- 您現在的位置：買賣IC網 > PDF目錄16351 > LM1894MTBD (National Semiconductor)BOARD EVALUATION LM1894 PDF資料下載
參數資料
| 型號： | LM1894MTBD |
| 廠商： | National Semiconductor |
| 文件頁數： | 2/19頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD EVALUATION LM1894 |
| 標準包裝： | 1 |
| 主要目的： | 音頻，音頻處理 |
| 已用 IC / 零件： | LM1894 |
| 已供物品： | 板 |
| 相關產品： | LM1894MX-ND - IC NOISE REDUCT SYS DYNAM 14SOIC LM1894M-ND - IC DYNAM NOISE REDUCT SYS 14SOIC |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁
SNAS551C – DECEMBER 1994 – REVISED APRIL 2013
APPLICATION HINTS
The DNR system should always be placed before tone and volume controls as shown in Figure 1. This is
because any adjustment of these controls would alter the noise floor seen by the DNR control path. The
sensitivity resistors R1 and R2 may need to be switched with the input selector, depending on the noise floors of
different sources, i.e., tape, FM, phono. To determine the value of R1 and R2 in a tape system for instance;
apply tape noise (no program material) and adjust the ratio of R1 and R2 to open slightly the bandwidth of the
main signal path. This can easily be done by viewing the capacitor voltage of pin 10 with an oscilloscope, or by
using the circuit of Figure 14. This circuit gives an LED display of the voltage on the peak detector capacitor.
Adjust the values of R1 and R2 (their sum is always 1 k
Ω) to light the LEDs of pin 1 and pin 18. The LED bar
graph does not indicate signal level, but rather instantaneous bandwidth of the two filters; it should not be used
as a signal-level indicator. For greater flexibility in setting the bandwidth sensitivity, R1 and R2 could be replaced
by a 1 k
Ω potentiometer.
To change the minimum and maximum value of bandwidth, the integrating capacitors, C3 and C12, can be
scaled up or down. Since the bandwidth is inversely proportional to the capacitance, changing this 0.0039
μF
capacitor to 0.0033
μF will change the typical bandwidth from 965 Hz–34 kHz to 1.1 kHz–40 kHz. With C3 and
C12 set at 0.0033
μF, the maximum bandwidth is typically 34 kHz. A double pole double throw switch can be
used to completely bypass DNR.
The capacitor on pin 10 in conjunction with internal resistors sets the attack and decay times. The attack time
can be altered by changing the size of C10. Decay times can be decreased by paralleling a resistor with C10,
and increased by increasing the value of C10.
When measuring the amount of noise reduction of the DNR system, the frequency response of the cassette
should be flat to 10 kHz. The CCIR weighting network has substantial gain to 8 kHz and any additional roll-off in
the cassette player will reduce the benefits of DNR noise reduction. A typical signal-to-noise measurement circuit
is shown in Figure 15. The DNR system should be switched from maximum bandwidth to nominal bandwidth with
tape noise as a signal source. The reduction in measured noise is the signal-to-noise ratio improvement.
Figure 14. Bar Graph Display of Peak Detector Voltage
10
Copyright 1994–2013, Texas Instruments Incorporated
Product Folder Links: LM1894
相關PDF資料 |
PDF描述 |
|---|---|
| A3DDH-3418G | IDC CABLE - AKR34H/AE34G/AKR34H |
| M1GXK-2036J | IDC CABLE - MCS20K/MC20G/X |
| BRC2016T1R5M | INDUCTOR 1.5UH 1.1A 0806 SMD |
| M1FXK-2036J | IDC CABLE - MCF20K/MC20G/X |
| REC3.5-0515DRW/R8/C | CONV DC/DC 3.5W 4.5-9VIN +/-15VO |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM1894MX | 功能描述:特殊用途放大器 RoHS:否 制造商:Texas Instruments 通道數量:Single 共模抑制比（最小值）: 輸入補償電壓: 工作電源電壓:3 V to 5.5 V 電源電流:5 mA 最大功率耗散: 最大工作溫度:+ 70 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-20 封裝:Reel |
| LM1894MX/NOPB | 功能描述:特殊用途放大器 RoHS:否 制造商:Texas Instruments 通道數量:Single 共模抑制比（最小值）: 輸入補償電壓: 工作電源電壓:3 V to 5.5 V 電源電流:5 mA 最大功率耗散: 最大工作溫度:+ 70 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-20 封裝:Reel |
| LM1894N | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:OC White Company 功能描述:Dynamic Noise Reduction System 14-Pin PDIP Rail |
| LM1895 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:AUDIO POWE RAMPLIFIER |
| LM1895N | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:AUDIO POWE RAMPLIFIER |
發布緊急采購，3分鐘左右您將得到回復。