參數資料
型號: LT1783IS5#TRM
廠商: Linear Technology
文件頁數: 3/16頁
文件大小: 0K
描述: IC OPAMP R-R IN/OUT TSOT-23-5
標準包裝: 1
系列: Over-The-Top®
放大器類型: 通用
電路數: 1
輸出類型: 滿擺幅
轉換速率: 0.45 V/µs
增益帶寬積: 1.3MHz
電流 - 輸入偏壓: 40nA
電壓 - 輸入偏移: 500µV
電流 - 電源: 230µA
電流 - 輸出 / 通道: 30mA
電壓 - 電源,單路/雙路(±): 2.5 V ~ 18 V,±1.25 V ~ 9 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: SOT-23-5 細型,TSOT-23-5
供應商設備封裝: TSOT-23-5
包裝: 剪切帶 (CT)
其它名稱: LT1783IS5
LT1783IS5#TRMCT
LT1783IS5-ND
LT1783
11
1783fd
APPLICATIONS INFORMATION
Supply Voltage
The positive supply pin of the LT1783 should be bypassed
with a small capacitor (typically 0.1μF) within an inch of
the pin. When driving heavy loads, an additional 4.7μF
electrolytic capacitor should be used. When using split
supplies, the same is true for the negative supply pin.
The LT1783 is protected against reverse-battery voltages
up to 18V. In the event a reverse-battery condition occurs,
the supply current is less than 1nA.
Inputs
The LT1783 has two input stages, NPN and PNP (see the
Simplied Schematic), resulting in three distinct operating
regions as shown in the Input Bias Current vs Common
Mode typical performance curve.
For input voltages about 0.8V or more below V+, the PNP
input stage is active and the input bias current is typically
–40nA. When the input common mode voltage is within
0.5V of the positive rail, the NPN stage is operating and
the input bias current is typically 80nA. Increases in tem-
perature will cause the voltage at which operation switches
from the PNP input stage to the NPN input stage to move
towards V+. The input offset voltage of the NPN stage is
untrimmed and is typically 1.8mV.
A Schottky diode in the collector of the input transistors,
along with special geometries for these NPN transistors,
allow the LT1783 to operate with either or both of its inputs
above V+. At about 0.3V above V+, the NPN input transistor
is fully saturated and the input bias current is typically 30μA
at room temperature. The input offset voltage is typically
1.8mV when operating above V+. The LT1783 will operate
with its inputs 18V above Vregardless of V+.
The inputs are protected against excursions as much as
10V below Vby an internal 1k resistor in series with each
input and a diode from the input to the negative supply.
The input stage of the LT1783 incorporates phase reversal
protection to prevent the output from phase reversing for
inputs up to 9V below V. There are no clamping diodes
between the inputs and the maximum differential input
voltage is 18V.
Output
The output of the LT1783 can swing to within 60mV of the
positive rail with no load and within 3mV of the negative
rail with no load. When monitoring input voltages within
60mV of the positive rail or within 3mV of the negative rail,
gain should be taken to keep the output from clipping. The
LT1783 can sink and source over 30mA at ±5V supplies,
sourcing current is reduced to 10mA at 3V total supplies
as noted in the Electrical Characteristics.
The LT1783 is internally compensated to drive at least
400pF of capacitance under any output loading condi-
tions. A 0.22μF capacitor in series with a 150Ω resistor
between the output and ground will compensate these
ampliers for larger capacitive loads, up to 10,000pF, at
all output currents.
Distortion
There are two main contributors to distortion in op amps:
output crossover distortion as the output transitions from
sourcing to sinking current, and distortion caused by non-
linear common mode rejection. If the op amp is operating
inverting, there is no common mode induced distortion.
If the op amp is operating in the PNP input stage (input is
not within 0.8V of V+), the CMRR is very good, typically
100dB. When the LT1783 switches between input stages,
there is signicant nonlinearity in the CMRR. Lower load
resistance increases the output crossover distortion but
has no effect on the input stage transition distortion. For
lowest distortion, the LT1783 should be operated single
supply, with the output always sourcing current and with
the input voltage swing between ground and (V+ – 0.8V).
See the Typical Performance Characteristics curves,
“Total Harmonic Distortion + Noise vs Output Voltage
Amplitude.”
相關PDF資料
PDF描述
534237-3 CONN RECEPT 5POS .100 VERT AU
ADA4851-4WYRUZ-R7 IC OPAMP QUAD R-R HS 14-TSSOP
KTR10EZPJ106 RES 10M OHM 1/8W 5% 0805 SMD
MMA25-020 CONN RACK/PANEL 20POS 5A
5-534206-4 CONN RECEPT 8POS .100 VERT DUAL
相關代理商/技術參數
參數描述
LT1783IS5-TRMPBF 制造商:LINEAR_DIMENSIONS 制造商全稱:LINEAR_DIMENSIONS 功能描述:1.25MHz, Over-The-Top Micropower, Rail-to-Rail Input and Output Op Amp in SOT-23
LT1783IS6 制造商:Linear Technology 功能描述:OP Amp Single GP R-R I/O ±9V/18V 6-Pin TSOT-23
LT1783IS6#PBF 制造商:Linear Technology 功能描述:SC-Amps/Industrial, Cut Tape SOT-23 uP Op Amp w/ Shutdown
LT1783IS6#TR 功能描述:IC OPAMP R-R IN/OUT SOT23-6 RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:Over-The-Top® 標準包裝:1,000 系列:- 放大器類型:電壓反饋 電路數:4 輸出類型:滿擺幅 轉換速率:33 V/µs 增益帶寬積:20MHz -3db帶寬:30MHz 電流 - 輸入偏壓:2nA 電壓 - 輸入偏移:3000µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:30mA 電壓 - 電源,單路/雙路(±):4.5 V ~ 16.5 V,±2.25 V ~ 8.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC(0.154",3.90mm 寬) 供應商設備封裝:14-SOIC 包裝:帶卷 (TR)
LT1783IS6#TRM 功能描述:IC OPAMP R-R IN/OUT SOT23-6 RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:Over-The-Top® 標準包裝:1,000 系列:- 放大器類型:電壓反饋 電路數:4 輸出類型:滿擺幅 轉換速率:33 V/µs 增益帶寬積:20MHz -3db帶寬:30MHz 電流 - 輸入偏壓:2nA 電壓 - 輸入偏移:3000µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:30mA 電壓 - 電源,單路/雙路(±):4.5 V ~ 16.5 V,±2.25 V ~ 8.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC(0.154",3.90mm 寬) 供應商設備封裝:14-SOIC 包裝:帶卷 (TR)