN2011-ZH PDF) 其它名稱:576-3303-2 |
| LT3587EUD#TRPBF | 功能描述:IC REG BOOST INV ADJ DL 20QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
發布緊急采購，3分鐘左右您將得到回復。