- 您現在的位置：買賣IC網 > PDF目錄358745 > LB1409 (Sanyo Electric Co.,Ltd.) Level Meter Driver for 9 LEDs PDF資料下載
參數資料
| 型號： | LB1409 |
| 廠商： | Sanyo Electric Co.,Ltd. |
| 英文描述： | Level Meter Driver for 9 LEDs |
| 中文描述： | 液位計9個LED驅動 |
| 文件頁數： | 4/4頁 |
| 文件大小： | 57K |
| 代理商： | LB1409 |
Sample Application Circuits
(All with offset adjustment)
.
Circuit not using Vref 2
Unit (resistance:
, capacitance: F)
.
Circuit using Vref 2
Unit (resistance:
, capacitance: F)
No products described or contained herein are intended for use in surgical implants, life-support systems, aerospace equipment,
nuclear power control systems, vehicles, disaster/crime-prevention equipment and the like, the failure of which may directly or
indirectly cause injury, death or property loss.
Anyone purchasing any products described or contained herein for an above-mentioned use shall:
1
Accept full responsibility and indemnify and defend SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors
and all their officers and employees, jointly and severally, against any and all claims and litigation and all damages, cost and
expenses associated with such use:
2
Not impose any responsibility for any fault or negligence which may be cited in any such claim or litigation on SANYO
ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors or any of their officers and employees jointly or severally.
Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed for volume
production. SANYO believes information herein is accurate and reliable, but no guarantees are made or implied regarding its use
or any infringements of intellectual property rights or other rights of third parties.
This catalog provides information as of May, 1996. Specifications and information herein are subject to change without notice.
Adjusting procedures
1.
Turn the center of 10 k
VR largely to 4.7 μF
capacitor side.
Input AC signal of 50/
u
2 mV from AC IN.
Adjust 1 k
VR so that the output at OUT becomes
500 mV DC.
Equation used in the calculation of R to be inserted
in series with LED.
Gain : 20 dB
R (red) = (V
CC
– 2.5) / 6 k
R (green) = (V
CC
– 2.8) / 18 k
2.
3.
Adjusting procedures
.
R to be inserted in series with LED is as follows
irrespective of V
CC
.
R (red) = 360
(Approx. 6 mA)
R (green) = 100
(Approx. 18 mA)
.
TR1 should be chosen with P
C
considered; and the
following transistors are recommended.
Red LED drive 2SD400
Green LED drive 2SD325
LB1409
No.683-4/4
相關PDF資料 |
PDF描述 |
|---|---|
| LB1410 | Level Meter |
| LB1411 | RES 61.9K OHM 1% 1/4W |
| LB1412M | Level Meter Driver for 12 LEDs(驅動12個LED的電平驅動器) |
| LB1412 | Level Meter Driver for 12 LEDs |
| LB1413N | 5-Dot Red/Green LED Level Meter(5點紅/綠色LED電平表) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LB1409M | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Interface IC |
| LB140DS03 | 制造商:SIPAT 制造商全稱:SIPAT 功能描述:140MHz SAW Filter 3.5MHz Bandwidth |
| LB140DS04 | 制造商:SIPAT 制造商全稱:SIPAT 功能描述:140MHz High-Loss SAW Filter 3.5MHz Bandwidth |
| LB140DS05 | 制造商:SIPAT 制造商全稱:SIPAT 功能描述:140MHz High-Loss SAW Filter 5MHz Bandwidth |
| LB140DS07 | 制造商:SIPAT 制造商全稱:SIPAT 功能描述:140MHz Low-loss SAW Filter 7MHz Bandwidth |
發布緊急采購，3分鐘左右您將得到回復。