- 您現在的位置：買賣IC網 > PDF目錄358770 > LC86P7148 (Sanyo Electric Co.,Ltd.) 8-Bit Single Chip Microcontroller with One-Time Programmable PROM PDF資料下載
參數資料
| 型號： | LC86P7148 |
| 廠商： | Sanyo Electric Co.,Ltd. |
| 英文描述： | 8-Bit Single Chip Microcontroller with One-Time Programmable PROM |
| 中文描述： | 8位微控制器的單芯片一次性可編程胎膜早破 |
| 文件頁數： | 20/21頁 |
| 文件大小： | 662K |
| 代理商： | LC86P7148 |
LC86P7148
No.6692-20/21
Notice for use
The construction of the one-time programmable microcomputer with a blank built-in PROM makes it impossible for SANYO
to completely factory-test it before shipping. To probe reliability of the programmed devices, the screening procedure shown
in the following figure should always be followed.
It is not possible to perform a writing test on the blank PROM.. 100% yield, therefore, cannot be guaranteed.
Keeping the dry packing
The environment must be held at a temperature of 30
°
C or less and a humidity level of 70% or less.
After opening the packing
The preparation procedures shown in the following figure should always be followed prior to mounting the packages on the
substrate. Note that the QFP package should be heat-soaked for 12 hours at 125
°
C immediately prior to mounting (This
baking is called pre-baking). After pre-baking, a controlled environment must be maintained until soldering. The environment
must be held at a temperature of 30
°
C or less and a humidity level of 70% or less. Please solder within 24 hours.
a. Shipping with a blank PROM
b. Shipping with a programmed PROM
(Programming the data by yourself)
(Programming the data by Sanyo)
Recommended process of screening
QFP
Writing data for program/Verifying
Heat-soak
150±5
°
C, 24-0
Reading ascertain of program
VDD=5±0.5V
Mounting
QFP
Mounting
Baking before mounting
125
°
C, 12 hours
Baking
Baking before mounting
125
°
C, 12 hours
Baking
相關PDF資料 |
PDF描述 |
|---|---|
| LC86P7248 | 8-Bit Single-Chip Microcontroller with the One-Time Programmable PROM Built in |
| LC875016A | 8-Bit Single Chip Microcontroller with 16K-Byte(16256 ×8 bits) EPROM and 640-Byte(640 ×9 bits) RAM On Chip(8位單片微控制器（帶片上16K（16256 ×8 bit）字節EPROM和640(640 ×9 bits)字節RAM）) |
| LC875064B | 8-Bit Single Chip Microcontroller with 64K-Byte(65535 ×8 bits) EPROM and 2048-Byte(2048 ×8 bits) RAM On Chip(8位單片微控制器（帶片上64K（65535 ×8 bit）字節EPROM和2048(2048 ×8 bits)字節RAM）) |
| LC875132A | 8-Bit Single Chip Microcontroller with 32K-Byte(32512 ×8 bits) ROM and 1024-Byte(1024 ×8 bits) RAM On Chip(8位單片微控制器（帶片上32K（32512 ×8 bit）字節ROM和1024(1024 ×8 bits)字節RAM）) |
| LC876564A | 8-Bit Single Chip Microcontroller with 72/64 KB ROM and 2048-Byte RAM On Chip |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LC86P7248 | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:8-Bit Single-Chip Microcontroller with the One-Time Programmable PROM Built in |
| LC871H92A | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:CMOS IC 128K/96K-byte ROM and 12288-byte RAM integrated 8-bit 1-chip Microcontroller with USB-host controller |
| LC871H96A | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:CMOS IC 128K/96K-byte ROM and 16384-byte RAM integrated 8-bit 1-chip Microcontroller with USB-host controller |
| LC871HC4A | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:CMOS IC 128K/96K-byte ROM and 12288-byte RAM integrated 8-bit 1-chip Microcontroller with USB-host controller |
| LC871HC8A | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:CMOS IC 128K/96K-byte ROM and 16384-byte RAM integrated 8-bit 1-chip Microcontroller with USB-host controller |
發布緊急采購，3分鐘左右您將得到回復。