- 您現在的位置：買賣IC網 > PDF目錄377698 > LT1339CN (LINEAR TECHNOLOGY CORP) Octal Buffers/Drivers With 3-State Outputs 20-SOIC 0 to 70 PDF資料下載
參數資料
| 型號： | LT1339CN |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Octal Buffers/Drivers With 3-State Outputs 20-SOIC 0 to 70 |
| 中文描述： | SWITCHING CONTROLLER, 150 kHz SWITCHING FREQ-MAX, PDIP20 |
| 封裝： | 0.300 INCH, PLASTIC, DIP-20 |
| 文件頁數： | 9/20頁 |
| 文件大?。?/td> | 415K |
| 代理商： | LT1339CN |
9
LT1339
OPERATIO
The current comparator trip threshold is set on the V
C
pin,
which is the output of a transconductance amplifier, or
error amplifier (EA). The error amplifier integrates the
difference between a feedback voltage (on the V
FB
pin)
and an internal bandgap generated reference voltage of
1.25V, forming a signal that represents required load
current. If the supplied current is insufficient for a given
load, the output will droop, thus reducing the feedback
voltage. The error amplifier forces current out of the V
C
pin, increasing the current comparator threshold. Thus,
the circuit will servo until the provided current is equal to
the required load and the average output voltage is at the
value programmed by the feedback resistors.
U
(Refer to Functional Block Diagram)
Average Current Limit
The output of the sense amplifier is monitored by a single
pole integrator comprised of an external capacitor on the
I
AVG
pin and an internal impedance of approximately
50k
. If this averaged value signal exceeds a level corre-
sponding to 120mV across the external sense resistor, the
current comparator threshold is clamped and cannot
continue to rise in response to the error amplifier. Thus, if
average load current requirements exceed 120mV/R
SENSE
,
the supply will current limit and the output voltage will fall
out of regulation. The average current limit circuit moni-
tors the sense amplifier output without slope compensa-
tion or ripple current contributions, therefore the average
load current limit threshold is unaffected by duty cycle.
Undervoltage Lockout
The LT1339 employs an undervoltage lockout circuit
(UVLO) that monitors the 12V supply rail. This circuit
disables the output drive capability of the LT1339 if
the 12V supply drops below about 9V. Unstable mode
switching is prevented through 350mV of UVLO threshold
hysteresis.
Adaptive Nonoverlapping Output Stage
The FET driver output stage implements adaptive
nonoverlapping control. This circuitry maintains dead
time independent of the type, size or operating conditions
of the switch elements. The control circuit monitors the
output gate drive signals, insuring that the switch gate
(being disabled) is fully discharged before enabling the
other switch driver.
Shutdown
The LT1339 can be put into low current shutdown mode
by pulling the RUN/SHDN pin low, disabling all circuit
functions. The shutdown threshold is a bandgap referred
voltage of 1.25V typical. Use of a precision threshold on
the shutdown circuit enables use of this pin for undervolt-
age protection of the V
IN
supply and/or power supply
sequencing.
Soft Start
The LT1339 incorporates a soft start function that oper-
ates by slowly increasing the internal current limit. This
limit is controlled by clamping the V
C
node to a low voltage
that climbs with time as an external capacitor on the SS pin
is charged with about 8
μ
A. This forces a graceful climb of
output current capability, and thus a graceful increase in
output voltage until steady-state regulation is achieved.
The soft start timing capacitor is clamped to ground
during shutdown and during undervoltage lockout, yield-
ing a graceful output recovery from either condition.
5V Internal Reference
Power for the oscillator timing elements and most other
internal LT1339 circuits is derived from an internal 5V
reference, accessible at the 5V
REF
pin. This supply pin can be
loaded with up to 10mA DC (20mA pulsed) for convenient
biasing of local elements such as control logic, etc.
Slope Compensation
For duty cycles greater than 50%, slope compensation is
required to prevent current mode duty cycle instability in
the regulator control loop. The LT1339 employs internal
slope compensation that is adequate for most applica-
tions. However, if additional slope compensation is
desired, it is available through the SL/ADJ pin. Excessive
slope compensation will cause reduction in maximum
load current capability and therefore is not desirable.
相關PDF資料 |
PDF描述 |
|---|---|
| LT1339CSW | Octal Buffers/Drivers With 3-State Outputs 20-SOIC 0 to 70 |
| LT1339I | Octal Buffers/Drivers With 3-State Outputs 20-SOIC 0 to 70 |
| LT1339IN | Octal Buffers/Drivers With 3-State Outputs 20-PDIP 0 to 70 |
| LT1339ISW | High Power Synchronous DC/DC Controller |
| LT1341 | 5V RS232 Transceiver with One Receiver Active in Shutdown |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1339CN#PBF | 功能描述:IC REG CTRLR BST PWM CM 20-DIP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,000 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:1MHz 占空比:50% 電源電壓:9 V ~ 10 V 降壓:無 升壓:是 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 包裝:帶卷 (TR) |
| LT1339CN#PBF | 制造商:Linear Technology 功能描述:DC-DC CONTROLLER CURRENT MODE 制造商:Linear Technology 功能描述:DC-DC CONTROLLER, CURRENT MODE, 150KHZ, |
| LT1339CSW | 功能描述:IC REG CTRLR BST PWM CM 20-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LT1339CSW#PBF | 功能描述:IC REG CTRLR BST PWM CM 20-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,000 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:1MHz 占空比:50% 電源電壓:9 V ~ 10 V 降壓:無 升壓:是 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 包裝:帶卷 (TR) |
| LT1339CSW#TR | 功能描述:IC REG CTRLR BST PWM CM 20-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
發布緊急采購，3分鐘左右您將得到回復。