參數資料
型號: LT3500IMSE#TRPBF
廠商: LINEAR TECHNOLOGY CORP
元件分類: 穩壓器
英文描述: 3.5 A SWITCHING REGULATOR, 2800 kHz SWITCHING FREQ-MAX, PDSO16
封裝: LEAD FREE, PLASTIC, MSOP-16
文件頁數: 5/28頁
文件大?。?/td> 318K
代理商: LT3500IMSE#TRPBF
LT3500
13
3500fc
APPLICATIONS INFORMATION
Note that the LT3500 will regulate if the input voltage is
taken above the calculated maximum voltage as long as
maximum ratings of the VIN and BST pins are not violated.
However operation in this region of input voltage will exhibit
pulse skipping behavior.
Example:
VOUT1 = 3.3V, IOUT1 = 1A, Frequency = 1MHz,
Temperature = 25°C,
VSW = 0.3V, VD = 0.4V, tON(MIN) = 150ns,
tOFF(MIN) = 110ns
DC
MAX = 1 (110ns)1MHz = 89%
V
IN(MIN) =
3.3
+ 0.4
0.89
0.4+ 0.3= 4.06V
DC
MIN = tON(MIN) Frequency = 15%
V
IN(MAX) =
3.3
+ 0.4
0.15
0.4+ 0.3 = 24.57V
Inductor Selection and Maximum Output Current
A good rst choice for the inductor value is:
L
=
(V
IN VOUT1) VOUT1
V
IN f
where f is frequency in MHz and L is in μH.
With this value the maximum load current will be ~2A,
independent of input voltage. The inductor’s RMS current
rating must be greater than your maximum load current
and its saturation current should be about 30% higher. To
keep efciency high, the series resistance (DCR) should
be less than 0.05Ω.
For applications with a duty cycle of about 50%, the induc-
tor value should be chosen to obtain an inductor ripple
current less than 40% of peak switch current.
Of course, such a simple design guide will not always result
in the optimum inductor for your application. A larger value
provides a slightly higher maximum load current, and will
reduce the output voltage ripple. If your load is lower than
1.5A, then you can decrease the value of the inductor and
operate with higher ripple current. This allows you to use
a physically smaller inductor, or one with a lower DCR
resulting in higher efciency.
The current in the inductor is a triangle wave with an
average value equal to the load current. The peak switch
current is equal to the output current plus half the peak-to
peak inductor ripple current. The LT3500 limits its switch
current in order to protect itself and the system from
overload faults. Therefore, the maximum output current
that the LT3500 will deliver depends on the current limit,
the inductor value, switch frequency, and the input and
output voltages. The inductor is chosen based on output
current requirements, output voltage ripple requirements,
size restrictions and efciency goals.
When the switch is off, the inductor sees the output volt-
age plus the catch diode drop. This gives the peak-to-peak
ripple current in the inductor:
ΔI
L =
1
DC
() V
OUT1 + VD
()
Lf
where f is the switching frequency of the LT3500 and L
is the value of the inductor. The peak inductor and switch
current is:
I
SW(PK) = ILPK = IOUT1 +
ΔI
L
2
相關PDF資料
PDF描述
LT3757MPMSE#TRPBF SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO10
LT3757HMSE#TRPBF SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO10
LT574AKNW 1-CH 12-BIT SUCCESSIVE APPROXIMATION ADC, PARALLEL ACCESS, PDIP28
LT574ALNW 1-CH 12-BIT SUCCESSIVE APPROXIMATION ADC, PARALLEL ACCESS, PDIP28
LT574AJNW 1-CH 12-BIT SUCCESSIVE APPROXIMATION ADC, PARALLEL ACCESS, PDIP28
相關代理商/技術參數
參數描述
LT3500T 制造商:Eaton Corporation 功能描述:TYPE LT TRIP UNIT ONLY 3P 500A 600VAC MAX
LT3501 制造商:LINER 制造商全稱:Linear Technology 功能描述:Monolithic Dual Tracking 3A Step-Down Switching Regulator
LT3501_12 制造商:LINER 制造商全稱:Linear Technology 功能描述:Monolithic Dual Tracking 3A Step-Down Switching
LT3501EFE 制造商:Linear Technology 功能描述:Conv DC-DC Dual Step Down 3.1V to 25V 20-Pin TSSOP EP
LT3501EFE#PBF 功能描述:IC REG BUCK ADJ 3A DL 20TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓(降壓) 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON(1.45x1) 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2