參數資料
型號： LT1993
廠商： Linear Technology Corporation
英文描述： 14-Bit, 125/105Msps Low Power 3V ADCs
中文描述： 14位，125/105Msps低功耗3V的模數轉換器
文件頁數： 14/24頁
文件大小： 608K
代理商： LT1993
LTC2255/LTC2254
14
22554f
Input Drive Impedance
As with all high performance, high speed ADCs, the
dynamic performance of the LTC2255/LTC2254 can be
influenced by the input drive circuitry, particularly the
second and third harmonics. Source impedance and reac-
tance can influence SFDR. At the falling edge of CLK, the
sample-and-hold circuit will connect the 3.5pF sampling
capacitor to the input pin and start the sampling period.
The sampling period ends when CLK rises, holding the
sampled input on the sampling capacitor. Ideally the input
circuitry should be fast enough to fully charge
the sampling capacitor during the sampling period
1/(2F
ENCODE
); however, this is not always possible and the
incomplete settling may degrade the SFDR. The sampling
glitch has been designed to be as linear as possible to
minimize the effects of incomplete settling.
For the best performance, it is recommended to have a
source impedance of 100
or less for each input. The
source impedance should be matched for the differential
inputs. Poor matching will result in higher even order
harmonics, especially the second.
Input Drive Circuits
Figure 3 shows the LTC2255/LTC2254 being driven by an
RF transformer with a center tapped secondary. The
secondary center tap is DC biased with V
CM
, setting the
ADC input signal at its optimum DC level. Terminating on
the transformer secondary is desirable, as this provides a
common mode path for charging glitches caused by the
sample and hold. Figure 3 shows a 1:1 turns ratio trans-
former. Other turns ratios can be used if the source
impedance seen by the ADC does not exceed 100
for
each ADC input. A disadvantage of using a transformer is
the loss of low frequency response. Most small RF trans-
formers have poor performance at frequencies below
1MHz.
Figure 4 demonstrates the use of a differential amplifier to
convert a single ended input signal into a differential input
signal. The advantage of this method is that it provides low
frequency input response; however, the limited gain band-
width of most op amps will limit the SFDR at high input
frequencies.
APPLICATIOU
W
U
U
Figure 5. Single-Ended Drive
Figure 5 shows a single-ended input circuit. The imped-
ance seen by the analog inputs should be matched. This
circuit is not recommended if low distortion is required.
The 25
resistors and 12pF capacitor on the analog inputs
serve two purposes: isolating the drive circuitry from the
sample-and-hold charging glitches and limiting the
wideband noise at the converter input.
Figure 3. Single-Ended to Differential Conversion
Using a Transformer
Figure 4. Differential Drive with an Amplifier
25
25
25
25
0.1
μ
F
A
IN+
A
IN–
12pF
2.2
μ
F
V
CM
LTC2255/
LTC2254
ANALOG
INPUT
0.1
μ
F
T1
1:1
T1 = MA/COM ETC1-1T
RESISTORS, CAPACITORS
ARE 0402 PACKAGE SIZE
22554 F03
25
25
12pF
2.2
μ
F
V
CM
LTC2255/
LTC2254
22554 F04
–
–
+
+
CM
ANALOG
INPUT
HIGH SPEED
DIFFERENTIAL
AMPLIFIER
A
IN+
A
IN–
25
0.1
μ
F
ANALOG
INPUT
V
CM
A
IN
+
A
IN
–
1k
12pF
224876 F05
2.2
μ
F
1k
25
0.1
μ
F
LTC2255/
LTC2254
相關PDF資料
PDF描述
LTC2254IUH 14-Bit, 125/105Msps Low Power 3V ADCs
LTC2255CUH 14-Bit, 125/105Msps Low Power 3V ADCs
LTC2252 14-Bit, 125/105Msps Low Power 3V ADCs
LTC1747 14-Bit, 125/105Msps Low Power 3V ADCs
LTC1749 14-Bit, 125/105Msps Low Power 3V ADCs
相關代理商/技術參數
參數描述
LT1993-10 制造商:LINER 制造商全稱:Linear Technology 功能描述:1.3GHz Low Noise, Low Distortion Differential ADC Driver for 140MHz IF
LT1993-2 制造商:LINER 制造商全稱:Linear Technology 功能描述:1.3GHz Low Noise, Low Distortion Differential ADC Driver for 140MHz IF
LT1993-4 制造商:LINER 制造商全稱:Linear Technology 功能描述:1.3GHz Low Noise, Low Distortion Differential ADC Driver for 140MHz IF
LT1993CUD-10 制造商:Linear Technology 功能描述:SP Amp DIFF AMP Single 5.5V 16-Pin QFN EP 制造商:Linear Technology 功能描述:DIFF-AMPLIFIER, 700MHZ, 1.1KV/US, QFN-16, No. of Amplifiers:2, Input Offset Voltage:1mV, Gain dB Max:20.9dB, Bandwidth:700MHz, Amplifier Case Style:QFN, No. of Pins:16, Supply Voltage Range:4V to 5.5V, Slew Rate:1.1kV/s, MSL:- 制造商:Linear Technology 功能描述:OP-AMP, 10000 uV OFFSET-MAX, PQCC16
LT1993CUD-10#PBF 功能描述:IC DIFF AMP/ADC DRVR 16-QFN RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:4 輸出類型:- 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:45nA 電壓 - 輸入偏移:2000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:40mA 電壓 - 電源，單路/雙路(±):3 V ~ 32 V，±1.5 V ~ 16 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:帶卷 (TR) 其它名稱:LM324ADTBR2G-NDLM324ADTBR2GOSTR
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*