- 您現在的位置：買賣IC網 > PDF目錄377719 > LT1963-1.8 (Linear Technology Corporation) 1.5A, Low Noise, Fast Transient Response LDO Regulators(1.8V輸出,1.5A,低噪聲,快速瞬變響應,低壓差輸出穩壓器) PDF資料下載
參數資料
| 型號： | LT1963-1.8 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | 1.5A, Low Noise, Fast Transient Response LDO Regulators(1.8V輸出,1.5A,低噪聲,快速瞬變響應,低壓差輸出穩壓器) |
| 中文描述： | 1.5A的，低噪聲，快速瞬態響應LDO穩壓器（1.8V的輸出，1.5安培的電流，低噪聲，快速瞬變響應，低壓差輸出穩壓器） |
| 文件頁數： | 11/16頁 |
| 文件大?。?/td> | 222K |
| 代理商： | LT1963-1.8 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁
11
LT1963 Series
Figure 4. Ceramic Capacitor Temperature Characteristics
APPLICATIOU
W
U
U
TEMPERATURE (
°
C)
–50
40
20
0
–20
–40
–60
–80
–100
25
75
1963 F04
–25
0
50
100
125
Y5V
C
X5R
BOTH CAPACITORS ARE 16V,
1210 CASE SIZE, 10
μ
F
an effective value as low as 1
μ
F to 2
μ
F over the operating
temperature range. The X5R and X7R dielectrics result in
more stable characteristics and are more suitable for use
as the output capacitor. The X7R type has better stability
across temperature, while the X5R is less expensive and
is available in higher values.
Voltage and temperature coefficients are not the only
sources of problems. Some ceramic capacitors have a
piezoelectric response. A piezoelectric device generates
voltage across its terminals due to mechanical stress,
similar to the way a piezoelectric accelerometer or micro-
phone works. For a ceramic capacitor the stress can be
induced by vibrations in the system or thermal transients.
Overload Recovery
Like many IC power regulators, the LT1963-X has safe
operating area protection. The safe area protection de-
creases the current limit as input-to-output voltage in-
creases and keeps the power transistor inside a safe
operating region for all values of input-to-output voltage.
The protection is designed to provide some output current
at all values of input-to-output voltage up to the device
breakdown.
When power is first turned on, as the input voltage rises,
the output follows the input, allowing the regulator to start
up into very heavy loads. During the start-up, as the input
voltage is rising, the input-to-output voltage differential is
small, allowing the regulator to supply large output
currents. With a high input voltage, a problem can occur
wherein removal of an output short will not allow the
output voltage to recover. Other regulators, such as the
LT1085, also exhibit this phenomenon, so it is not unique
to the LT1963-X.
The problem occurs with a heavy output load when the
input voltage is high and the output voltage is low. Com-
mon situations are immediately after the removal of a
short-circuit or when the shutdown pin is pulled high after
the input voltage has already been turned on. The load line
for such a load may intersect the output current curve at
two points. If this happens, there are two stable output
operating points for the regulator. With this double inter-
section, the input power supply may need to be cycled
down to zero and brought up again to make the output
recover.
Output Voltage Noise
The LT1963 regulators have been designed to provide low
output voltage noise over the 10Hz to 100kHz bandwidth
while operating at full load. Output voltage noise is typi-
cally 40nV/
√
Hz over this frequency bandwidth for the
LT1963 (adjustable version). For higher output voltages
(generated by using a resistor divider), the output voltage
noise will be gained up accordingly. This results in RMS
noise over the 10Hz to 100kHz bandwidth of 14
μ
V
RMS
for
the LT1963 increasing to 38
μ
V
RMS
for the LT1963-3.3.
Higher values of output voltage noise may be measured
when care is not exercised with regards to circuit layout
and testing. Crosstalk from nearby traces can induce
unwanted noise onto the output of the LT1963-X. Power
supply ripple rejection must also be considered; the LT1963
regulators do not have unlimited power supply rejection
and will pass a small portion of the input noise through to
the output.
Thermal Considerations
The power handling capability of the device is limited by the
maximum rated junction temperature (125
°
C). The power
dissipated by the device is made up of two components:
1. Output current multiplied by the input/output voltage
differential: (I
OUT
)(V
IN
– V
OUT
), and
相關PDF資料 |
PDF描述 |
|---|---|
| LT1963-3 | 1.5A, Low Noise, Fast Transient Response LDO Regulators(13V輸出,1.5A,低噪聲,快速瞬變響應,低壓差輸出穩壓器) |
| LT1963-3.3 | 1.5A, Low Noise, Fast Transient Response LDO Regulators(3.3V輸出,1.5A,低噪聲,快速瞬變響應,低壓差輸出穩壓器) |
| LT1965 | 1.1A, Low Noise, Low Dropout Linear Regulator |
| LT1965IMS8EPBF | 1.1A, Low Noise, Low Dropout Linear Regulator |
| LT1965IMS8ETRPBF | 1.1A, Low Noise, Low Dropout Linear Regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1963A | 制造商:LINER 制造商全稱:Linear Technology 功能描述:1.1A, Low Noise, Low Dropout Linear Regulator |
| LT1963A_1208 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:1.5A Low Noise Fast Transient Response LDO Regulators |
| LT1963A-1.5 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:1.5A, Low Noise, Fast Transient Response LDO Regulators |
| LT1963A-1.8 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:1.5A, Low Noise, Fast Transient Response LDO Regulators |
| LT1963A-2.5 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:1.5A, Low Noise, Fast Transient Response LDO Regulators |
發布緊急采購，3分鐘左右您將得到回復。