- 您現在的位置：買賣IC網 > PDF目錄361034 > LM8300HLQ9 (NATIONAL SEMICONDUCTOR CORP) Four Wire Resistive Touchscreen Controller with Brownout PDF資料下載
參數資料
| 型號： | LM8300HLQ9 |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 消費家電 |
| 英文描述： | Four Wire Resistive Touchscreen Controller with Brownout |
| 中文描述： | SPECIALTY CONSUMER CIRCUIT, QCC44 |
| 封裝： | LLP-44 |
| 文件頁數： | 8/20頁 |
| 文件大?。?/td> | 327K |
| 代理商： | LM8300HLQ9 |
8.0 Electrical Characteristics
DC Electrical Characteristics (0C
≤
T
A
≤
+70C)
(Continued)
Datasheet min/max specification limits are guaranteed by design, test, or statistical analysis.
(Continued)
Parameter
Conditions
Min
Typ
Max
7
Units
pF
Input Capacitance
Note 4:
Maximum rate of voltage change must be
<
0.5 V/ms.
Note 5:
Supply and IDLE currents are measured with CKI driven with a
square wave Oscillator, CKO driven 180 out of phase with CKI, inputs
connected to V
CC
and outputs driven low but not connected to a load.
A/D Converter Electrical Characteristics (0C
≤
T
A
≤
+70C) (Single-ended
mode only)
Datasheet min/max specification limits are guaranteed by design, test, or statistical analysis.
Note 6:
The HALT mode will stop CKI from oscillating. Measurement of I
DD
HALT is done with device neither sourcing nor sinking current; all inputs tied
to V
CC
; A/D converter and clock monitor and BOR disabled.
Note 7:
Absolute Maximum Ratings should not be exceeded.
Parameter
Conditions
Min
Typ
Max
10
±
1
±
1
±
2
±
4
±
1.5
±
2.5
±
1.5
±
2.5
V
CC
0.5
6k
7
0.6
Units
Bits
LSB
LSB
LSB
LSB
LSB
LSB
LSB
LSB
V
μA
pF
mA
Resolution
DNL
DNL
INL
INL
Offset Error
Offset Error
Gain Error
Gain Error
Input Voltage Range
Analog Input Leakage Current
Analog Input Resistance (Note 8)
Analog Input Capacitance
Operating Current on AV
CC
V
CC
= 5V
V
CC
= 3V
V
CC
= 5V
V
CC
= 3V
V
CC
= 5V
V
CC
= 3V
V
CC
= 5V
V
CC
= 3V
2.7V
≤
V
CC
<
5.5V
0
AV
CC
= 5.5V
0.2
Note 8:
Resistance between the device input and the internal sample and hold capacitance.
9.0 Functional Description
9.1 GENERAL
The LM8300/8500 is a 4-wire resistive touch screen control-
ler. The primary communication is through the built in UART
operating at a baud rate of 38400. The LM8300/8500 has the
ability to measure pressure on the Z-axis, in addition to the
X-Y coordinates.
The device has the capability to do a 2, 5, and 13 point
calibration. All calibration data is stored in the internal non-
volatile storage element. In addition, all settings pertaining to
the controller are stored internally. This feature negates the
need for external EEPROM.
The device has three built in averaging algorithms: oversam-
pling, delta, and focus. These algorithms help to minimize
noise and A/D variation due to noise. Refer to the averaging
algorithm section for a more detail explanation. These algo-
rithms are implemented on-chip, freeing the main processor
from these tasks. To further minimize noise in extremely
noisy environments, the device has the ability to route the
signal from the touch panel to an external filtering stage
before A/D conversions are performed.
To minimize power consumption, the device can be put into
power save mode. The device can be set to go into power
save mode automatically or manually by pulling the external
shutdown pin low.
9.2 ADVANCED PIN DESCRIPTIONS
CLK_SET
— This pin is the selection pin used to determine
the operating frequency of the controller. On power up, the
controller polls this pin to determine if the operating fre-
quency is set to 10 MHz or 3.3 MHz. If the pin is left floating
or tied high, then the operating frequency is 10 MHz. If the
pin is tied low, then the operating frequency is set to 3.3
MHz.
Note:
This is available on the LM8500 only.
SHUTDOWN
— This is the external shut down pin. When
pulled low, the controller goes into power saving mode. This
selection pin state has higher priority than the internal power
save mode settings.
WAKE_UP
— This pin is used to wake the controller from
power save mode. When the device is in power save mode,
the pin must be tied to one of X-Y lines coming from the
touch screen panel.
X+
— Connect to X+ terminal of the resistive screen.
X-
— Connect to X- terminal of the resistive screen.
Y+
— Connect to Y+ terminal of the resistive screen.
Y-
— Connect to Y- terminal of the resistive screen.
Filter_out
— Analog output to external filter. The use of the
external filter is controlled by sending a command byte of
$A0 on the UART to the controller.
Filter_in
— Analog input from external filter. The use of the
external filter is controlled by sending a command byte of
$A0 on the UART to the controller.
L
www.national.com
8
相關PDF資料 |
PDF描述 |
|---|---|
| LM8300HMT9 | Four Wire Resistive Touchscreen Controller with Brownout |
| LM831 | LM831 Low Voltage Audio Power Amplifier |
| LM831M | LM831 Low Voltage Audio Power Amplifier |
| LM831N | LM831 Low Voltage Audio Power Amplifier |
| LM8364 | Thin Film Resistor Network; Series:VSSR; Resistance:39ohm; Resistance Tolerance:+/- 2 %; Power Rating:1.4W; Voltage Rating:50V; Temperature Coefficient:+/-100 ppm; Package/Case:24-QSOP; Network Circuit Type:Isolated |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM8300HMT9 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Four Wire Resistive Touchscreen Controller with Brownout |
| LM8300HVA9 | 功能描述:IC TOUCHSCREEN CONTROLLER 44PLCC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 觸摸屏控制器 系列:- 標準包裝:96 系列:- 類型:- 觸摸面板接口:- 輸入數/鍵:- 分辨率（位）:- 評估套件:* 數據接口:- 數據速率/采樣率 (SPS，BPS):- 電壓基準:- 電源電壓:- 電流 - 電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| LM8300ILQ9 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Four Wire Resistive Touchscreen Controller with Brownout |
| LM8300IMT9 | 功能描述:IC TOUCHSCREEN CONTROLLR 48TSSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 觸摸屏控制器 系列:- 標準包裝:96 系列:- 類型:- 觸摸面板接口:- 輸入數/鍵:- 分辨率（位）:- 評估套件:* 數據接口:- 數據速率/采樣率 (SPS，BPS):- 電壓基準:- 電源電壓:- 電流 - 電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| LM8300IMT9/NOPB | 制造商:Texas Instruments 功能描述:Four Wire Resistive Touchscreen Controller With Brownout 48-Pin TSSOP |
發布緊急采購，3分鐘左右您將得到回復。