參數資料
型號: LT1762-5
廠商: Linear Technology Corporation
英文描述: 150mA, Low Noise, LDO Micropower Regulators(5V輸出,150mA,低噪聲,低壓差穩壓器)
中文描述: 150mA的,低噪聲,LDO的微功耗穩壓器(5V的輸出,為150mA,低噪聲,低壓差穩壓器)
文件頁數: 13/16頁
文件大?。?/td> 229K
代理商: LT1762-5
13
LT1762 Series
APPLICATIO
S I
N
FOR
ATIO
U
across temperature, while the X5R is less expensive and
is available in higher values.
Voltage and temperature coefficients are not the only
sources of problems. Some ceramic capacitors have a
piezoelectric response. A piezoelectric device generates
voltage across its terminals due to mechanical stress,
similar to the way a piezoelectric accelerometer or micro-
phone works. For a ceramic capacitor the stress can be
induced by vibrations in the system or thermal transients.
The resulting voltages produced can cause appreciable
amounts of noise, especially when a ceramic capacitor is
used for noise bypassing. A ceramic capacitor produced
Figure 6’s trace in response to light tapping from a pencil.
Similar vibration induced behavior can masquerade as
increased output voltage noise.
W
U
The GND pin current can be found by examining the GND
Pin Current curves in the Typical Performance Character-
istics. Power dissipation will be equal to the sum of the two
components listed above.
The LT1762 series regulators have internal thermal limit-
ing designed to protect the device during overload condi-
tions. For continuous normal conditions, the maximum
junction temperature rating of 125
°
C must not be
exceeded. It is important to give careful consideration to
all sources of thermal resistance from junction to ambient.
Additional heat sources mounted nearby must also be
considered.
For surface mount devices, heat sinking is accomplished
by using the heat spreading capabilities of the PC board
and its copper traces. Copper board stiffeners and plated
through-holes can also be used to spread the heat gener-
ated by power devices.
The following table lists thermal resistance for several
different board sizes and copper areas. All measurements
were taken in still air on 3/32" FR-4 board with one ounce
copper.
Table 1. Measured Thermal Resistance
COPPER AREA
TOPSIDE*
BACKSIDE
2500mm
2
2500mm
2
1000mm
2
2500mm
2
225mm
2
2500mm
2
100mm
2
2500mm
2
50mm
2
2500mm
2
THERMAL RESISTANCE
(JUNCTION-TO-AMBIENT)
110
°
C/W
115
°
C/W
120
°
C/W
130
°
C/W
140
°
C/W
BOARD AREA
2500mm
2
2500mm
2
2500mm
2
2500mm
2
2500mm
2
*Device is mounted on topside.
Calculating Junction Temperature
Example: Given an output voltage of 3.3V, an input voltage
range of 4V to 6V, an output current range of 0mA to 50mA
and a maximum ambient temperature of 50
°
C, what will
the maximum junction temperature be
The power dissipated by the device will be equal to:
I
OUT(MAX)
(V
IN(MAX)
– V
OUT
) + I
GND
(V
IN(MAX)
)
Figure 6. Noise Resulting from Tapping on a Ceramic Capacitor
LT1762-5
C
OUT
= 10
μ
F
C
BYP
= 0.01
μ
f
I
LOAD
= 100mA
V
500
μ
V/DIV
100ms/DIV
1762 F05
Thermal Considerations
The power handling capability of the device will be limited
by the maximum rated junction temperature (125
°
C). The
power dissipated by the device will be made up of two
components:
1. Output current multiplied by the input/output voltage
differential: (I
OUT
)(V
IN
– V
OUT
), and
2. GND pin current multiplied by the input voltage:
(I
GND
)(V
IN
).
