- 您現在的位置：買賣IC網 > PDF目錄358827 > LM2700MTX-ADJ (NATIONAL SEMICONDUCTOR CORP) 600kHz/1.25MHz, 2.5A, Step-up PWM DC/DC Converter PDF資料下載
參數資料
| 型號： | LM2700MTX-ADJ |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 600kHz/1.25MHz, 2.5A, Step-up PWM DC/DC Converter |
| 中文描述： | 4.3 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PDSO14 |
| 封裝： | TSSOP-14 |
| 文件頁數： | 3/17頁 |
| 文件大?。?/td> | 478K |
| 代理商： | LM2700MTX-ADJ |
Block Diagram
20012303
Detailed Description
The LM2700 utilizes a PWM control scheme to regulate the
output voltage over all load conditions. The operation can
best be understood referring to the block diagram and Figure
1 of the Operation section. At the start of each cycle, the
oscillator sets the driver logic and turns on the NMOS power
device conducting current through the inductor, cycle 1 of
Figure 1 (a). During this cycle, the voltage at the V
pin
controls the peak inductor current. The V
C
voltage will in-
crease with larger loads and decrease with smaller. This
voltage is compared with the summation of the SW voltage
and the ramp compensation. The ramp compensation is
used in PWM architectures to eliminate the sub-harmonic
oscillations that occur during duty cycles greater than 50%.
Once the summation of the ramp compensation and switch
voltage equals the V
C
voltage, the PWM comparator resets
the driver logic turning off the NMOS power device. The
inductor current then flows through the schottky diode to the
load and output capacitor, cycle 2 of Figure 1(b). The NMOS
power device is then set by the oscillator at the end of the
period and current flows through the inductor once again.
The LM2700 has dedicated protection circuitry running dur-
ing normal operation to protect the IC. The Thermal Shut-
down circuitry turns off the NMOS power device when the
die temperature reaches excessive levels. The UVP com-
parator protects the NMOS power device during supply
power startup and shutdown to prevent operation at voltages
less than the minimum input voltage. The OVP comparator is
used to prevent the output voltage from rising at no loads
allowing full PWM operation over all load conditions. The
LM2700 also features a shutdown mode decreasing the
supply current to 5μA.
L
www.national.com
3
相關PDF資料 |
PDF描述 |
|---|---|
| LM2700LD-ADJ | 600kHz/1.25MHz, 2.5A, Step-up PWM DC/DC Converter |
| LM2700LDX-ADJ | 600kHz/1.25MHz, 2.5A, Step-up PWM DC/DC Converter |
| LM2700 | 600kHz/1.25MHz, 2.5A, Step-up PWM DC/DC Converter |
| LM2703MF-ADJ | Micropower Step-up DC/DC Converter with 350mA Peak Current Limit |
| LM2703MFX-ADJ | Micropower Step-up DC/DC Converter with 350mA Peak Current Limit |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM2700MTX-ADJ/NOPB | 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| LM2700Q | 制造商:TI 制造商全稱:Texas Instruments 功能描述:600kHz/1.25MHz, 2.5A, Step-up PWM DC/DC Converter |
| LM2700QMT-ADJ | 制造商:TI 制造商全稱:Texas Instruments 功能描述:600kHz/1.25MHz, 2.5A, Step-up PWM DC/DC Converter |
| LM2700QMT-ADJ/NOPB | 功能描述:直流/直流開關轉換器 600kHz/1.25MHz,2.5A SU PWM DC/DC Cnvrtr RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| LM2700QMTX-ADJ | 制造商:TI 制造商全稱:Texas Instruments 功能描述:600kHz/1.25MHz, 2.5A, Step-up PWM DC/DC Converter |
發布緊急采購，3分鐘左右您將得到回復。