- 您現在的位置：買賣IC網 > PDF目錄377774 > LT1616 (Linear Technology Corporation) Dual DC/DC Converter with USB Power Manager and Li-Ion Battery Charger PDF資料下載
參數資料
| 型號： | LT1616 |
| 廠商： | Linear Technology Corporation |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | Dual DC/DC Converter with USB Power Manager and Li-Ion Battery Charger |
| 中文描述： | 雙DC / DC轉換器的USB電源管理器和鋰離子電池充電器 |
| 文件頁數： | 18/24頁 |
| 文件大小： | 516K |
| 代理商： | LT1616 |
LTC3455
18
3455f
APPLICATIU
W
U
U
Figure 8. Burst Mode and PWM Mode Waveforms
Soft-Start for each Switcher
Soft-start is accomplished by gradually increasing the
peak inductor current for each switcher. This allows each
output to rise slowly, helping minimize the battery in-rush
current. Figure 9 shows the battery current during startup.
A soft-start cycle occurs whenever each switcher first
turns on, or after a fault condition has occurred (thermal
shutdown or UVLO).
Figure 9. In-Rush Current at Startup
In-Rush Current Limiting
When the LTC3455 is battery-powered, an internal 0.15
PMOS switch connects the battery (V
BAT
pin) to the V
MAX
pin to provide power for both switchers and other internal
circuitry. This PMOS switch is turned off in shutdown, and
the V
MAX
pin discharges to ground, providing output
disconnect for all outputs. At startup, this PMOS must first
charge up any capacitance present on the V
MAX
pin to the
battery voltage. To minimize the in-rush current needed
from the battery, the PMOS switch is current-limited to
900mA and both switchers are disabled while the V
MAX
voltage is ramping up. Once V
MAX
reaches the battery
voltage, the PMOS current-limit increases to 4A and both
switchers are allowed to turn on. Figure 9 shows the
startup battery current for the LTC3455, which stays well-
controlled while V
MAX
is ramping up and while both
switchers outputs are rising.
Battery Charger General Information
The battery charger and Switcher 1 will always be enabled
whenever USB or wall power is present (as sensed by the
USB and WALLFB pins). This ensures that the battery can
be charged and that the microcontroller is alive whenever
external power is available. For some applications, it may
be undesirable for the charger to become active immedi-
ately when external power is applied. For such applica-
tions, an NMOS switch can be used to disconnect the
R
PROG
resistor and allow the PROG pin to float high,
turning off the charger. In this manner, charging occurs
only when allowed by the microcontroller.
The LTC3455 battery charger is a constant-current, con-
stant-voltage charger. In constant-current mode, the maxi-
mum charge current is set by a single external resistor.
When the battery approaches the final float voltage, the
charge current begins to decrease as the charger switches
to constant-voltage mode. The charge cycle is terminated
only by the charge timer.
V
2V/DIV
V
OUT1
(1.8V)
2V/DIV
V
OUT2
(3.3V)
2V/DIV
100
μ
s/DIV
3455 F09
I
500mA/DIV
V
2V/DIV
1
μ
s/DIV
3455 F08b
V
10mV/DIV
AC COUPLED
I
L1
100mA/DIV
V
2V/DIV
V
50mV/DIV
AC COUPLED
5
μ
s/DIV
3455 F08a
I
L1
100mA/DIV
PWM Mode
Burst Mode
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3406A | Standalone Linear Li-lon Battery Charger with Thermistor Input |
| LTC3406B | Dual DC/DC Converter with USB Power Manager and Li-Ion Battery Charger |
| LTC3406ES5 | 1.5MHz, 600mA Synchronous Step-Down Regulator in ThinSOT |
| LTC3407 | Dual DC/DC Converter with USB Power Manager and Li-Ion Battery Charger |
| LTC3412 | Dual DC/DC Converter with USB Power Manager and Li-Ion Battery Charger |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1616ES6 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC |
| LT1616ES6#PBF | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 3.6V to 25V 6-Pin TSOT-23 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 3.6V to 25V 6-Pin TSOT-23 Bulk 制造商:Linear Technology 功能描述:IC, DC-DC CONV; Primary Input Voltage:25V; No. of Outputs:1; Output Voltage:3.3V; Output Current:400mA; No. of Pins:6; Operating Temperature Min:-40C; Operating Temperature Max:85C; MSL:MSL 1 - Unlimited ;RoHS Compliant: Yes |
| LT1616ES6#TR | 功能描述:IC REG BUCK 3.3V/5V 0.6A SOT23-6 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LT1616ES6#TRM | 功能描述:IC REG BUCK 3.3V/5V 0.6A SOT23-6 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LT1616ES6#TRMPBF | 功能描述:IC REG BUCK 3.3V/5V 0.6A SOT23-6 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
發布緊急采購，3分鐘左右您將得到回復。