相關PDF資料
PDF描述
LT1763-1.5 500mA, Low Noise, LDO Micropower Regulators(1.5V輸出,5000mA,低噪聲,低壓差穩壓器)
LT1763-1.8 500mA, Low Noise, LDO Micropower Regulators(1.8V輸出,5000mA,低噪聲,低壓差穩壓器)
LT1763-2.5 500mA, Low Noise, LDO Micropower Regulators(2.5V輸出,5000mA,低噪聲,低壓差穩壓器)
LT1763-3 500mA, Low Noise, LDO Micropower Regulators(3V輸出,5000mA,低噪聲,低壓差穩壓器)
LT1763-3.3 500mA, Low Noise, LDO Micropower Regulators(3.3V輸出,5000mA,低噪聲,低壓差穩壓器)
相關代理商/技術參數
參數描述
LT1762EMS8 功能描述:IC REG LDO ADJ .15A 8-MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:1 系列:- 穩壓器拓?fù)浣Y(jié)構:正,固定式 輸出電壓:3.3V 輸入電壓:2.5 V ~ 5.5 V 電壓 - 壓降(標準):0.1V @ 200mA 穩壓器數量:2 電流 - 輸出:300mA 電流 - 限制(最?。?350mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-UFQFN 供應商設備封裝:8-MLPQ-UT(1.5x1.5) 包裝:剪切帶 (CT) 產品目錄頁面:1358 (CN2011-ZH PDF) 其它名稱:SC560HULCT
LT1762EMS8#PBF 功能描述:IC REG LDO ADJ .15A 8-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 產品培訓模塊:MIC5365/66 Ultra-small LDO Regulators 標準包裝:1 系列:- 穩壓器拓?fù)浣Y(jié)構:正,固定式 輸出電壓:3V 輸入電壓:最高 5.5V 電壓 - 壓降(標準):0.155V @ 150mA 穩壓器數量:1 電流 - 輸出:150mA 電流 - 限制(最小):200mA 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:4-UDFN 裸露焊盤,4-TMLF? 供應商設備封裝:4-TMLF?(1x1) 包裝:Digi-Reel® 其它名稱:576-3192-6
LT1762EMS8#TR 功能描述:IC REG LDO ADJ .15A 8MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:1 系列:- 穩壓器拓?fù)浣Y(jié)構:正,固定式 輸出電壓:3.3V 輸入電壓:2.5 V ~ 5.5 V 電壓 - 壓降(標準):0.1V @ 200mA 穩壓器數量:2 電流 - 輸出:300mA 電流 - 限制(最?。?350mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-UFQFN 供應商設備封裝:8-MLPQ-UT(1.5x1.5) 包裝:剪切帶 (CT) 產品目錄頁面:1358 (CN2011-ZH PDF) 其它名稱:SC560HULCT
LT1762EMS8#TRPBF 功能描述:IC REG LDO ADJ .15A 8-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:1 系列:- 穩壓器拓?fù)浣Y(jié)構:正,固定式 輸出電壓:3.3V 輸入電壓:2.5 V ~ 5.5 V 電壓 - 壓降(標準):0.1V @ 200mA 穩壓器數量:2 電流 - 輸出:300mA 電流 - 限制(最小):350mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-UFQFN 供應商設備封裝:8-MLPQ-UT(1.5x1.5) 包裝:剪切帶 (CT) 產品目錄頁面:1358 (CN2011-ZH PDF) 其它名稱:SC560HULCT
LT1762EMS8-2.5 功能描述:IC REG LDO 2.5V .15A 8MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:1 系列:- 穩壓器拓?fù)浣Y(jié)構:正,固定式 輸出電壓:3.3V 輸入電壓:2.5 V ~ 5.5 V 電壓 - 壓降(標準):0.1V @ 200mA 穩壓器數量:2 電流 - 輸出:300mA 電流 - 限制(最小):350mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-UFQFN 供應商設備封裝:8-MLPQ-UT(1.5x1.5) 包裝:剪切帶 (CT) 產品目錄頁面:1358 (CN2011-ZH PDF) 其它名稱:SC560HULCT