參數資料
型號： LT1993IUD-2#TRPBF
廠商： Linear Technology
文件頁數： 7/20頁
文件大?。?/td> 0K
描述： IC DIFF AMP/ADC DRVR 16-QFN
標準包裝： 2,500
放大器類型： 差分
電路數： 2
輸出類型： 差分
轉換速率： 1100 V/µs
-3db帶寬： 800MHz
電流 - 輸入偏壓： 5µA
電壓 - 輸入偏移： 1000µV
電流 - 電源： 100mA
電流 - 輸出 / 通道： 45mA
電壓 - 電源，單路/雙路(±)： 4 V ~ 5.5 V，±2 V ~ 2.5 V
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 16-WFQFN 裸露焊盤
供應商設備封裝： 16-QFN-EP（3x3）
包裝： 帶卷 (TR)
LT1993-2
15
19932fa
APPLICATIO S I FOR ATIO
WU
U
Single-Ended to Differential Operation
The LT1993-2’s performance with single-ended inputs is
comparable to its performance with differential inputs.
This excellent single-ended performance is largely due
to the internal topology of the LT1993-2. Referring to
the block diagram, if the +INA and +INB pins are driven
with a single-ended signal (while –INA and –INB are tied
to AC ground), then the +OUT and –OUT pins are driven
differentially without any voltage swing needed from
amplier C. Single-ended to differential conversion using
more conventional topologies suffers from performance
limitations due to the common mode amplier.
Driving ADCs
The LT1993-2 has been specically designed to interface
directly with high speed Analog to Digital Converters
(ADCs). In general, these ADCs have differential inputs,
with an input impedance of 1k or higher. In addition, there
is generally some form of lowpass or bandpass ltering just
prior to the ADC to limit input noise at the ADC, thereby
improving system signal to noise ratio. Both the unltered
and ltered outputs of the LT1993-2 can easily drive the
high impedance inputs of these differential ADCs. If the
ltered outputs are used, then cutoff frequency and the
type of lter can be tailored for the specic application if
needed.
Wideband Applications
(Using the +OUT and –OUT Pins)
In applications where the full bandwidth of the LT1993-2
is desired, the unltered output pins (+OUT and –OUT)
should be used. They have a low output impedance;
therefore, gain is unaffected by output load. Capacitance
in excess of 5pF placed directly on the unltered outputs
results in additional peaking and reduced performance.
When driving an ADC directly, a small series resistance
is recommended between the LT1993-2’s outputs and
the ADC inputs (Figure 5). This resistance helps eliminate
any resonances associated with bond wire inductances of
either the ADC inputs or the LT1993-2’s outputs. A value
between 10
Ω and 25Ω gives excellent results.
Figure 3. Alternate Input Termination for Differential
50
Ω Input Impedance
Figure 4. Input Termination for Differential 50
Ω Input Impedance
with 6dB Additional Gain
19932 F02
IF IN–
IF IN+
LT1993-2
–INA
–INB
–OUT
+OUT
8
5
+INB
+INA
14
13
15
ZIN = 50
DIFFERENTIAL
16
67
19932 F04
0.1
F
LT1993-2
–INA
–INB
–OUT
+OUT
8
5
+INB
+INA
14
13
15
ZIN = 50
DIFFERENTIAL
1:4 TRANSFORMER
(MINI-CIRCUITS TCM4-19)
16
19932 F05
LT1993-2
–OUT
+OUT
8
5
10
TO 25
10
TO 25
ADC
Figure 5. Adding Small Series R at LT1993-2 Output
Filtered Applications
(Using the +OUTFILTERED and –OUTFILTERED Pins)
Filtering at the output of the LT1993-2 is often desired to
provide either anti-aliasing or improved signal to noise
ratio. To simplify this ltering, the LT1993-2 includes an
additional pair of differential outputs (+OUTFILTERED
and –OUTFILTERED) which incorporate an internal low-
pass lter network with a –3dB bandwidth of 175MHz
(Figure 6). These pins each have an output impedance
of 25
Ω. Internal capacitances are 12pF to VEE on each
ltered output, plus an additional 12pF capacitor con-
nected differentially between the two ltered outputs. This
resistor/capacitor combination creates ltered outputs
相關PDF資料
PDF描述
1.5KE12AHE3/73 TVS UNIDIR 1.5KW 12V 5% 1.5KE
1.5KE120AHE3/73 TVS UNIDIR 1.5KW 120V 5% 1.5KE
1.5KE11AHE3/73 TVS UNIDIR 1.5KW 11V 5% 1.5KE
9-146308-0-32 CONN HEADR BRKWAY .100 64POS R/A
1.5KE110AHE3/73 TVS UNIDIR 1.5KW 110V 5% 1.5KE
相關代理商/技術參數
參數描述
LT1993IUD-4 制造商:Linear Technology 功能描述:SC-Amps/High Speed, 900MHz Low Noise/Distortion Differential Amplifer 制造商:Linear Technology 功能描述:IC,Differential Amplifier,SINGLE,LLCC,16PIN,PLASTIC , RoHS Compliant: No
LT1993IUD-4#PBF 功能描述:IC DIFF AMP/ADC DRVR 16-QFN RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.028 V/µs 增益帶寬積:105kHz -3db帶寬:- 電流 - 輸入偏壓:3nA 電壓 - 輸入偏移:100µV 電流 - 電源:3.3µA 電流 - 輸出 / 通道:12mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 12 V，±1.35 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:剪切帶 (CT) 其它名稱:OP481GRUZ-REELCT
LT1993IUD-4#TRPBF 功能描述:IC DIFF AMP/ADC DRVR 16-QFN RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:1 輸出類型:滿擺幅 轉換速率:0.11 V/µs 增益帶寬積:350kHz -3db帶寬:- 電流 - 輸入偏壓:4nA 電壓 - 輸入偏移:20µV 電流 - 電源:260µA 電流 - 輸出 / 通道:20mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 36 V，±1.35 V ~ 18 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SO 包裝:帶卷 (TR)
LT1994 制造商:LINER 制造商全稱:Linear Technology 功能描述:Precision, Low Power Rail-to-Rail Input/Output
LT1994CDD 制造商:Linear Technology 功能描述:SC-Amps/High Speed, 70MHz Low Noise/Distortion Differential Amplifer
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*