- 您現在的位置：買賣IC網 > PDF目錄377681 > LT1105I (Linear Technology Corporation) RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS PDF資料下載
參數資料
| 型號： | LT1105I |
| 廠商： | Linear Technology Corporation |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| 中文描述： | 抗輻射高效，5安培開關穩壓器 |
| 文件頁數： | 21/32頁 |
| 文件大?。?/td> | 452K |
| 代理商： | LT1105I |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
21
LT1103/LT1105
to zero or changing polarity. Therefore, the voltage on the
bias winding is only valid as a representation of the output
voltage while the secondary is delivering current.
Although the bias winding flyback voltage is a representa-
tion of the output voltage, its voltage is not constant. For
a brief period following the leakage inductance spike, the
bias winding flyback voltage decreases due to nonlinearities
and parasitics present in the transformer. Following this
nonlinear behavior is a period where the bias winding
flyback voltage decreases linearly. This behavior is easily
explained. Current flow in the secondary decreases lin-
early at a rate determined by the voltage across the
secondary and the inductance of the secondary. The
parasitic secondary leakage inductance appears as an
impedance in series with the secondary winding. In addi-
tion, parasitic resistances exist in the secondary winding,
the output diode and the output capacitor. These imped-
ances can be combined to form a lumped sum equivalent
and which cause a voltage drop as secondary current
flows. This voltage drop is coupled from the secondary to
the bias winding flyback voltage and becomes more sig-
nificant as the output is loaded more heavily. This voltage
drop is largest at the beginning of “switch off” time and
smallest just prior to either all transformer energy being
depleted or the switch turning on again.
The best representation of the output voltage is just prior
to either all transformer energy being used up and the bias
winding voltage collapsing to zero or just prior to the
switch turning on again and the bias winding going
negative. This point in time also represents the smallest
forward voltage for the output diode. It is possible to
redefine the relationship between the secondary winding
voltage and the bias winding voltage as:
(
V
V
Vf
N1
I R
BIAS
OUT
P
=
+
+
)
where Vf is the forward voltage of the output diode, I is the
current flowing in the secondary, R
P
is the lumped sum
equivalent secondary parasitic impedance and N1 is the
transformer turns ratio from the secondary to the bias
winding. It is apparent that even though the above point in
APPLICATIO
S I
N
FOR
ATIO
U
W
U
voltage, the secondary voltage, the bias voltage and the
winding currents are indicated in the figures found on the
following page for both continuous and discontinuous
modes of operation.
Simplified Flyback Converter
D1
1:N
LT1103 AI01
V
BIAS
S1
R
L(lk
SEC
)
V
OUT
C1
COMMON
L(Ik
PRI
)
V
IN
1:N1
N = TURNS RATIO FROM SECONDARY TO PRIMARY.
N1 = TURNS RATIO FROM SECONDARY TO BIAS.
N2 = N/N1
L(lk
PRI
) = PRIMARY LEAKAGE INDUCTANCE.
L(lk
SEC
) = SECONDARY LEAKAGE INDUCTANCE.
R = PARASITIC WINDING, DIODE AND OUTPUT
CAPACITOR RESISTANCE.
When the switch “turns on,” the primary winding sees the
input voltage and the secondary and bias windings go to
negative voltages as a function of the turns ratio. Current
builds in the primary winding as the transformer stores
energy. When the switch “turns off,” the voltage across
the switch flies back to a clamp level as defined by a
snubber network until the energy in the leakage induc-
tance of the primary dissipates. Leakage inductance is one
of the main parasitic elements in a flux-sensed converter
and is modeled as an inductor in series with the primary
and secondary of the transformer. These parasitic induc-
tances contribute to changes in the bias winding voltage
and thus the output voltage with increasing load current.
The energy stored in the transformer transfers through the
secondary and bias windings during “switch off” time.
Ideally, the voltage across the bias winding is set by the DC
output voltage, the forward voltage of the output diode,
and the turns ratio of the transformer after the energy in
the leakage inductance spike of the primary is dissipated.
This relationship holds until the energy in the transformer
drops to zero (discontinuous mode) or the switch turns on
again (continuous mode). Either case results in the volt-
age across the secondary and bias windings decreasing
相關PDF資料 |
PDF描述 |
|---|---|
| LT1105IN | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LT1107MJ8-12 | Micropower DC/DC Converter Adjustable and Fixed 5V, 12V |
| LT1107CN8-12 | Micropower DC/DC Converter Adjustable and Fixed 5V, 12V |
| LT1107-12 | Micropower DC/DC Converter Adjustable and Fixed 5V, 12V |
| LT1107-5 | Micropower DC/DC Converter Adjustable and Fixed 5V, 12V |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1105IN | 功能描述:IC OFFLINE SWIT CM HV 14DIP RoHS:否 類別:集成電路 (IC) >> PMIC - AC-DC 轉換器，離線開關 系列:- 標準包裝:3,000 系列:- 輸出隔離:隔離 頻率范圍:61kHz ~ 71kHz 輸入電壓:9.4 V ~ 28 V 輸出電壓:12V 功率（瓦特）:- 工作溫度:-40°C ~ 125°C 封裝/外殼:SC-74，SOT-457 供應商設備封裝:6-TSOP 包裝:帶卷 (TR) |
| LT1105IN#PBF | 制造商:Linear Technology 功能描述:Conv DC-DC Single 30V 14-Pin PDIP N |
| LT1105IN8 | 功能描述:IC OFFLINE SWIT CM HV 8DIP RoHS:否 類別:集成電路 (IC) >> PMIC - AC-DC 轉換器，離線開關 系列:- 標準包裝:3,000 系列:- 輸出隔離:隔離 頻率范圍:61kHz ~ 71kHz 輸入電壓:9.4 V ~ 28 V 輸出電壓:12V 功率（瓦特）:- 工作溫度:-40°C ~ 125°C 封裝/外殼:SC-74，SOT-457 供應商設備封裝:6-TSOP 包裝:帶卷 (TR) |
| LT1105IN8#PBF | 制造商:Linear Technology 功能描述:Conv DC-DC Single 30V 8-Pin PDIP N |
| LT1106 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Micropower Step-Up DC/DC Converter for PCMCIA Card Flash Memory |
發布緊急采購，3分鐘左右您將得到回復。