- 您現在的位置：買賣IC網 > PDF目錄377682 > LT1108-12 (Linear Technology Corporation) Micropower DC/DC Converter Adjustable and Fixed 5V, 12V PDF資料下載
參數資料
| 型號： | LT1108-12 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | Micropower DC/DC Converter Adjustable and Fixed 5V, 12V |
| 中文描述： | 微功率DC / DC轉換可調和固定5V，12V的 |
| 文件頁數： | 9/12頁 |
| 文件大?。?/td> | 266K |
| 代理商： | LT1108-12 |
9
LT1108
U
S
A
O
PPLICATI
IU
U
HIGHER CURRENT STEP-DOWN OPERATION
Output current can be increased by using a discrete PNP
pass transistor as shown in Figure 3. R1 serves as a
current limit sense. When the voltage drop across R1
equals 0.5V
BE
, the switch turns off. As shown, switch
current is limited to 2A. Inductor value can be calculated
based on formulas in the Inductor Selection Step-Down
Converter section with the following conservative expres-
sion for V
SW
:
V
V
V
V
SW
R
Q SAT
1
=
+
≈
1
1 0
.
24
(
)
R2 provides a current path to turn off Q1. R3 provides base
drive to Q1. R4 and R5 set output voltage. A PMOS FET can
be used in place of Q1 when V
IN
is between 10V and 20V.
Figure 2. Step-Down Mode Hookup
LT1108 F02
GND
SW2
SW1
I
LIM
R3
100
FB
V
OUT
+
C2
+
C1
D1
1N5818
V
IN
R2
R1
L1
LT1108
V
IN
LT1108 F03
D1
1N5821
+
+
V
OUT
V
30V
MAX
L1
R1
0.15
R2
100
R6
100
Q1
ZETEX ZTX749
R3
330
R4
R5
C1
LT1108
GND
SW2
SW1
V
IN
I
L
FB
C2
V
OUT
= 1.245V 1 +
R4
R5
)
INVERTING CONFIGURATIONS
The LT1108 can be configured as a positive-to-negative
converter (Figure 4), or a negative-to-positive converter
(Figure 5). In Figure 4, the arrangement is very similar to a
step-down, except that the high side of the feedback is
referred to ground. This level shifts the output negative. As
in the step-down mode, D1 must be a Schottky diode,
and
V
OUT
should be less than 6.2V. More negative output
voltages can be accommodated as in the prior section.
In Figure 5, the input is negative while the output is positive.
In this configuration, the magnitude of the input voltage can
be higher or lower than the output voltage. A level shift,
I
V
V
V
L
t
PEAK
IN
SW
OUT
ON
=
(
)
22
When the switch turns off, the SW2 pin falls rapidly and
actually goes below ground. D1 turns on when SW2
reaches 0.4V below ground. D1 MUST BE A SCHOTTKY
DIODE The voltage at SW2 must never be allowed to go
below –0.5V. A silicon diode such as the 1N4933 will allow
SW2 to go to –0.8V, causing potentially destructive power
dissipation inside the LT1108. Output voltage is deter-
mined by
V
R
R
V
OUT
=
+
(
)
1
2
1
1 245
.
23
(
)
R3 programs switch current limit. This is especially impor-
tant in applications where the input varies over a wide
range. Without R3, the switch stays on for a fixed time each
cycle. Under certain conditions the current in L1 can build
up to excessive levels, exceeding the switch rating and/or
saturating the inductor. The 100
resistor programs the
switch to turn off when the current reaches approximately
700mA. When using the LT1108 in step-down mode,
output voltage should be limited to 6.2V or less. Higher
output voltages can be accommodated by inserting a
1N5818 diode in series with the SW2 pin (anode connected
to SW2).
Figure 3. Q1 Permits Higher Current Switching
The LT1108 Functions as Controller
相關PDF資料 |
PDF描述 |
|---|---|
| LT1108CN8 | Micropower DC/DC Converter Adjustable and Fixed 5V, 12V |
| LT1108CN8-12 | Micropower DC/DC Converter Adjustable and Fixed 5V, 12V |
| LT1108 | Micropower DC/DC Converter Adjustable and Fixed 5V, 12V |
| LT1108CN8-5 | 4-Bit Synchronous Up/Down Binary Counters With Dual Clock and Clear 16-SOIC 0 to 70 |
| LT1108CS8 | Micropower DC/DC Converter Adjustable and Fixed 5V, 12V |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1108-5 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Micropower DC/DC Converter Adjustable and Fixed 5V, 12V |
| LT1108CN8 | 功能描述:IC REG BUCK BST INV ADJ .4A 8DIP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LT1108CN8#PBF | 功能描述:IC REG BUCK BST INV ADJ .4A 8DIP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LT1108CN8-12 | 功能描述:IC REG BUCK BST INV 12V .4A 8DIP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LT1108CN8-12#PBF | 功能描述:IC REG BUCK BST INV 12V .4A 8DIP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:20 系列:SIMPLE SWITCHER® 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:12V 輸入電壓:4 V ~ 60 V PWM 型:電壓模式 頻率 - 開關:52kHz 電流 - 輸出:1A 同步整流器:無 工作溫度:-40°C ~ 125°C 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 包裝:管件 供應商設備封裝:16-DIP 其它名稱:*LM2575HVN-12LM2575HVN-12 |
發布緊急采購，3分鐘左右您將得到回復。