- 您現在的位置：買賣IC網 > PDF目錄30765 > LT1031DCH#PBF (LINEAR TECHNOLOGY CORP) 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 10 V, MBCY3 PDF資料下載
參數資料
| 型號： | LT1031DCH#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 10 V, MBCY3 |
| 封裝： | METAL CAN, TO-39, 3 PIN |
| 文件頁數： | 10/12頁 |
| 文件大?。?/td> | 156K |
| 代理商： | LT1031DCH#PBF |
7
LT1031/LH0070
1031fb
APPLICATIO S I FOR ATIO
WU
UU
Standard Series Mode
LT1031 TA05
INPUT
LOAD
+
KEEP THIS LINE RESISTANCE LOW
GROUND
RETURN
LT1031
GND
IN
OUT
Capacitive Loading and Transient Response
The LT1031 is stable with all capacitive loads, but for
optimum settling with load transients, output capacitance
should be under 1000pF. The output stage of the reference
is class AB with a fairly low idling current. This makes
transient response worst-case at light load currents.
Because of internal current drain on the output, actual
worst-case occurs at ILOAD = 1.4mA (sinking).
Significantly better load transient response is obtained by
moving slightly away from these points. See Load
Transient Response curves for details. In general, best
transient response is obtained when the output is sourcing
current. In critical applications, a 10
F solid tantalum
capacitor with several ohms in series provides optimum
output bypass.
Kelvin Connections
Although the LT1031 does not have true force/sense
capability at its outputs, significant improvements in ground
loop and line loss problems can be achieved with proper
hook-up. In series mode operation, the ground pin of the
LT1031 carries only
≈1mA and can be used as a sense line,
greatly reducing ground loop and loss problems on the low
side of the reference. The high side supplies load current
so line resistance must be kept low. Twelve feet of
#22 gauge hook up wire or 1 foot of 0.025 inch printed
circuit trace will create 2mV loss at 10mA output current.
This is equivalent to 1LSB in a 10V, 12-bit system.
The following circuits show proper hook-up to minimize
errors due to ground loops and line losses. Losses in the
output lead can be greatly reduced by adding a PNP boost
transistor if load currents are 5mA or higher. R2 can be
added to further reduce current in the output sense lead.
Effects of Air Movement on Low Frequency Noise
The LT1031 has very low noise because of the buried zener
used in its design. In the 0.1Hz to 10Hz band, peak-to-peak
noise is about 0.5ppm of the DC output. To achieve this
low noise, however, care must be taken to shield the
reference from ambient air turbulence. Air movement can
create noise because of thermoelectric differences
between IC package leads (especially kovar lead TO-5) and
printed circuit board materials and/or sockets. Power
dissipation in the reference, even though it rarely exceeds
20mW, is enough to cause small temperature gradients in
the package leads. Variations in thermal resistance, caused
by uneven airflow, create differential lead temperatures,
thereby causing thermoelectric voltage noise at the output
of the reference. The XY plotter trace shown on the
following page dramatically illustrates this effect. The first
half of the plot was done with the LT1031 shielded from
ambient air with a small foam cup. The cup was then
removed for the second half of the trace. Ambient in both
cases was a lab environment with no excessive air turbu-
lence from air conditioners, opening/closing doors, etc.
Removing the foam cup increases the output noise by
almost an order of magnitude in the 0.01Hz to 1Hz band!
The kovar leads of the TO-5 (H) package are the primary
culprit. Alloy 42 and copper lead frames used on dual-in-
line packages are not nearly as sensitive to thermally
generated noise because they are intrinsically matched.
Series Mode with Boost Transistor
LT1031
GND
OUT
IN
2N3906
INPUT
LOAD
*OPTIONAL—REDUCES CURRENT IN OUTPUT SENSE LEAD
GROUND
RETURN
R1
220
R2*
5.6k
LT1031 TA06
相關PDF資料 |
PDF描述 |
|---|---|
| LT1054MJ8#PBF | SWITCHED CAPACITOR REGULATOR, 40 kHz SWITCHING FREQ-MAX, CDIP8 |
| LT1054IN8#TRPBF | SWITCHED CAPACITOR REGULATOR, 40 kHz SWITCHING FREQ-MAX, PDIP8 |
| LT1054MJ8#TRPBF | SWITCHED CAPACITOR REGULATOR, 40 kHz SWITCHING FREQ-MAX, CDIP8 |
| LT1076HVCT#TRPBF | 3.2 A SWITCHING REGULATOR, 125 kHz SWITCHING FREQ-MAX, PZFM7 |
| LT1076IT-5#TR | 3.2 A SWITCHING REGULATOR, 120 kHz SWITCHING FREQ-MAX, PZFM5 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1031DMH | 功能描述:IC VREF SERIES SHUNT ZNR TO-39 RoHS:否 類別:集成電路 (IC) >> PMIC - 電壓基準 系列:- 標準包裝:2,000 系列:- 基準類型:旁路，可調節，精度 輸出電壓:1.24 V ~ 16 V 容差:±0.5% 溫度系數:- 輸入電壓:1.24 V ~ 16 V 通道數:1 電流 - 陰極:100µA 電流 - 靜態:- 電流 - 輸出:20mA 工作溫度:-40°C ~ 85°C 安裝類型:通孔 封裝/外殼:TO-226-3、TO-92-3（TO-226AA）成形引線 供應商設備封裝:TO-92-3 包裝:帶卷 (TR) |
| LT1031DMH#PBF | 功能描述:IC VREF SERIES SHUNT ZNR TO-39 RoHS:是 類別:集成電路 (IC) >> PMIC - 電壓基準 系列:- 標準包裝:3,000 系列:- 基準類型:旁路，精度 輸出電壓:5V 容差:±0.5% 溫度系數:100ppm/°C 輸入電壓:- 通道數:1 電流 - 陰極:80µA 電流 - 靜態:- 電流 - 輸出:15mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:TO-236-3，SC-59，SOT-23-3 供應商設備封裝:SOT-23-3 包裝:帶卷 (TR) 其它名稱:LM4040CIM3-5.0MLTRLM4040CIM3-5.0MLTR-ND |
| LT1031DMH/883 | 制造商:Linear Technology 功能描述:PRECISION 10V REFERENCE WITH ULTRALOW DRIFT AND NOISE |
| LT1032CN | 功能描述:IC LINE DRIVER LOWPWR QUAD 14DIP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232，RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC 包裝:管件 |
| LT1032CN#PBF | 功能描述:IC LINE DRIVER LOWPWR QUAD 14DIP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:RS-232 & USB Transceiver 標準包裝:2,000 系列:- 類型:收發器 驅動器/接收器數:1/1 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:16-SSOP 包裝:帶卷 (TR) 其它名稱:296-19849-2 |
發布緊急采購，3分鐘左右您將得到回復。