- 您現在的位置：買賣IC網 > PDF目錄358780 > LF451 (National Semiconductor Corporation) LF451 Wide-Bandwidth JFET-Input Operational Amplifier PDF資料下載
參數資料
| 型號： | LF451 |
| 廠商： | National Semiconductor Corporation |
| 英文描述： | LF451 Wide-Bandwidth JFET-Input Operational Amplifier |
| 中文描述： | LF451寬帶寬JFET輸入運算放大器 |
| 文件頁數： | 6/8頁 |
| 文件大?。?/td> | 207K |
| 代理商： | LF451 |
Application Hints
(Continued)
Exceeding the positive common-mode limit on a single input
will not change the phase of the output; however, if both
inputs exceed the limit, the output of the amplifier will be
forced to a high state.
The amplifier will operate with a common-mode input volt-
age equal to the positive supply; however, the gain band-
width and slew rate may be decreased in this condition.
When the negative common-mode voltage swings to within
3V of the negative supply, an increase in input offset voltage
may occur.
The LF451 is biased by a zener reference which allows nor-
mal circuit operation on
g
4V power supplies. Supply volt-
ages less than these may result in lower gain bandwidth and
slew rate.
The LF451 will drive a 2 k
X
load resistance to
g
10V over
the full temperature range of 0
§
C to
a
70
§
C. If the amplifier
is forced to drive heavier load currents, however, an in-
crease in input offset voltage may occur on the negative
voltage swing and finally reach an active current limit on
both positive and negative swings.
Precautions should be taken to ensure that the power sup-
ply for the integrated circuit never becomes reversed in po-
larity or that the unit is not inadvertently installed backwards
in a socket as an unlimited current surge through the result-
ing forward diode within the IC could cause fusing of the
internal conductors and result in a destroyed unit.
As with most amplifiers, care should be taken with lead
dress, component placement and supply decoupling in or-
der to ensure stability. For example, resistors from the out-
put to an input should be placed with the body close to the
input to minimize ‘‘pick-up’’ and maximize the frequency of
the feedback pole by minimizing the capacitance from the
input to ground.
A feedback pole is created when the feedback around any
amplifier is resistive. The parallel resistance and capaci-
tance from the input of the device (usually the inverting in-
put) to AC ground set the frequency of the pole. In many
instances the frequency of this pole is much greater than
the expected 3 dB frequency of the closed loop gain and
consequently there is negligible effect on stability margin.
However, if the feedback pole is less than approximately 6
times the expected 3 dB frequency a lead capacitor should
be placed from the output to the input of the op amp. The
value of the added capacitor should be such that the RC
time constant of this capacitor and the resistance it parallels
is greater than or equal to the original feedback pole time
constant.
The benefit of the S.O. package results from its very small
size. It follows, however, that the die inside the S.O. pack-
age is less protected from external physical forces than a
die in a standard DIP would be, because there is so much
less plastic in the S.O. Therefore, not following certain pre-
cautions when board mounting the LF451CM can put me-
chanical stress on the die, lead frame, and/or bond wires.
This can cause shifts in the LF451CM’s parameters, even
causing them to exceed limits specified in the Electrical
Characteristics. For recommended practices in LF451CM
surface mounting refer to Application Note AN-450 ‘‘Sur-
face Mounting Methods and Their Effect on Product Reli-
ability’’ and to Section 6 ‘‘Surface Mount’’ found in any
Rev. 1 Linear Databook volume.
Detailed Schematic
TL/H/9660–11
6
相關PDF資料 |
PDF描述 |
|---|---|
| LF451CM | LF451 Wide-Bandwidth JFET-Input Operational Amplifier |
| LF505-S | Current Transducer LF 505-S |
| LF59EMBGMBC | T-1 3/4 (5mm) FULL COLOR RGB LED LAMPS |
| LF5WAEMBGMBC | T-1 3/4 (5mm) FULL COLOR RGB LAMPS |
| LF8114 | BANDPASS FILTER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LF451CM | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| LF-452 | 制造商:SIRENZA 制造商全稱:SIRENZA 功能描述:Wideband RF/pulse Transformers .01-10 MHz/.01-5 MHz |
| LF453 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:LF453 Wide-Bandwidth Dual JFET-Input Operational Amplifiers |
| LF453CM | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:LF453 Wide-Bandwidth Dual JFET-Input Operational Amplifiers |
| LF-454 | 制造商:SIRENZA 制造商全稱:SIRENZA 功能描述:Wideband RF/pulse Transformers .01-10 MHz/.01-5 MHz |
發布緊急采購，3分鐘左右您將得到回復。