參數資料
型號： LT3470ITS8
廠商： Linear Integrated Systems
英文描述： Micropower Buck Regulator with Integrated Boost and Catch Diodes
中文描述： 微功耗降壓穩壓器與集成升壓二極管和捕捉
文件頁數： 8/16頁
文件大小： 205K
代理商： LT3470ITS8
8
LT3470
3470f
APPLICATIU
Input Voltage Range
The minimum input voltage required to generate a particu-
lar output voltage in an LT3470 application is limited by
either its 4V undervoltage lockout or by its maximum duty
cycle. The duty cycle is the fraction of time that the internal
switch is on and is determined by the input and output
voltages:
V
V
V
V
V
IN
SW
D
+
–
where V
D
is the forward voltage drop of the catch diode
(~0.6V) and V
SW
is the voltage drop of the internal switch
at maximum load (~0.4V). Given DC
MAX
= 0.90, this leads
to a minimum input voltage of:
W
U
U
DC
OUT
D
=
+
V
V
V
+
DC
V
V
IN MIN
(
OUT
D
MAX
D
SW
)
–
=
+
This analysis assumes the part has started up such that the
capacitor tied between the BOOST and SW pins is charged
to more than 2V. For proper start-up, the minimum input
voltage is limited by the boost circuit as detailed in the
section BOOST Pin Considerations.
The maximum input voltage is limited by the absolute
maximum V
IN
rating of 40V, provided an inductor of
sufficient value is used.
Inductor Selection
The switching action of the LT3470 during continuous
operation produces a square wave at the SW pin that
results in a triangle wave of current in the inductor. The
hysteretic mode control regulates the top and bottom
current limits (see Electrical Characteristics) such that the
average inductor current equals the load current. For safe
operation, it must be noted that the LT3470 cannot turn the
switch on for less than ~150ns. If the inductor is small and
the input voltage is high, the current through the switch
may exceed safe operating limit before the LT3470 is able
to turn off. To prevent this from happening, the following
equation provides a minimum inductor value:
L
V
t
I
MIN
IN MAX
(
MAX
=
)
ON-TIME(MIN)
where V
IN(MAX)
is the maximum input voltage for the
application, t
ON-TIME(MIN)
is ~150ns and I
MAX
is the maxi-
mum allowable increase in switch current during a mini-
mum switch on-time (150mA). While this equation provides
a safe inductor value, the resulting application circuit may
switch at too high a frequency to yield good efficiency. It
is advised that switching frequency be below 1.2MHz
during normal operation:
f
DC V
L
V
I
D
OUT
L
=
+
)
1–
where f is the switching frequency,
I
L
is the ripple current
in the inductor (~150mA), V
D
is the forward voltage drop
of the catch diode, and V
OUT
is the desired output voltage.
If the application circuit is intended to operate at high duty
cycles (V
IN
close to V
OUT
), it is important to look at the
calculated value of the switch off-time:
t
DC
f
OFF-TIME
=
1–
The calculated t
OFF-TIME
should be more than LT3470’s
minimum t
OFF-TIME
(See Electrical Characteristics), so the
application circuit is capable of delivering full rated output
current. If the full output current of 200mA is not required,
the calculated t
OFF-TIME
can be made less than minimum
t
OFF-TIME
possibly allowing the use of a smaller inductor.
See Table 1 for an inductor value selection guide.
Table 1. Recommended Inductors for Loads up to 200mA
V
OUT
V
IN
Up to 16V
2.5V
3.3V
5V
12V
V
IN
Up to 40V
33
μ
H
33
μ
H
33
μ
H
47
μ
H
10
μ
H
10
μ
H
15
μ
H
33
μ
H
Choose an inductor that is intended for power applica-
tions. Table 2 lists several manufacturers and inductor
series.
For robust output short-circuit protection at high V
IN
(up
to 40V) use at least a 33
μ
H inductor with a minimum
450mA saturation current. If short-circuit performance is
not required, inductors with I
SAT
of 300mA or more may
be used. It is important to note that inductor saturation
相關PDF資料
PDF描述
LTBDM Micropower Buck Regulator with Integrated Boost and Catch Diodes
LT3486 Dual 1.3A White LED Step-Up Converters with Wide Dimming
LT3486EDHC Dual 1.3A White LED Step-Up Converters with Wide Dimming
LT3486EFE Dual 1.3A White LED Step-Up Converters with Wide Dimming
LT3524 Regulating Pulse Width Modulator
相關代理商/技術參數
參數描述
LT3470ITS8#PBF 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 4V to 40V 8-Pin TSOT-23 制造商:Linear Technology 功能描述:IC BUCK REGULATOR 8-TSOT-23 制造商:Linear Technology 功能描述:SP-SWREG/Monolithic, Cut Tape 300mA, 40V Micropower Step-Down Reg in ThinSOT 制造商:Linear Technology 功能描述:IC, BUCK REGULATOR, 8-TSOT-23, Primary Input Voltage:40V, No. of Outputs:1, Output Voltage:16V, Output Current:200mA, No. of Pins:8, Operating Temperature Min:-40C, Operating Temperature Max:125C, MSL:MSL 1 - Unlimited , RoHS Compliant: Yes
LT3470ITS8#TR 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 4V to 40V 8-Pin TSOT-23 T/R 制造商:Linear Technology 功能描述:SP-SWREG/Monolithic, 300mA, 40V Micropower Step-Down Reg in ThinSOT
LT3470ITS8#TRM 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 4V to 40V 8-Pin TSOT-23 T/R
LT3470ITS8#TRMPBF 功能描述:IC REG BUCK ADJ 0.2A TSOT23-8 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2
LT3470ITS8#TRPBF 功能描述:IC REG BUCK ADJ 0.2A TSOT23-8 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*