- 您現在的位置：買賣IC網 > PDF目錄69003 > L6710TR (STMICROELECTRONICS) 2 A SWITCHING CONTROLLER, PQFP44 PDF資料下載
參數資料
| 型號： | L6710TR |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 穩壓器 |
| 英文描述： | 2 A SWITCHING CONTROLLER, PQFP44 |
| 封裝： | 10 X 10 MM, 1 MM HEIGHT, TQFP-44 |
| 文件頁數： | 11/34頁 |
| 文件大小： | 1610K |
| 代理商： | L6710TR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
19/34
L6710
Input bulk capacitor must be equally divided between high-side drain mosfets and placed as close as pos-
sible to reduce switching noise above all during load transient. Ceramic capacitor can also introduce ben-
efits in high frequency noise decoupling, noise generated by parasitic components along power path.
OUTPUT CAPACITOR
Since the microprocessors require a current variation beyond 50A doing load transients, with a slope in
the range of tenth A/
s, the output capacitor is a basic component for the fast response of the power sup-
ply.
Dual phase topology reduces the amount of output capacitance needed because of faster load transient
response (switching frequency is doubled at the load connections). Current ripple cancellation due to the
180° phase shift between the two phases also reduces requirements on the output ESR to sustain a spec-
ified voltage ripple.
When a load transient is applied to the converter's output, for first few microseconds the current to the load
is supplied by the output capacitors. The controller recognizes immediately the load transient and increas-
es the duty cycle, but the current slope is limited by the inductor value.
The output voltage has a first drop due to the current variation inside the capacitor (neglecting the effect
of the ESL):
A minimum capacitor value is required to sustain the current during the load transient without discharge
it. The voltage drop due to the output capacitor discharge is given by the following equation:
Where DMAX is the maximum duty cycle value. The lower is the ESR, the lower is the output drop during
load transient and the lower is the output voltage static ripple.
INDUCTOR DESIGN
The inductance value is defined by a compromise between the transient response time, the efficiency, the
cost and the size. The inductor has to be calculated to sustain the output and the input voltage variation
to maintain the ripple current
IL between 20% and 30% of the maximum output current. The inductance
value can be calculated with this relationship:
Where FSW is the switching frequency, VIN is the input voltage and VOUT is the output voltage.
Increasing the value of the inductance reduces the ripple current but, at the same time, reduces the con-
verter response time to a load transient. The response time is the time required by the inductor to change
its current from initial to final value. Since the inductor has not finished its charging time, the output current
is supplied by the output capacitors. Minimizing the response time can minimize the output capacitance
required.
The response time to a load transient is different for the application or the removal of the load: if during
the application of the load the inductor is charged by a voltage equal to the difference between the input
and the output voltage, during the removal it is discharged only by the output voltage. The following ex-
pressions give approximate response time for I load transient in case of enough fast compensation net-
work response:
V
OUT
I
OUT
ESR
=
V
OUT
I
2
OUT
L
4C
OUT
V
In
d
ma x
V
OUT
–
()
-------------------------------------------------------------------------------
=
L
V
IN
V
OUT
–
fs
I
L
------------------------------
V
OUT
V
IN
--------------
=
相關PDF資料 |
PDF描述 |
|---|---|
| L6713ATR | 2 A SWITCHING CONTROLLER, 225 kHz SWITCHING FREQ-MAX, PQFP64 |
| L6716TR | DUAL SWITCHING CONTROLLER, 225 kHz SWITCHING FREQ-MAX, QCC48 |
| L6716 | DUAL SWITCHING CONTROLLER, 225 kHz SWITCHING FREQ-MAX, QCC48 |
| L6722 | SWITCHING CONTROLLER, 300 kHz SWITCHING FREQ-MAX, QCC36 |
| L6722TR | SWITCHING CONTROLLER, 300 kHz SWITCHING FREQ-MAX, QCC36 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L6711 | 功能描述:DC/DC 開關控制器 3 PHASE CONTROLLER RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| L6711_06 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:3 Phase controller with dynamic VID and selectable DACs |
| L6711TR | 功能描述:DC/DC 開關控制器 3 PHASE CONTROLLER RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| L6712 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:TWO-PHASE INTERLEAVED DC/DC CONTROLLER |
| L6712_05 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:TWO-PHASE INTERLEAVED DC/DC CONTROLLER |
發布緊急采購，3分鐘左右您將得到回復。