- 您現在的位置：買賣IC網 > PDF目錄377657 > LQH32CN100K53 (Linear Technology Corporation) 20mA LED Driver and OLED Driver with Integrated Schottky in 3mm x 2mm DFN PDF資料下載
參數資料
| 型號： | LQH32CN100K53 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | 20mA LED Driver and OLED Driver with Integrated Schottky in 3mm x 2mm DFN |
| 中文描述： | 20mA的LED驅動器和3毫米的OLED驅動器集成肖特基x 2mm DFN封裝 |
| 文件頁數： | 16/24頁 |
| 文件大?。?/td> | 449K |
| 代理商： | LQH32CN100K53 |
LT3498
16
3498f
Maximum Output Load Current
The maximum output current of a particular LT3498
circuit is a function of several circuit variables. The fol-
lowing method can be helpful in predicting the maximum
load current for a given circuit:
Step 1: Calculate the peak inductor current:
where I
LIMIT
is 0.3A for the OLED driver. L is the induc-
tance value in Henrys and V
IN
is the input voltage to the
boost circuit.
Step 2: Calculate the inductor ripple current:
(
2
I
I
V
L
amps
PK
LIMIT
IN
=
+
–
400 10
9
where V
OUT2
is the desired output voltage.
If the inductor ripple current is less then the peak current,
then the circuit will only operate in discontinuous conduc-
tion mode. The inductor value should be increased so
that I
RIPPLE
< I
PK
. An application circuit can be designed
to operate only in discontinuous mode, but the output
current capability will be reduced.
Step 3: Calculate the average input current:
I
V
V
L
amps
RIPPLE
OUT
IN
=
+
)
9
1
150 10
–
–
I
I
I
amps
IN AVG
(
PK
RIPPLE
2
)
–
=
Step 4: Calculate the nominal output current:
Step 5: Derate output current:
I
OUT
= I
OUT(NOM)
0.7 amps
I
I
V
V
amps
OUT NOM
(
IN AVG
(
IN
OUT
)
)
0 75
=
2
For low output voltages the output current capability will
be increased. When using output disconnect (load current
taken from V
OUT2
), these higher currents will cause the
drop in the PMOS switch to be higher resulting in reduced
output current capability than those predicted by the
preceding equations.
Inrush Current
When V
IN
is stepped from ground to the operating voltage
while the output capacitor is discharged, a higher level of
inrush current will flow through the inductor and integrated
Schottky diode into the output capacitor. Conditions that
increase inrush current include a larger more abrupt voltage
step at V
IN
, a larger output capacitor tied to the CAP2 pin,
and an inductor with a low saturation current. While the
internal diode is designed to handle such events, the inrush
current should not be allowed to exceed 1A. For circuits
that use output capacitor values within the recommended
range and have input voltages of less than 5V, inrush cur-
rent remains low, posing no hazard to the device. In cases
where there are large steps at V
IN
(more than 5V) and/or
a large capacitor is used at the CAP2 pin, inrush current
should be measured to ensure safe operation.
APPLICATIONS INFORMATION—OLED DRIVER
相關PDF資料 |
PDF描述 |
|---|---|
| LQH32CN150K53 | 20mA LED Driver and OLED Driver with Integrated Schottky in 3mm x 2mm DFN |
| LQH31C | Dual Micropower DC/DC Converters with Schottky Diodes |
| LQH32C | Dual Micropower DC/DC Converters with Schottky Diodes |
| LQH3C100 | Dual Micropower DC/DC Converter with Positive and Negative Outputs |
| LQH3C220 | Dual Micropower DC/DC Converter with Positive and Negative Outputs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LQH32CN100K53K | 制造商:MURATA 制造商全稱:Murata Manufacturing Co., Ltd. 功能描述:Chip Inductor (Chip Coil) Power Inductor (Wire Wound Type for Choke) LQH32C_53 Series |
| LQH32CN100K53L | 功能描述:固定電感器 10uH 10% RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm |
| LQH32CN101K21L | 功能描述:固定電感器 1210 100uH +/-10% RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm |
| LQH32CN101K23L | 功能描述:固定電感器 100uH 10% RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm |
| LQH32CN101K51L | 功能描述:固定電感器 1210 100uH +/-10% RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm |
發布緊急采購，3分鐘左右您將得到回復。