- 您現在的位置：買賣IC網 > PDF目錄44344 > LMZ1301-7RV3H 1-OUTPUT 50 W AC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | LMZ1301-7RV3H |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 50 W AC-DC REG PWR SUPPLY MODULE |
| 封裝： | METAL, CASE M02, MODULE |
| 文件頁數： | 13/25頁 |
| 文件大?。?/td> | 569K |
| 代理商： | LMZ1301-7RV3H |
Cassette Style
DC-DC Converters
M Series
Edition 01/01.2001
20/25
Fig. 20
Typical inrush current waveforms of CM, CMZ, EM, LM
and LMZ DC-DC converter with option E
Precautions:
In order to avoid overload of the series resistor RI the on/off
switching cycle should be limited to 12 s if switched on/off
continuously. There should not be more than 10 start-up
cycles within 20 s at a case temperature of 25
°C.
If CM and CMZ types are driven by input voltages below
35 V DC or LM and LMZ types below 100 V AC, the maxi-
mum case temperature should be derated by 10 K or the to-
tal output power should be derated by 20%. EM, LM and
LMZ units driven by DC input voltages do not need to be
derated within the full specified input voltage range.
Availability:
Option E is available for CM, EM, LM and CMZ, LMZ mod-
ules with a nominal output power of 51 W maximum.
Input
Filter
Control
Converter
FET
Ci
RI
RS
Rectifier
(LM/LMZ types)
11018
Fig. 19
Option E block diagram
Table 19: Inrush current characteristics with option E
Characteristic
CM, CMZ
EM, LM, LMZ
Unit
at
Ui = 110 V DC
at
Ui = 110 V DC
at
Ui = 372 V DC
typ
max
typ
max
typ
max
Iinr p
Peak inrush current
6.5
8
2.2
4
7.3
10
A
tinr
Inrush current duration
22
30
10
20
40
ms
E Electronic Inrush Current Limitation
Available for CM, EM, LM and CMZ, LMZ types.
The standard version of the modules CM, DM, EM, LM as
well as CMZ, DMZ, LMZ include a passive inrush current
limitation in the form of a NTC resistor.
For applications which require an improved inrush current
limitation, an active electronic circuit as shown in fig.
Option
E block diagram has been developed. Typical inrush cur-
rent waveforms of units equipped with this option are
shown below.
CM and CMZ units meet the CEPT/ETSI standards for 48 V
DC supply voltage according to ETS 300132-2 if fitted with
option E combined with option D6 (input voltage monitor-
ing). Option D6, externally adjustable via potentiometer, is
necessary to disable the converter at input voltages below
the actual service ranges, avoiding an excessive input cur-
rent when the input voltage is raised slowly according to
ETS 300132-2. Option D6 threshold level
Uti + Uhi (refer to
description of option D) should be adjusted to 36.0...40.5 V
for 48 V DC nominal supply voltage (for 60 V DC systems,
threshold should be set to 44.0...50.0 V DC). The D output
(pin 5) should be connected to the inhibit (pin 2). For appli-
cations where potentiometers are not allowed refer to op-
tion D9.
12
10
8
6
4
2
0
10
20
30
40
t [ms]
Ii [A]
tinr
Normal operation
(FET fully conducting)
Ii = Po/(Ui η)
11019
tinr
CM, CMZ at 110 V DC
EM, LM, LMZ at 372 V DC
EM, LM, LMZ at 110 V DC
F Fuse Not Accessible
The standard M units have a fuseholder containing a 5
× 20
mm fuse which is externally accessible and to be found in
the back plate near the connector. Some applications re-
quire an inaccessible fuse. Option F provides a fuse moun-
ted directly onto the main PCB inside the case.
The full self-protecting functions of the module do normally
not lead to broken fuses, except as a result of inverse polar-
ity at the input of an AM, BM, CM, FM or CMZ type or if a
power component inside fails (switching transistor, free-
wheeling diode, etc). In such cases the defective unit has to
be returned to Power-One for repair.
H Enhanced Electric Strenght Test
Electric strength test voltage output to case 2800 V DC
(2000 V AC) instead of 1400 V DC (1000 V AC).
相關PDF資料 |
PDF描述 |
|---|---|
| LMZ1301-9EPD5 | 1-OUTPUT 50 W AC-DC REG PWR SUPPLY MODULE |
| LMZ1301-9ERA | 1-OUTPUT 50 W AC-DC REG PWR SUPPLY MODULE |
| LMZ1301-9PD4HF | 1-OUTPUT 50 W AC-DC REG PWR SUPPLY MODULE |
| LMZ1301-9PD5AF | 1-OUTPUT 50 W AC-DC REG PWR SUPPLY MODULE |
| LMZ1301-9PD7HF | 1-OUTPUT 50 W AC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LMZ13608 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:SIMPLE SWITCHER?? Power Module with 36V Maximum Input Voltage |
| LMZ13608EVAL/NOPB | 功能描述:電源管理IC開發工具 LMZ13608 EVAL BOARD RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| LMZ13608TZ | 制造商:TI 制造商全稱:Texas Instruments 功能描述:SIMPLE SWITCHER?? Power Module with 36V Maximum Input Voltage |
| LMZ13608TZ/NOPB | 功能描述:直流/直流開關調節器 RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| LMZ13608TZE | 制造商:TI 制造商全稱:Texas Instruments 功能描述:SIMPLE SWITCHER?? Power Module with 36V Maximum Input Voltage |
發布緊急采購，3分鐘左右您將得到回復。