參數資料
型號: LT1328
廠商: Linear Technology Corporation
英文描述: Octal D-Type Transparent Latches With 3-State Outputs 20-SOIC 0 to 70
中文描述: 4Mbps的IrDA紅外接收器
文件頁數: 4/12頁
文件大小: 274K
代理商: LT1328
4
LT1328
GND (Pin 4):
Ground.
DATA (Pin 5):
TTL Output of the Comparator. A TTL LOW
at this pin indicates that the photodiode has received a
pulse of light. This pin will remain HIGH when the light
signal and noise are below the attenuation band of the DC
servo.
V
CC
(Pin 6):
5V Supply. A bypass capacitor, connected as
close as possible from Pin 6 to ground is recommended
(4.7
μ
F).
MODE (Pin 7):
A TTL HIGH on this pin will cause the open
collector at Pin 3 to switch to ground. This is an option that
switches in extra capacitance for lower frequency data
rates. If this pin is not used, select a capacitor (C4) to
accommodate the lowest data rate (for IrDA C4 = 10nF).
V
BIAS
(Pin 8):
A 1000pF capacitor from this pin to ground
is required.
PI
FU
CTIO
N
S
U
U
IN (Pin 1):
Connect this pin to the photodiode cathode.
This is the input to the preamplifier and is held at 1.5V by
the output of the DC servo. To maintain the 1.5V on this
pin, the DC servo can source up to 2mA or sink 40
μ
A to this
pin.
FILTER (Pin 2):
Connect a capacitor from this pin to
ground. The value of the capacitor will set the band of
frequencies that will be attenuated by the servo. The pole
is set by the formula f = 25/(2
π
60k C). A 330pF
capacitor will attenuate photodiode signals below 200kHz
when operating at high data rates (FIR and 4ppm).
FILTER SWITCH (Pin 3):
Collector of a Transistor Switch.
When the MODE switch (Pin 7) is TTL HIGH this pin will be
switched to ground. This pin is used to increase the filter
capacitor for slower data rates (SIR). A 10nF capacitor
from Pin 2 to Pin 3 will bring the highpass frequency down
to 6.6kHz for SIR.
BLOCK DIAGRA
M
W
Figure 1. LT1328 Block Diagram
R
FB
50k
1.5V
V
CC
R
IN
2k
D1
PHOTODIODE
TEMIC
BPV22NF
C1
10nF
IN
1
8
V
BIAS
6
5V
V
CC
7
MODE
5
1328 BD
DATA
FILTER
2
FILTER SWITCH
3
GND
4
PREAMP
DC SERVO
FILTER
g
m
60k
+
+
COMPARATOR
BIAS
C4
330pF
C6
1000pF
HIGH: SIR
LOW: FIR AND 4ppm
C2
4.7
μ
F
相關PDF資料
PDF描述
LT1330IJW 5V RS232 Transceiver with 3V Logic Interface and One Receiver Active in Shutdown
LT1330 5V RS232 Transceiver with 3V Logic Interface and One Receiver Active in Shutdown
LT1330C Octal D-Type Transparent Latches With 3-State Outputs 20-SOIC 0 to 70
LT1330CG Octal D-Type Transparent Latches With 3-State Outputs 20-SOIC 0 to 70
LT1330CNW 5V RS232 Transceiver with 3V Logic Interface and One Receiver Active in Shutdown
相關代理商/技術參數
參數描述
LT1328CMS8 功能描述:IC RECEIVER 4MBPS IRDA IR 8-MSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232,RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC 包裝:管件
LT1328CMS8#PBF 功能描述:IC RECEIVER 4MBPS IRDA IR 8-MSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232,RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC 包裝:管件
LT1328CMS8#TR 功能描述:IC RECEIVER IR 4MBPS IRDA 8MSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232,RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC 包裝:管件
LT1328CMS8#TRPBF 功能描述:IC RECEIVER 4MBPS IRDA IR 8-MSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232,RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC 包裝:管件
LT1328CS8 功能描述:IC RECEIVER 4MBPS IRDA IR 8-SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232,RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC 包裝:管件