- 您現在的位置：買賣IC網 > PDF目錄377774 > LT3467 (Linear Technology Corporation) 1A Low Noise High Current LED Charge Pump with Independent Torch/Flash Current Control PDF資料下載
參數資料
| 型號： | LT3467 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | 1A Low Noise High Current LED Charge Pump with Independent Torch/Flash Current Control |
| 中文描述： | 第1A低噪聲大電流LED的獨立火炬電荷泵/閃光電流控制 |
| 文件頁數： | 7/12頁 |
| 文件大?。?/td> | 102K |
| 代理商： | LT3467 |
LTC 3216
7
3216fa
R
OL
is dependent on a number of factors including
the oscillator frequency, flying capacitor values and
switch resistances.
From Figure 1, we can see that the output current is
proportional to:
(1.5V
IN
– CPO)/R
OL
or (2V
IN
– CPO)/R
OL
in the 1.5x mode or 2x mode respectively.
(2)
Current Levels
The LTC3216 may be programmed to have three discrete
current levels. These are the LOW, HIGH and LOW + HIGH
current levels. The LOW and HIGH currents are set by the
resistors connected between I
SET1
and I
SET2
pins, respec-
tively, to GND. The LOW + HIGH current mode supplies a
current that is equal to sum of the LOW and HIGH currents.
Due to the low output impedance of this part, care should
be taken in selecting current levels. This part can supply up
to 500mA continuously, and up to 1A for pulsed operation
with a 10% duty cycle. Pulsed operation may be achieved
by toggling the EN1 and EN2 bits. In either continuous or
pulsed operation, proper board layout is required for
effective heat sinking.
Mode Switching
The LTC3216 will automatically switch from 1x mode to
1.5x mode, and subsequently from 1.5x mode to 2x mode
whenever a dropout condition is detected at the I
LED
pin.
In the LOW current mode, the part will wait approximately
150ms after dropout is detected before switching to the
next mode. In the HIGH and LOW + HIGH current modes,
the part will wait approximately 2ms before switching to
the next mode. These delays allow the LED to warm up and
reduce its forward voltage which may remove the dropout
condition.
In order to reset the part back into 1x mode, the LTC3216
must be brought into shutdown (EN1 = EN2 = LOW).
Immediately after the part has been brought to shutdown,
it may be set to the desired output current level via the EN1
and EN2 pins. An internal comparator will not allow the
main switches to connect V
IN
and CPO in 1x mode until the
voltage at the CPO pin has decayed to less than or equal to
the voltage at the V
IN
pin.
Figure 1. Charge Pump Open-Loop Thevenin-Equivalent Circuit
OPERATIOU
–
+
+
CPO
R
OL
1.5V
IN
OR
2V
IN
相關PDF資料 |
PDF描述 |
|---|---|
| LT3467A | 1A Low Noise High Current LED Charge Pump with Independent Torch/Flash Current Control |
| LTC3216 | Single Cell 350mA LED Driver |
| LTC3400ES6 | 600mA, 1.2MHz Micropower Synchronous Boost Converter in ThinSOT |
| LTC3400 | 600mA, 1.2MHz Micropower Synchronous Boost Converter in ThinSOT |
| LTC3400B | Quadruple 2-Input Positive-OR Gate 14-TVSOP -40 to 85 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT3467A | 制造商:LINER 制造商全稱:Linear Technology 功能描述:700mA Low Noise High Current LED Charge Pump |
| LT3467AEDDB#PBF | 制造商:Linear Technology 功能描述:SP-SWREG/Monolithic, Cut Tape 1.1A, 2.1MHz Boost Converter |
| LT3467AEDDB#TRMPBF | 功能描述:IC REG BOOST ADJ 1.1A 8DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LT3467AEDDB#TRPBF | 功能描述:IC REG BOOST ADJ 1.1A 8DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LT3467AES6 | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Up 2.2V to 16V 6-Pin TSOT-23 |
發布緊急采購，3分鐘左右您將得到回復。