- 您現在的位置：買賣IC網 > PDF目錄11175 > LPC1342FHN33,518 (NXP Semiconductors)IC MCU 32BIT 16KB FLASH 32HVQFN PDF資料下載
參數資料
| 型號： | LPC1342FHN33,518 |
| 廠商： | NXP Semiconductors |
| 文件頁數： | 21/74頁 |
| 文件大小： | 0K |
| 描述： | IC MCU 32BIT 16KB FLASH 32HVQFN |
| 標準包裝： | 4,000 |
| 系列： | LPC13xx |
| 核心處理器： | ARM? Cortex?-M3 |
| 芯體尺寸： | 32-位 |
| 速度： | 72MHz |
| 連通性： | I²C，Microwire，SPI，SSI，SSP，UART/USART，USB |
| 外圍設備： | 欠壓檢測/復位，POR，WDT |
| 輸入/輸出數： | 28 |
| 程序存儲器容量： | 16KB（16K x 8） |
| 程序存儲器類型： | 閃存 |
| RAM 容量： | 4K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 2 V ~ 3.6 V |
| 數據轉換器： | A/D 8x10b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 32-VQFN 裸露焊盤 |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁
LPC1311_13_42_43
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2012. All rights reserved.
Product data sheet
Rev. 5 — 6 June 2012
28 of 74
NXP Semiconductors
LPC1311/13/42/43
32-bit ARM Cortex-M3 microcontroller
7.18.5.4
Deep power-down mode
In Deep power-down mode, power is shut off to the entire chip with the exception of the
WAKEUP pin. The LPC1311/13/42/43 can wake up from Deep power-down mode via the
WAKEUP pin.
A LOW-going pulse as short as 50 ns wakes up the part from Deep power-down mode.
When entering Deep power-down mode, an external pull-up resistor is required on the
WAKEUP pin to hold it HIGH. The RESET pin must also be held HIGH to prevent it from
floating while in Deep power-down mode.
7.19 System control
7.19.1 Start logic
The start logic connects external pins to corresponding interrupts in the NVIC. Each pin
NVIC interrupt vector table. The start logic pins can serve as external interrupt pins when
the chip is running. In addition, an input signal on the start logic pins can wake up the chip
from Deep-sleep mode when all clocks are shut down.
The start logic must be configured in the system configuration block and in the NVIC
before being used.
7.19.2 Reset
Reset has four sources on the LPC1311/13/42/43: the RESET pin, the Watchdog reset,
power-on reset (POR), and the Brown-Out Detection (BOD) circuit. The RESET pin is a
Schmitt trigger input pin. Assertion of chip reset by any source, once the operating voltage
attains a usable level, starts the IRC and initializes the flash controller.
When the internal reset is removed, the processor begins executing at address 0, which is
initially the reset vector mapped from the boot block. At that point, all of the processor and
peripheral registers have been initialized to predetermined values.
7.19.3 Brownout detection
The LPC1311/13/42/43 includes four levels for monitoring the voltage on the VDD pin. If
this voltage falls below one of the four selected levels, the BOD asserts an interrupt signal
to the NVIC. This signal can be enabled for interrupt in the Interrupt Enable Register in the
NVIC in order to cause a CPU interrupt; if not, software can monitor the signal by reading
a dedicated status register. An additional threshold level can be selected to cause a
forced reset of the chip.
7.19.4 Code security (Code Read Protection - CRP)
This feature of the LPC1311/13/42/43 allows user to enable different levels of security in
the system so that access to the on-chip flash and use of the Serial Wire Debugger (SWD)
and In-System Programming (ISP) can be restricted. When needed, CRP is invoked by
programming a specific pattern into a dedicated flash location. In-Application
Programming (IAP) commands are not affected by the CRP.
In addition, ISP entry via the PIO0_1 pin can be disabled without enabling CRP (NO_ISP
mode). For details see the LPC13xx user manual.
相關PDF資料 |
PDF描述 |
|---|---|
| VE-BNH-IW | CONVERTER MOD DC/DC 52V 100W |
| R5F100JCAFA#X0 | MCU 16BIT 32KB FLASH 52LQFP |
| VE-BNF-IW | CONVERTER MOD DC/DC 72V 100W |
| VE-BND-IX | CONVERTER MOD DC/DC 85V 75W |
| VE-BNB-IX | CONVERTER MOD DC/DC 95V 75W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LPC1342FHN33551 | 制造商:NXP Semiconductors 功能描述:IC 32BIT MCU ARM 72MHZ HVQFN-33 制造商:NXP Semiconductors 功能描述:MCU 32BIT ARM CORTEX M3 32HVQFN |
| LPC1343 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:32-bit ARM Cortex-M3 microcontroller up to 32 kB flash and 8 kB SRAM USB device |
| LPC1343FBD48 | 制造商:NXP Semiconductors 功能描述:MCU 32BIT 32K FLASH CORTEX-M3 48LQFP 制造商:NXP Semiconductors 功能描述:MCU, 32BIT, 32K FLASH, CORTEX-M3, 48LQFP |
| LPC1343FBD48,151 | 功能描述:ARM微控制器 - MCU 32-bit ARM Cortex-M3 32kb Flash RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC1343FBD48151 | 制造商:NXP Semiconductors 功能描述:MCU 32BIT CORTEX M3 48LQFP |
發布緊急采購，3分鐘左右您將得到回復。