- 您現在的位置：買賣IC網 > PDF目錄358756 > LC5822 (Sanyo Electric Co.,Ltd.) 4-Bit Single-Chip Microcontrollers Featuring 4 KB to 8 KB of ROM, 1 Kbit of RAM, and an LCD Driver for Medium Speed Small-Scale Control Applications PDF資料下載
參數資料
| 型號： | LC5822 |
| 廠商： | Sanyo Electric Co.,Ltd. |
| 英文描述： | 4-Bit Single-Chip Microcontrollers Featuring 4 KB to 8 KB of ROM, 1 Kbit of RAM, and an LCD Driver for Medium Speed Small-Scale Control Applications |
| 中文描述： | 4位單片微控制器具有4 KB到8的ROM，1千位的RAM，以及為中速小規?？刂浦械膽肔CD驅動KB |
| 文件頁數： | 1/24頁 |
| 文件大?。?/td> | 281K |
| 代理商： | LC5822 |
Any and all SANYO products described or contained herein do not have specifications that can handle
applications that require extremely high levels of reliability, such as life-support systems, aircraft’s
control systems, or other applications whose failure can be reasonably expected to result in serious
physical and/or material damage. Consult with your SANYO representative nearest you before using
any SANYO products described or contained herein in such applications.
SANYO assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other
parameters) listed in products specifications of any and all SANYO products described or contained
herein.
Overview
The LC5822, LC5823, and LC5824 are CMOS
microcontrollers that feature the low-voltage operation
required for battery-power applications and that provide
4 KB, 6 KB, or 8 KB of ROM, 1 kilobit of RAM, and an
LCD driver.
These microcontrollers support an instruction set based on
that of the earlier LC5800, LC5812, and LC5814 for
excellent efficiency in software development.
Applications
LCD display in multi-function watches, timers, and
other products
Control and LCD display in timers
Control and LCD display in miniature test equipment,
health maintenance equipment, and other products
These microcontrollers are optimal for products that
include an LCD display, especially battery powered
products.
Wide Allowable Operating Ranges
Note
*
: When the backup flag is set, the BAK pin is connected to V
DD
.
Features
These microcontrollers are high-end versions of the
LC5800 and provide the following features.
Low Current Drain * In halt mode (typical)
Ceramic oscillator 400 kHz (3.0 V) 200 μA
Crystal oscillator 32 kHz (1.5 V, Ag specifications)
3.0 μA (LCD biases other than 1/3) 4.5 μA (LCD drive:
1/3 bias)
Crystal oscillator 32 kHz (3.0 V, Li specifications)
2.0 μA (LCD biases other than 1/3) 6.0 μA (LCD drive:
1/3 bias)
Timer and Counter Functions
One 8-bit programmable timer (May be used as an event
counter)
One 8-bit programmable reload timer
Time base timer (for clocks)
Watchdog timer
8-bit serial I/O (3-pin synchronous system)
Standby Functions
Clock standby function (halt mode)
Only the oscillator circuits, the divider circuit, and the
LCD driver operate. All other internal operations are
stopped. This provides a power-saving function in which
current drain is minimized, and allows a clock function
to be implemented easily with low power dissipation.
Furthermore, low-speed and high-speed modes can be
implemented by setting the operating modes of the two
oscillator circuits.
Full standby function (hold mode)
Halt mode can be cleared by any of two external and
two internal interrupts.
CMOS IC
82198RM (OT) No. 5944-1/24
SANYO Electric Co.,Ltd. Semiconductor Bussiness Headquarters
TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110-8534 JAPAN
4-Bit Single-Chip Microcontrollers Featuring 4 KB to 8 KB of ROM, 1 Kbit of RAM,
and an LCD Driver for Medium Speed Small-Scale Control Applications
LC5824, LC5823, LC5822
Ordering number : EN5944
Power
options
supply
Cycle
times
Supply
voltage
range
Notes
EXT-V
10 μs
V
DD
= 2.3 to 3.6 V
When an 800-kHz ceramic
oscillator is used
EXT-V
20 μs
V
DD
= 2.3 to 3.6 V
When an 400-kHz ceramic
oscillator is used
EXT-V
61 μs
V
DD
= 2.3 to 3.6 V
When an 65-kHz crystal oscillator
is used
EXT-V
122 μs
V
DD
= 2.0 to 3.6 V
When an 32-kHz crystal oscillator
is used
Li
122 μs
V
DD
= 2.6 to 3.6 V
*
When an 32-kHz crystal oscillator
is used
Ag
122 μs
V
DD
= 1.3 to 1.65 V
When an 32-kHz crystal oscillator
is used
相關PDF資料 |
PDF描述 |
|---|---|
| LC5851N | 4-bit Single Chip Microcontroller with LCD Driver(4位微控制器（帶LCD驅動器）) |
| LC5852N | Four-Bit Single-Chip Microcontroller with On-Chip LCD Drivers for Small-Scale Control in Medium-Speed Applications(應用于中等速率中小規模控制的4位微控制器（帶片上LCD驅動器）) |
| LC5863H | 4-BIT SINGLE CHIP MICROCOMPUTER |
| LC587008 | Single-Chip 4-Bit Microprocessors with LCD Driver,2 Kb RAM, and 16 KB ROM on chip(4位單片微控制器（帶LCD驅動器，16K位ROM和2K位RAM）) |
| LC587202A | Single-Chip 4-Bit Micontroller with LCD Driver,512 ×4bit RAM,2K× 16 Bit ROM on chip(單片4位微控制器（帶LCD驅動器，512 ×4位RAM和2K× 16位ROM）) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LC5823 | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:4-Bit Single-Chip Microcontrollers Featuring 4 KB to 8 KB of ROM, 1 Kbit of RAM, and an LCD Driver for Medium Speed Small-Scale Control Applications |
| LC5824 | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:4-Bit Single-Chip Microcontrollers Featuring 4 KB to 8 KB of ROM, 1 Kbit of RAM, and an LCD Driver for Medium Speed Small-Scale Control Applications |
| LC5824-1K35 | 制造商:ON Semiconductor 功能描述: |
| LC5850 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| LC5851 | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Small-Scale Control, Medium Speed Type, On-Chip LCD Driver 4-Bit Single Chip Microcomputer |
發布緊急采購，3分鐘左右您將得到回復。