參數資料
型號: LT1840-7Z
廠商: POWER-ONE INC
元件分類: 電源模塊
英文描述: 1-OUTPUT 500 W AC-DC REG PWR SUPPLY MODULE
文件頁數: 1/32頁
文件大?。?/td> 1000K
代理商: LT1840-7Z
BCD20023 Rev. AA, 3-Sep-2008
Page 1 of 32
www.power-one.com
T Series Data Sheet
500 Watt AC-DC Converters
Table of Contents
Page
Features
168
6.6"
141
5.6"
28 TE
111
4.4"
3 U
Universal AC input range 70 to 255 VAC with PFC
Class I equipment
DC output for 24 and 48 V loads
Battery charging for 24 and 48 V batteries with remote
temperature control
4 kVAC I/O electric strength test voltage
Telecom rectifier applications
Immune to transients and disturbances according to
VDE 160 and IEC/EN 61000-4-2,-3,-4,-5,-6
Very high efficiency, typically 93%
Power factor >0.96, harmonics according to IEC/EN
61000-3-2, low RFI
No inrush current, hot swap capability
High power density, rugged mechanical design, all
boards covered with a protective lacquer
Very compact 19" cassette (28 TE, 3 U, 160 mm)
Safety according to IEC/EN 60950 and UL 60950-1
Description
The T Series converters are electrically isolated AC-DC
converters with an output power of up to 550 watts. For higher
power requirements several converters may be connected in
parallel.
The input is ideally adapted to the mains: Full power factor
correction, no inrush current, low RFI level, and high transient
and surge immunity are key design features. A T Series
converter behaves similar to a resistive load.
The LT models can be operated from a universal AC-input
range from 85 to 255 VAC. It is the preferred type for 230 VAC
mains, whereas the UT models are optimized for 110/
120 VAC mains. The output delivers an electrically isolated
Safety Extra Low Voltage (SELV) and is short-circuit and no-
load proof. Depending on the type, two output characteristics
are available, intended either for rectifier applications or for
battery charging purposes.
The latter types can be integrated into systems, where the
output voltage is backed-up by a battery. The float charge of the
battery can be set by a cell-voltage selector switch according to
the battery type used. These converters are equipped with a
temperature sensor input, in order to improve the life
expectancy of the battery.
The rectifier models are suited for DC-bus applications at
constant voltage. As the output voltage is SELV, even
electrically non-isolated switching regulators, such as the PSx
models, may be connected to the output.
The LT/UT1701 models are especially optimized to build
distributed power systems together with the 48Q or CQ Series
DC-DC converters, as the signalling capabilities of both families
are matched. Distributed power systems have as one
advantage less power losses over load lines and fewer
regulation problems.
Power-One also offers backplanes for fast and simple set-up
of 19" DIN-rack systems with T Series converters; see
Accessories.
相關PDF資料
PDF描述
LT1740-7Z 1-OUTPUT 500 W AC-DC REG PWR SUPPLY MODULE
LT1241MJ8 1 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, CDIP8
LT1245MJ8 1 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, CDIP8
LT1241CJ8 1 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, CDIP8
LT1242CJ8 1 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, CDIP8
相關代理商/技術參數
參數描述
LT1846 制造商:LINER 制造商全稱:Linear Technology 功能描述:Current Mode PWM Controller
LT1846J 制造商:LINER 制造商全稱:Linear Technology 功能描述:Current Mode PWM Controller
LT1847 制造商:LINER 制造商全稱:Linear Technology 功能描述:Current Mode PWM Controller
LT1847J 制造商:LINER 制造商全稱:Linear Technology 功能描述:Current Mode PWM Controller
LT185-AC 制造商:ABB Low Voltage Products and Systems 功能描述:TERMINAL SHROUD,A145-A185