參數資料
型號: LM3475
廠商: National Semiconductor Corporation
英文描述: Hysteretic PFET Buck Controller
中文描述: 遲滯PFET的降壓控制器
文件頁數: 8/14頁
文件大小: 305K
代理商: LM3475
Operation Description
(Continued)
device enters soft-start. During soft-start, the reference volt-
age is ramped up to the nominal value of 0.8V in approxi-
mately 4ms. Duty cycle and output voltage will increase as
the reference voltage is ramped up.
UNDER VOLTAGE DETECTION
When the output voltage falls below 70% (typical) of the
normal voltage, as measured at the FB pin, the device turns
off PFET and restarts a new soft-start cycle. In short circuit,
the PFET is always on, and the converter is effectively a
resistor divider from input to output to ground. Whether the
part restarts depends on the power path resistance and the
short circuit resistance. This feature should not be consid-
ered as overcurrent protection or output short circuit protec-
tion.
PGATE
During switching, the PGATE pin swings from V
(off) to
ground (on). As input voltage increases, the time it takes to
slew the gate of the PFET on and off also increases.Also, as
the PFET gate voltage approaches V
, the PGATE current
driving capability decreases. This can cause a significant
additional delay in turning the switch off when using a PFET
with a low threshold voltage. These two effects will increase
power dissipation and reduce efficiency. Therefore, a PFET
with relatively high threshold voltage and low gate capaci-
tance is recommended.
MINIMUM ON/OFF TIME
To ensure accurate comparator switching, the LM3475 im-
poses a blanking time after each comparator state change.
This blanking time is 180ns typically. Immediately after the
comparator goes high or low, it will be held in that state for
the duration of the blanking time. This helps keep the hys-
teretic comparator from improperly responding to switching
noise spikes (See Reducing Switching Noise) and ESL
spikes (See Output Capacitor Selection) at the output.
At very low or very high duty cycle operation, maximum
frequency will be limited by the blanking time. The maximum
operating frequency can be determined by the following
equations:
F
MAX
= D / ton
min
F
MAX
= (1-D) / toff
min
Where D is the duty cycle, defined as V
/V
, and ton
and toff
is the sum of the blanking time, the propagation
delay time and the PFET delay time (see
Figure 1
).
ENABLE PIN (EN)
The LM3475 provides a shutdown function via the EN pin to
disable the device. The device is active when the EN pin is
pulled above 1.5V (typ) and in shutdown mode when EN is
below 1.135V (typ). In shutdown mode, total quiescent cur-
rent is less than 10μA. The EN pin can be directly connected
to V
IN
for always-on operation.
L
www.national.com
8
相關PDF資料
PDF描述
LM3475MF Hysteretic PFET Buck Controller
LM3475MFX Hysteretic PFET Buck Controller
LM3480IM3-12 100 mA, SOT-23, Quasi Low-Dropout Linear Voltage Regulator
LM3480IM3-3.3 100 mA, SOT-23, Quasi Low-Dropout Linear Voltage Regulator
LM3480IM3-5.0 100 mA, SOT-23, Quasi Low-Dropout Linear Voltage Regulator
相關代理商/技術參數
參數描述
LM3475EVAL 功能描述:電源管理IC開發工具 LM3475 EVAL BOARD RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
LM3475EVAL 制造商:Texas Instruments 功能描述:EVAL BOARD, LM3475 HYSTERITIC STEP-DOWN
LM3475MF 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
LM3475MF/NOPB 功能描述:DC/DC 開關控制器 HYSTERETIC PFET BUCK CONTROLLER RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
LM3475MFX 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK