- 您現在的位置：買賣IC網 > PDF目錄5857 > LT1497CS#TR (Linear Technology)IC OPAMP CFA DUAL 50MHZ 16SOIC PDF資料下載
參數資料
| 型號： | LT1497CS#TR |
| 廠商： | Linear Technology |
| 文件頁數： | 2/12頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP CFA DUAL 50MHZ 16SOIC |
| 標準包裝： | 2,500 |
| 放大器類型： | 電流反饋 |
| 電路數： | 2 |
| 轉換速率： | 900 V/µs |
| -3db帶寬： | 50MHz |
| 電流 - 輸入偏壓： | 7µA |
| 電壓 - 輸入偏移： | 3000µV |
| 電流 - 電源： | 7mA |
| 電流 - 輸出 / 通道： | 220mA |
| 電壓 - 電源，單路/雙路(±)： | 4 V ~ 30 V，±2 V ~ 15 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 16-SO |
| 包裝： | 帶卷 (TR) |
10
LT1497
the normally active emitter of Q2 will turn off as the entire
current available from the current source is used to slew
the base of Q3. The base of Q4 is driven by Q1 without slew
limitation. When the differential input voltage exceeds two
diode drops (about 1.4V) the extra clamp emitter on Q1
turns on and drives the base of Q3 directly. Once the base
of Q3 has been driven within 1.4V of its final value, the
clamp emitter of Q1 turns off and the node must finish
slewing using the current source.
This effect can be seen in Figure 2 which shows the large
signal behavior in a gain of 1 on
±15V supplies. The
clamping action enhances the slew rate beyond the input
limitation, but always leads to slew overshoot after the
clamps turn off. Figure 3 shows that for higher gain
APPLICATIONS INFORMATION
WU
U
configurations there is much less slew rate enhancement
because the input only moves 2V, barely enough to turn on
the input clamps. In inverting configurations as shown in
Figure 4 the noninverting input does not move so there is
no input slew rate limitation. Slew overshoot is due to
capacitance on the inverting input and can be reduced with
a larger feedback resistor.
The output slew rate is set by the value of the feedback
resistors and the internal capacitance. Larger feedback
resistors will reduce the slew rate as will lower supply
voltages, similar to the way the bandwidth is reduced.
The larger feedback resistors will also cut back on slew
overshoot.
Figure 2. Large-Signal Response
AV = 1
VS = ±15V
RF = 560
RL = 100
1497 F02
Figure 3. Large-Signal Response
AV = 10
VS = ±15V
RF = 560
RL = 100
1497 F03
RG = 62
Figure 4. Large-Signal Response
AV = –1
VS = ±15V
RF = RG = 560
RL = 100
1497 F04
One Amplifier
SI
PLIFIED SCHE ATIC
W
1497 SS
+IN
–IN
VOUT
V+
V–
Q2
Q1
Q4
Q11
Q12
Q14
Q9
Q8
Q7
Q13
Q6
Q3
Q5
Q10
相關PDF資料 |
PDF描述 |
|---|---|
| FTSH-138-01-L-DV | CONN HEADER 76POS DUAL .05" SMD |
| FTS-138-03-L-DV | CONN HEADER 76POS DUAL .05" SMD |
| LT1222IS8#TRPBF | IC OP-AMP 500MHZ 200V/US 8-SOIC |
| 77317-812-12LF | CONN HEADER .100 2ROW R/A 12POS |
| SE5532AD8G | IC OPAMP DUAL LOW NOISE 8-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1498 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Single/Dual/Quad 60MHz, 20V/us, Low Power, Rail-to-Rail Input and Output Precision Op Amps |
| LT1498_09 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Driving A-to-D Converters |
| LT1498CN8 | 功能描述:IC OP-AMP R-R IN/OUT DUAL 8-DIP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:C-Load™ 標準包裝:2,500 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:350 V/µs 增益帶寬積:180MHz -3db帶寬:320MHz 電流 - 輸入偏壓:12.5µA 電壓 - 輸入偏移:800µV 電流 - 電源:15mA 電流 - 輸出 / 通道:85mA 電壓 - 電源，單路/雙路(±):2.5 V ~ 12.6 V，±1.25 V ~ 6.3 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-MSOP 包裝:帶卷 (TR) |
| LT1498CN8#PBF | 功能描述:IC OP-AMP R-R IN/OUT DUAL 8-DIP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:C-Load™ 標準包裝:2,500 系列:- 放大器類型:通用 電路數:4 輸出類型:- 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:45nA 電壓 - 輸入偏移:2000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:40mA 電壓 - 電源，單路/雙路(±):3 V ~ 32 V，±1.5 V ~ 16 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:帶卷 (TR) 其它名稱:LM324ADTBR2G-NDLM324ADTBR2GOSTR |
| LT1498CN8PBF | 制造商:Linear Technology 功能描述:LT1498CN8PBF |
發布緊急采購，3分鐘左右您將得到回復。