參數資料
型號: LIS3LV02DL
廠商: 意法半導體
英文描述: MEMS INERTIAL SENSOR 3-Axis - 【2g/【6g Digital Output Low Voltage Linear Accelerometer
中文描述: MEMS慣性傳感器3軸- 【2克/【6克數字輸出低電壓線性加速度計
文件頁數: 14/36頁
文件大?。?/td> 248K
代理商: LIS3LV02DL
Digital Interfaces
LIS3LV02DL
14/36
5
Digital Interfaces
The registers embedded inside the LIS3LV02DL may be accessed through both the I
2
C and
SPI serial interfaces. The latter may be SW configured to operate either in 3-wire or 4-wire
interface mode.
The serial interfaces are mapped onto the same pads. To select/exploit the I
2
C interface, CS
line must be tied high (i.e connected to Vdd_IO).
Table 5.
Serial interface pin description
5.1
I
2
C Serial Interface
The LIS3LV02DL I
2
C is a bus slave. The I
2
C is employed to write the data into the registers
whose content can also be read back.
The relevant I
2
C terminology is given in the table below
Table 6.
Serial interface pin description
There are two signals associated with the I
2
C bus: the Serial Clock Line (SCL) and the Serial
DAta line (SDA). The latter is a bidirectional line used for sending and receiving the data to/from
the interface. Both the lines are connected to Vdd_IO through a pull-up resistor embedded
inside the LIS3LV02DL. When the bus is free both the lines are high.
The I
2
C interface is compliant with Fast Mode (400 kHz) I
2
C standards as well as the Normal
Mode.
PIN Name
PIN Description
CS
SPI enable
I
2
C/SPI mode selection (1: I
2
C mode; 0: SPI enabled)
SCL/SPC
I
2
C Serial Clock (SCL)
SPI Serial Port Clock (SPC)
SDA/SDI/SDO
I
2
C Serial Data (SDA)
SPI Serial Data Input (SDI)
3-wire Interface Serial Data Output (SDO)
SDO
SPI Serial Data Output (SDO)
Term
Description
Transmitter
The device which sends data to the bus
Receiver
The device which receives data from the bus
Master
The device which initiates a transfer, generates clock signals and terminates a
transfer
Slave
The device addressed by the master
相關PDF資料
PDF描述
LIS3LV02DL-TR MEMS INERTIAL SENSOR 3-Axis - 【2g/【6g Digital Output Low Voltage Linear Accelerometer
LIS3LV02DQ MEMS INERTIAL SENSOR 3-Axis - +-2g/+-6g Digital Output Low Voltage Linear Accelerometer
LIS3LV02DQ-TR MEMS INERTIAL SENSOR 3-Axis - +-2g/+-6g Digital Output Low Voltage Linear Accelerometer
LJ600600-1 Class J Fuse Blocks
LJ600100-1 Class J Fuse Blocks
相關代理商/技術參數
參數描述
LIS3LV02DL_08 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:MEMS inertial sensor 3-axis - 【2g/【6g digital output low voltage linear accelerometer
LIS3LV02DLTR 功能描述:加速計 - 板上安裝 MEMS INERTIAL snsr 3 axis RoHS:否 制造商:Murata 傳感軸:Double 加速:12 g 靈敏度: 封裝 / 箱體: 輸出類型:Analog 數字輸出 - 位數:11 bit 電源電壓-最大:5.25 V 電源電壓-最小:4.75 V 電源電流:4 mA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C
LIS3LV02DL-TR 制造商:STMicroelectronics 功能描述:MEMS INERTIAL SENSOR
LIS3LV02DQ 功能描述:加速計 - 板上安裝 3-axis +/-2g/+/-6g MEMS Intertial Sensr RoHS:否 制造商:Murata 傳感軸:Double 加速:12 g 靈敏度: 封裝 / 箱體: 輸出類型:Analog 數字輸出 - 位數:11 bit 電源電壓-最大:5.25 V 電源電壓-最小:4.75 V 電源電流:4 mA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C
LIS3LV02DQ-TR 功能描述:加速計 - 板上安裝 INERTIAL SENSOR Lo Vltg 3Axis RoHS:否 制造商:Murata 傳感軸:Double 加速:12 g 靈敏度: 封裝 / 箱體: 輸出類型:Analog 數字輸出 - 位數:11 bit 電源電壓-最大:5.25 V 電源電壓-最小:4.75 V 電源電流:4 mA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C