- 您現在的位置：買賣IC網 > PDF目錄385488 > LM6134BIN (NATIONAL SEMICONDUCTOR CORP) Low Power 10 MHz Rail-to-Rail I/O Operational Amplifiers PDF資料下載
參數資料
| 型號： | LM6134BIN |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 運動控制電子 |
| 英文描述： | Low Power 10 MHz Rail-to-Rail I/O Operational Amplifiers |
| 中文描述： | QUAD OP-AMP, 8000 uV OFFSET-MAX, 10 MHz BAND WIDTH, PDIP14 |
| 封裝： | 0.300 INCH, PLASTIC, DIP-14 |
| 文件頁數： | 9/14頁 |
| 文件大小： | 361K |
| 代理商： | LM6134BIN |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁
LM6132/34 Application Hints
(Continued)
If the input signal exceeds the slew rate of the input stage
and the differential input voltage rises above a diode drop,
the excess signal bypasses the normal input transistors,
(Q1–Q4), and is routed in correct phase through the two ad-
ditional transistors, (Q5, Q6), directly into the current mirrors.
This rerouting of excess signal allows the slew-rate to in-
crease by a factor of 10 to 1 or more. (See Figure 1)
As the overdrive increases, the opamp reacts better than a
conventional opamp. Large fast pulses will raise the slew-
rate to around 25V to 30V/μs.
This effect is most noticeable at higher supply voltages and
lower gains where incoming signals are likely to be large.
This speed-up action adds stability to the system when driv-
ing large capacitive loads.
DRIVING CAPACITIVE LOADS
Capacitive loads decrease the phase margin of all opamps.
This is caused by the output resistance of the amplifier and
the load capacitance forming an R-C phase lag network.
This can lead to overshoot, ringing and oscillation. Slew rate
limiting can also cause additional lag. Most opamps with a
fixed maximum slew-rate will lag further and further behind
when driving capacitive loads even though the differential in-
put voltage raises. With the LM6132, the lag causes the slew
rate to raise. The increased slew-rate keeps the output fol-
lowing the input much better. This effectively reduces phase
lag. After the output has caught up with the input, the differ-
ential input voltage drops down and the amplifier settles
rapidly.
These features allow the LM6132 to drive capacitive loads
as large as 500 pF at unity gain and not oscillate. The scope
photos (Figure 3and Figure 4) above show the LM6132 driv-
ing a 500 pF load. In Figure 3 , the lower trace is with no ca-
pacitive load and the upper trace is with a 500 pF load. Here
we are operating on
±
12V supplies with a 20 Vp-p pulse. Ex-
Slew Rate vs Differential V
IN
V
S
=
±
12V
DS012349-40
FIGURE 1.
DS012349-36
FIGURE 2.
L
www.national.com
9
相關PDF資料 |
PDF描述 |
|---|---|
| LM6134BIM | Low Power 10 MHz Rail-to-Rail I/O Operational Amplifiers |
| LM6211 | Low Noise, RRO Operational Amplifier with CMOS Input and 24V Operation |
| LM6211MF | Low Noise, RRO Operational Amplifier with CMOS Input and 24V Operation |
| LM6211MFX | Low Noise, RRO Operational Amplifier with CMOS Input and 24V Operation |
| LM62CIM3X | 2.7V, 15.6 mV/∑C SOT-23 Temperature Sensor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM6134BIN | 制造商:Texas Instruments 功能描述:OP AMP QUAD 10MHZ RRI/O 6134 DIP |
| LM6134BIN/NOPB | 功能描述:運算放大器 - 運放 10Mhz,350Ua Sply Cur Quad Amp RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| LM613AIMX/NOPB | 制造商:Texas Instruments 功能描述: |
| LM613AIN | 制造商:Texas Instruments 功能描述: |
| LM613AME/883 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Dual Operational Amplifiers, Dual Comparators, and Adjustable Reference |
發布緊急采購，3分鐘左右您將得到回復。